Get Safety ? Seats, seat belts and supplemental restraint system -> INSTALLATION ON FRONT PASSENGER SEAT Guide for Nissan X Trail SUV First Generation (2000-2006)

INSTALLATION ON FRONT

PASSENGER SEAT

WARNING

쐌 Never install a rear facing child re-

straint in the front passenger seat.

Supplemental air bags inflate with

great force. A rear facing child re-

straint could be struck by the supple-

mental air bag in a crash and could

seriously injure or kill your child.

쐌 NISSAN recommends that child re-

straints be installed in the rear seat.

However, if you must install a front

facing child restraint in the front pas-

senger seat, move the passenger

seat to the rearmost position.

쐌 A child restraint with a top tether

strap should not be used in the front

passenger seat.

쐌 The three-point belt in your vehicle is

equipped with a locking mode retrac-

tor which must be used when install-

ing a child restraint.

쐌 Failure to use the retractor’s locking

mode will result in the child restraint

not being properly secured. The child

restraint could tip over or otherwise

be unsecured and cause injury to the

child in a sudden stop or collision.

SSS0300

1-28 Safety — Seats, seat belts and supplemental restraint system

墌 04.6.10/T30-J/V5.0 墍

Front facing

If you must install a child restraint in the front

seat, follow these steps:

1. Position the child restraint on the front pas-

senger seat. It should be placed in a front

facing direction only. Move the seat to the

rearmost position. Adjust the head restraint to

its highest position. Always follow the child

restraint manufacturer’s instructions. Child

restraints for infants must be used in

the rear facing direction and therefore

must not be used in the front seat.

2. Route the seat belt tongue through the child

restraint and insert it into the buckle until you

hear and feel the latch engage. Be sure to

follow the child restraint manufacturer’s in-

structions for belt routing.

3. Pull on the shoulder belt until all of the belt is

fully extended. At this time, the belt retractor

is in the automatic locking mode (child re-

straint mode). It reverts back to emergency

locking mode when the belt is fully retracted.

SSS0301 SSS0055 SSS0113

Safety — Seats, seat belts and supplemental restraint system 1-29

墌 04.6.10/T30-J/V5.0 墍

4. Allow the belt to retract. Pull up on the belt to

remove any slack in the belt.

5. Before placing the child in the child restraint,

use force to tilt the child restraint from side to

side, and tug it forward to make sure that it is

securely held in place. It should not move

more than 25 mm (1 inch).

6. Check that the retractor is in the automatic

locking mode by trying to pull more belt out of

the retractor. If you cannot pull any more belt

webbing out of the retractor, the belt is in the

automatic locking mode.

7. Check to make sure that the child restraint is

properly secured prior to each use. If the lap

belt is not locked, repeat steps 3 through 6.

After the child restraint is removed and the seat

belt is allowed to wind back into the retractor,

the automatic locking mode (child restraint

mode) is canceled; the seat belt only locks

during a sudden stop or impact.

SSS0056 SSS0302

1-30 Safety — Seats, seat belts and supplemental restraint system

墌 04.6.10/T30-J/V5.0 墍

Safety ? Seats, seat belts and supplemental restraint system -> INSTALLATION ON FRONT PASSENGER SEAT for Your Nissan X Trail SUV First Generation (2000-2006)

Related Topics

Popular Owner Manuals

Latest Owner Manuals