2021-2026 Nissan Qashqai SUV Pre-driving checks and adjustments -> Remote keyless entry system (if so equipped) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Pre-driving checks and adjustments -> Remote keyless entry system (if so equipped) for Your Nissan Qashqai SUV Third Generation (2021-2026)

REMOTE KEYLESS ENTRY SYSTEM  
(if so equipped)  
It is possible to lock/unlock all doors  
(including the liftgate), and activate the  
panic alarm by using the key fob from  
outside the vehicle.  
fob while on an airplane. Make sure  
the buttons are not operated unin-  
tentionally when the unit is stored  
during a flight.  
Before locking the doors, make sure the  
key is not left in the vehicle.  
The key fob can operate at a distance of  
approximately 33 ft (10 m) from the  
vehicle. (The effective distance depends  
upon the conditions around the vehicle.)  
As many as 4 key fobs can be used with  
one vehicle. For information concerning  
the purchase and use of additional key  
fobs, contact a NISSAN dealer.  
CAUTION  
The following conditions or occur-  
rences will damage the key fob.  
.
Do not allow the key fob to  
become wet.  
.
.
Do not drop the key fob.  
SPA2801  
The key fob will not function:  
Do not strike the key fob sharply  
CHILD SAFETY REAR DOOR LOCK  
.
When the key fob is not within the  
against another object.  
Child safety rear door locks help prevent  
the rear doors from being opened acci-  
dentally, especially when small children  
are in the vehicle.  
operational range.  
.
If the outside temperature is be-  
low 14°F (-10°C) degrees, the bat-  
tery of key fob may not function  
properly.  
Do not place the key fob for an  
extended period in an area where  
temperatures exceed 140°F  
(60°C).  
.
When the doors are open or not  
closed securely.  
.
.
When the key is in the ignition switch.  
When the battery is discharged.  
When the levers are in the lock position  
, the rear doors can be opened only  
from the outside.  
.
WARNING  
To disengage, move the levers to the  
unlock position  
.
If a key fob is lost or stolen, NISSAN  
recommends erasing the ID code of  
that key fob. This will prevent the key  
fob from unauthorized use to unlock  
the vehicle. For information regard-  
ing the erasing procedure, it is re-  
commended that you visit a NISSAN  
The remote keyless entry key fob  
transmits radio waves when the  
buttons are pushed. The FAA advises  
that the radio waves may affect  
aircraft navigation and communica-  
tion systems. Do not operate the key  
3-8 Pre-driving checks and adjustments  
CarManuals2.com  
dealer.  
For information regarding the replace-  
ment of a battery, see “Key fob battery  
replacement” (P.8-21).  
JVP0308X  
JVP0213X  
Type A (if so equipped)  
Jackknife type key release button  
LOCK button  
Type B (if so equipped)  
LOCK button  
UNLOCK button  
PANIC button  
UNLOCK button  
PANIC button  
Battery indicator light  
Battery indicator light  
HOW TO USE REMOTE KEYLESS  
ENTRY SYSTEM  
Welcome light and farewell light  
function  
When you lock or unlock the doors or the  
liftgate, the daytime running lights, park-  
ing lights and the tail lights will illuminate  
for a period of time. The welcome light  
and farewell light function can be dis-  
abled. For information about disabling  
the welcome light and farewell light  
Pre-driving checks and adjustments 3-9  
CarManuals2.com  
.
Any of the buttons on the key fob is  
pushed. (Note: the PANIC button  
must be pushed for more than 1  
second.)  
function, see “Vehicle Settings” (P.2-23).  
Locking doors  
2. Push the UNLOCK  
button again  
within 5 seconds.  
.
All the doors and the liftgate unlock.  
The hazard indicator flashes once if  
all doors are completely closed.  
1. Remove the key from the ignition  
.
switch.  
2. Close all the doors.  
Battery indicator light  
All doors will be locked automatically  
unless one of the following operations is  
performed within 1 minute of pushing the  
The battery indicator light illuminates  
when you push any button. If the light  
does not illuminate, the battery is weak or  
needs replacement. For information re-  
garding replacement of a battery, see  
“Key fob battery replacement” (P.8-21).  
3. Push the LOCK  
button on the key  
fob.  
UNLOCK  
button.  
4. All the doors will lock.  
.
.
Any door or liftgate is opened.  
All of the doors will lock when the  
The ignition switch is placed in the ON  
LOCK  
button is pushed even  
position.  
though a door remains open.  
Setting hazard indicator and horn  
mode  
This vehicle is set in hazard indicator and  
horn mode when you first receive the  
vehicle.  
NOTE:  
5. The hazard indicator flashes twice  
and the horn chirps once.  
The unlocking operation can be chan-  
ged in selective unlock in the Vehicle  
Settings of the vehicle information dis-  
play. For additional information, refer to  
“Vehicle Settings” (P.2-23).  
Using panic alarm  
If you are near your vehicle and feel  
threatened, you may activate the alarm  
to call attention as follows:  
.
.
When the LOCK  
button is pushed  
with all doors locked, the hazard  
indicator flashes twice and the horn  
chirps once as a reminder that the  
doors are already locked.  
In hazard indicator and horn mode, when  
the LOCK  
button is pushed, the  
hazard indicator flashes twice and the  
horn chirps once. When the UNLOCK  
button is pushed, the hazard indicator  
flashes once.  
Operate the door handles to confirm  
that the doors have been securely  
locked.  
1. Push the PANIC  
button on the key  
If the horn chirp is not necessary, you can  
switch to hazard indicator only mode by  
following the switching procedure.  
Unlocking doors  
fob for more than 0.5 seconds.  
1. Push the UNLOCK  
button on the  
2. The theft warning alarm and head-  
key fob.  
lights will stay on for a period of time.  
In hazard indicator only mode, when the  
.
The driver’s door unlocks.  
The hazard indicator flashes once if  
all doors are completely closed.  
LOCK  
button is pushed, the hazard  
.
3. The panic alarm stops when:  
indicator flashes twice. When the UNLOCK  
button is pushed, neither the hazard  
indicator nor the horn operates.  
.
It has run for a period of time.  
3-10 Pre-driving checks and adjustments  
CarManuals2.com  
Mode (Pushing the  
button)  
or  
Switching procedure:  
DOOR UNLOCK  
DOOR LOCK  
To switch the hazard indicator and horn  
HAZARD - once  
HAZARD - twice  
operation, push the LOCK  
and UN-  
Hazard indicator and horn mode  
Hazard indicator mode  
HORN - none  
HORN - once  
LOCK  
buttons on the key fob simul-  
HAZARD - none  
HAZARD - twice  
taneously for more than 2 seconds.  
.
.
When the hazard indicator mode is  
set, the hazard indicator flashes 3  
times.  
When the hazard indicator and horn  
mode is set, the hazard indicator  
flashes once and the horn chirps once.  
The horn operation can also be turned on  
or off in the vehicle information display.  
See “Vehicle Settings” (P.2-23).  
Pre-driving checks and adjustments 3-11  
CarManuals2.com  

Related Topics

Popular Owner Manuals