2000-2006 Nissan X Trail SUV Pre-driving checks and adjustments -> BATTERY REPLACEMENT User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Pre-driving checks and adjustments -> BATTERY REPLACEMENT for Your Nissan X Trail SUV First Generation (2000-2006)

2. Push the UNLOCK button on the keyfob
again within 5 seconds.
쐌 All doors unlock
쐌 The hazard indicator flashes once if all doors
are completely closed.
If the following operation is not carried out
within 5 minutes after pressing the
UNLOCK button, all doors will be locked
automatically.
쐌 any door is opened.
쐌 the ignition key is turned to the ON
position
The interior light can be turned off without
waiting for 30 seconds by turning the ignition
switch to the ON position or by locking the
doors with the keyfob.
Using the panic alarm
If you are near your vehicle and feel threatened,
you may activate the alarm to call attention as
follows:
1. Push the PANIC button on the keyfob for
longer than 0.5 seconds.
2. The theft warning alarm and headlights will
stay on for 30 seconds.
3. The panic alarm stops when:
쐌 It has run for 30 seconds, or
쐌 The LOCK or the UNLOCK button is
pressed, or
쐌 The PANIC button is pushed on the keyfob
for more than 0.5 seconds.
BATTERY REPLACEMENT
Replace the battery as follows:
1. Open the lid using a suitable tool.
2. Replace the battery with a new one.
SPA1374A
3-6 Pre-driving checks and adjustments
墌 04.6.10/T30-J/V5.0 墍
Recommended battery: CR2025 or equiva-
lent
Make sure that the ⊕ side faces the
bottom case.
3. Close the lid securely.
4. Push the keyfob button two or three times to
check its operation.
See your NISSAN dealer if you need any assis-
tance for replacement.
If the battery is removed for any reason
other than replacement, perform the step 4
above.
쐌 Be careful not to touch a circuit board
and a battery terminal.
쐌 An improperly disposed battery can
harm the environment. Always confirm
local regulations for battery disposal.
쐌 The keyfob is water-resistant; however,
if it does get wet, immediately wipe
completely dry.
쐌 When changing batteries, do not let
dust or oil get on the keyfob.
FCC Notice:
Changes or modifications not expressly
approved by the manufacturer compliance
could void the user’s authority to operate
the equipment. This device complies with
RSS-210 of Industry Canada and Part 15 of
the FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Pre-driving checks and adjustments 3-7
墌 04.6.10/T30-J/V5.0 墍

Related Topics

Popular Owner Manuals