Get Accesses Guide for Peugeot 107 4 Door 2005-2014

ACCESSES

4

Spotting the vehicle

KEYS/REMOTE CONTROL

To spot your vehicle, if you have

locked it, in a car park:

press button A, the direction indi-

The set of keys or remote

controls, supplied with your

vehicle, enable you to ob-

tain a maximum of three new

keys.

cators come on brieﬂy.

If all of the keys in your possession

are lost, a major operation will have

to be carried out on your vehicle.

Contact a PEUGEOT dealer.

Remote control

This carries out the vehicle locking-

unlocking and locating functions at a

distance.

Locking

Press button A to lock the vehicle

from a distance. This is conﬁrmed by

brief lighting of the direction indica-

tors.

Keys

Unlocking

Press button B to unlock the vehicle.

This is conﬁrmed by two successive

ﬂashes of the direction indicators.

The keys allow you to switch on the

ignition and operate the locks on the

front doors, the boot, the fuel tank

cap, the steering lock and the pas-

senger air bag disarming switch.

Central locking and unlocking

Note: after locking, if you no-

tice that a door is not closed

properly, close it then lock

the vehicle again.

From the driver’s door, the keys al-

low you to lock and unlock the doors

and boot simultaneously.

45

ACCESSES

4

Driving with the doors locked

may make access to the pas-

senger compartment by the

emergency services more

difﬁcult in an emergency.

Reprogramming the remote

control

Following replacement of the remote

control battery or in the event of a re-

mote control malfunction, it may be

necessary to reprogramme the sys-

tem.

Switch off the ignition.

Switch the ignition on again.

Press one of the remote control

buttons immediately for a few sec-

onds.

As a safety measure (with children

on board), remove the key from the

ignition when leaving the vehicle,

even for a short time.

Do not make any modiﬁcations to the

electronic immobiliser system.

The high frequency remote control is

a sensitive system; do not operate it

in your pockets as there is a risk that

it may unlock the vehicle without you

being aware of this.

Avoid pressing the buttons of your

remote control out of range of your

vehicle, you risk rendering it inopera-

tive. It would then have to be repro-

grammed.

Switch off the ignition and remove

the key from the ignition lock.

The remote control is now working

again.

If the malfunction persists, contact a

PEUGEOT dealer.

Changing the remote control

battery

To change the battery, remove the

screw then unclip the housing using

a coin inserted at the ring.

Battery CR 2016/3 volts.

If the remote control does not work

after the battery has been changed,

reprogramme it.

ELECTRONIC ENGINE

IMMOBILISER

This locks the engine control sys-

tem as soon as the ignition has been

switched off and therefore prevents

starting of the vehicle by anyone who

does not have the key.

Do not discard the remote

control batteries, they contain

metals which are harmful to

the environment.

The ignition key has an electronic

chip which has a special code. When

the ignition is switched on, the code

must be recognised for starting to be

possible.

Take them to a PEUGEOT dealership,

or to any other approved collection

point.

In the event of a malfunction, your

vehicle will not start.

Contact a PEUGEOT dealer.

46

ACCESSES

4

Driving with the doors locked

may make access to the pas-

senger compartment by the

emergency services more

difﬁcult in an emergency.

Reprogramming the remote

control

Following replacement of the remote

control battery or in the event of a re-

mote control malfunction, it may be

necessary to reprogramme the sys-

tem.

Switch off the ignition.

Switch the ignition on again.

Press one of the remote control

buttons immediately for a few sec-

onds.

As a safety measure (with children

on board), remove the key from the

ignition when leaving the vehicle,

even for a short time.

Do not make any modiﬁcations to the

electronic immobiliser system.

The high frequency remote control is

a sensitive system; do not operate it

in your pockets as there is a risk that

it may unlock the vehicle without you

being aware of this.

Avoid pressing the buttons of your

remote control out of range of your

vehicle, you risk rendering it inopera-

tive. It would then have to be repro-

grammed.

Switch off the ignition and remove

the key from the ignition lock.

The remote control is now working

again.

If the malfunction persists, contact a

PEUGEOT dealer.

Changing the remote control

battery

To change the battery, remove the

screw then unclip the housing using

a coin inserted at the ring.

Battery CR 2016/3 volts.

If the remote control does not work

after the battery has been changed,

reprogramme it.

ELECTRONIC ENGINE

IMMOBILISER

This locks the engine control sys-

tem as soon as the ignition has been

switched off and therefore prevents

starting of the vehicle by anyone who

does not have the key.

Do not discard the remote

control batteries, they contain

metals which are harmful to

the environment.

The ignition key has an electronic

chip which has a special code. When

the ignition is switched on, the code

must be recognised for starting to be

possible.

