2005-2009 Peugeot 1007 4 Door Visibility -> Lights Stalk User Manual

MY CAR USER MANUAL

Visibility -> Lights Stalk for Your Peugeot 1007 4 Door First Generation (2005-2009)

5
Front fog lamps and rear fog  
lamp  
Rotate the ring B or C forwards to  
switch on and backwards to switch  
off. The status is displayed by the in-  
dicator light on the instrument panel.  
Vehicles fitted with a rear fog  
lamp (ring B)  
Dipped/Main beam change  
Pull the stalk fully towards you.  
LIGHTS STALK  
Rear fog lamp  
Front and rear lights  
This can only operate with the dipped  
and main beam headlamps.  
Selection is by turning ring A.  
Lights on  
With the ignition off, a buzzer sounds  
when the driver’s door is opened, if  
you have left your lights on.  
If the dipped headlamps remain  
on, with the ignition off, they will be  
switched off automatically after thirty  
minutes maximum to prevent dis-  
charging of the battery.  
Vehicles fitted with front fog  
lamps and a rear fog lamp (ring C)  
Lights off  
Front fog lamps (1st rotation  
of the ring forwards)  
Automatic switching on  
of lights.  
These operate with the side lights  
and dipped headlamps.  
Side lights  
Dipped/main beam  
headlamps  
86  
5
Notes:  
Direction indicators (flashers)  
When the main beam headlamps are  
switched on, the front fog lamps are  
switched off.  
When the lights are switched off au-  
tomatically, with the engine running,  
the front fog lamps and the side lights  
will remain on (turn the ring back-  
wards to switch the fog lamps off).  
Left: downwards.  
Right: upwards.  
Follow me home lighting  
Leaving the dipped headlamps on  
temporarily, after switching off the ig-  
nition, facilitates the driver’s exit from  
the vehicle when the light is poor.  
Front fog lamps and rear  
fog lamp (2nd rotation of  
the ring forwards)  
Note: to switch off the rear fog lamp  
and the front fog lamps, turn the ring  
backwards twice in succession.  
Switching on  
With the ignition off, "flash" the  
headlamps.  
A second "headlamp flash"  
switches the function off.  
Switching off  
The follow me home lighting is  
switched off automatically following  
locking of the doors, after a specified  
time.  
When the lights are switched  
off automatically or when  
the dipped headlamps are  
switched off manually, with  
the engine running, the fog  
lamps and the side lights will  
remain on.  
In good or rainy weather, both day  
and night, the front fog lamps and  
the rear fog lamp are dazzling and  
are prohibited.  
Do not forget to switch them off when  
they are no longer needed.  
87  
5
In foggy weather or in  
snow, the brightness  
sensor can detect suffi-  
cient light, the lights will  
not come on automati-  
cally.  
Operating fault  
Automatic switching on of  
lights  
If the brightness sensor does not  
function correctly, the lights come on  
accompanied by the service warning  
light, an audible signal and a mes-  
sage on the multifunction display.  
The side lights and dipped beam  
headlamps switch on automatically if  
the light is poor and when the wind-  
screen wipers operate continuously.  
They switch off when the light be-  
comes bright enough or the wind-  
screen wipers are switched off.  
Do not cover the brightness sen-  
sor, coupled with the rain sensor,  
located in the centre of the wind-  
screen behind the interior mirror.  
It is used for automatic switching  
on of the lights.  
Contact a PEUGEOT dealer.  
Do not cover the brightness  
sensor, coupled with the rain  
sensor, located in the centre  
of the windscreen behind  
the interior mirror; the as-  
sociated functions would no  
longer be controlled.  
Activation  
Turn the lighting control to the  
"AUTO" position.  
Coupling with the Follow Me  
Home lighting  
The association with the automatic  
lighting function provides the follow  
me home lighting with the following  
additional options:  
Disarming  
Turn the lighting control to a position  
other than "AUTO".  
Daytime lights*  
-
selection of maintaining of the  
lighting for a duration of 15, 30  
or 60 seconds in the vehicle pa-  
rameters of the multifunction dis-  
play configuration menu (except  
in the case of the monochrome  
display A for which the duration  
is pre-set),  
On vehicles which are equipped with  
daytime lights, the dipped headlamps  
come on when the vehicle is started.  
Operating fault  
If the brightness sensor does not  
function correctly, the lights come on  
accompanied by the service warning  
light, an audible signal and a mes-  
sage on the multifunction display.  
This warning light comes on  
on the instrument panel.  
-
automatic activation of the fol-  
low me home lighting when the  
automatic lighting function is in  
operation.  
The instruments and controls (instru-  
ment panel, multifunction display,  
air conditioning control panel, ...)  
are only lit on switching to the auto-  
matic switching on of the lights mode  
or when the lights are switched on  
manually.  
Consult a PEUGEOT dealer.  
* According to country.  
88  
5
In foggy weather or in  
snow, the brightness  
sensor can detect suffi-  
cient light, the lights will  
not come on automati-  
cally.  
Operating fault  
Automatic switching on of  
lights  
If the brightness sensor does not  
function correctly, the lights come on  
accompanied by the service warning  
light, an audible signal and a mes-  
sage on the multifunction display.  
The side lights and dipped beam  
headlamps switch on automatically if  
the light is poor and when the wind-  
screen wipers operate continuously.  
They switch off when the light be-  
comes bright enough or the wind-  
screen wipers are switched off.  
Do not cover the brightness sen-  
sor, coupled with the rain sensor,  
located in the centre of the wind-  
screen behind the interior mirror.  
It is used for automatic switching  
on of the lights.  
Contact a PEUGEOT dealer.  
Do not cover the brightness  
sensor, coupled with the rain  
sensor, located in the centre  
of the windscreen behind  
the interior mirror; the as-  
sociated functions would no  
longer be controlled.  
Activation  
Turn the lighting control to the  
"AUTO" position.  
Coupling with the Follow Me  
Home lighting  
The association with the automatic  
lighting function provides the follow  
me home lighting with the following  
additional options:  
Disarming  
Turn the lighting control to a position  
other than "AUTO".  
Daytime lights*  
-
selection of maintaining of the  
lighting for a duration of 15, 30  
or 60 seconds in the vehicle pa-  
rameters of the multifunction dis-  
play configuration menu (except  
in the case of the monochrome  
display A for which the duration  
is pre-set),  
On vehicles which are equipped with  
daytime lights, the dipped headlamps  
come on when the vehicle is started.  
Operating fault  
If the brightness sensor does not  
function correctly, the lights come on  
accompanied by the service warning  
light, an audible signal and a mes-  
sage on the multifunction display.  
This warning light comes on  
on the instrument panel.  
-
automatic activation of the fol-  
low me home lighting when the  
automatic lighting function is in  
operation.  
The instruments and controls (instru-  
ment panel, multifunction display,  
air conditioning control panel, ...)  
are only lit on switching to the auto-  
matic switching on of the lights mode  
or when the lights are switched on  
manually.  
Consult a PEUGEOT dealer.  
* According to country.  
88  

Related Topics

Visibility

Headlamp Adjustment
Windscreen Wiper Stalk
Courtesy Light