Take them to a PEUGEOT dealership,

or to any other approved collection

point.

In the event of a malfunction, your

vehicle will not start.

Contact a PEUGEOT dealer.

46

ACCESSES

4

Simultaneous central locking/

unlocking of the doors and boot.

To lock/unlock the vehicle, press/pull

button A on the driver’s door.

For the other doors, carry out the

same operation as for normal lock-

ing/unlocking.

Driver’s door open

DOORS

ELECTRIC WINDOWS

The driver and front passenger each

have an electric window.

After the ignition has been switched

on, press or pull control 1. The win-

dow stops when you release the con-

trol.

If the driver’s door is open,

the courtesy light remains

on if the button is in this po-

sition.

Locking/unlocking a door

from the inside

Normal locking/unlocking: the

doors lock/unlock independently.

To lock/unlock a door, press/pull but-

ton A.

Note: operating the handle does not

unlock the door, pull button A to un-

lock.

Always remove the key from

the ignition when leaving

the vehicle, even for a short

time.

The driver must ensure that the front

passenger uses his electric window

correctly.

Be aware of children when operating

the windows.

47

ACCESSES

4

REAR WINDOWS (5-door)

LOCKING/UNLOCKING THE

BOOT USING THE KEY*

LOCKING/UNLOCKING THE

BOOT USING THE REMOTE

CONTROL*

To partially open the rear windows,

pull the lever then push the window.

To close the window, pull then press

the lever to lock the window.

To open, operate the lock B using the

key and raise the tailgate.

The boot is locked/unlocked using

the buttons on the remote control.

Then, to open, press button C and

raise the tailgate.

Note: the boot can be locked/un-

locked using control A on the driver’s

door.

CHILD LOCK

This prevents the opening of each of

the rear doors from the inside.

Push control 1 towards the outside of

the vehicle.

Check the status of this safe-

ty device before switching on

the ignition.

* According to version.

48

ACCESSES

4

REAR WINDOWS (5-door)

LOCKING/UNLOCKING THE

BOOT USING THE KEY*

LOCKING/UNLOCKING THE

BOOT USING THE REMOTE

CONTROL*

To partially open the rear windows,

pull the lever then push the window.

To close the window, pull then press

the lever to lock the window.

To open, operate the lock B using the

key and raise the tailgate.

The boot is locked/unlocked using

the buttons on the remote control.

Then, to open, press button C and

raise the tailgate.

Note: the boot can be locked/un-

locked using control A on the driver’s

door.

CHILD LOCK

This prevents the opening of each of

the rear doors from the inside.

Push control 1 towards the outside of

the vehicle.

Check the status of this safe-

ty device before switching on

the ignition.

* According to version.

48

ACCESSES

4

2. Spare wheel/Additional

storage compartments

Located under the carpet and a plas-

tic cover, this contains the tools for

wheel changing and towing.

BOOT

In order to obtain additional

space, the spare wheel can

be removed temporarily

(boot tray available as an ac-

cessory).

1. Rear shelf

To remove the shelf:

- unhook the shelf from its ﬁxing A,

- pull upwards on each side to de-

tach it from its ﬁxings,

There are two shelf storage options:

- either behind the rear seats,

- or ﬂat in the boot.

- raise then tilt the shelf slightly to re-

move it.

49

ACCESSES

4

FILLING THE FUEL TANK

Low fuel level

When the fuel tank minimum

level is reached, the last

block ﬂashes, accompanied

by an audible signal.

You have approximately 5 litres re-

maining.

Incertaindrivingconditionsanddepend-

ing on the engine, the distance which

can be travelled with the fuel remaining

may be less than 30 miles (50 km).

When the frequency of the ﬂashing

increases, you have approximately

3 litres remaining.

Open the fuel ﬁller ﬂap.

Unscrew the cap and hook it onto

the clip located on the inside of

the ﬂap.

A label afﬁxed on the inside of the

ﬂap reminds you which type of fuel

to use.

When you ﬁll the fuel tank, do not

continue after the 3rd cut-off of the

pump. This could cause malfunc-

tions.

Insert the key, turn it slightly to the

left then return to the right. The

key returns to its initial position

and the cap is unlocked.

Note: if you run out of fuel,

the emission control system

warning light may come on

on the instrument panel. It will

switch off automatically after the en-

gine has been started a few times.

The capacity of the fuel tank is ap-

proximately 35 litres.

After ﬁlling the fuel tank, screw the

cap back on fully to the right until it

clicks and close the ﬂap.

The fuel tank must be ﬁlled

with the engine switched

off.

Remove the key.

50

Accesses for Your Peugeot 107 4 Door 2005-2014

Related Topics

Popular Owner Manuals

Latest Owner Manuals