ACCESSES
4
Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
difficult in an emergency.
Reprogramming the remote
control
Following replacement of the remote
control battery or in the event of a re-
mote control malfunction, it may be
necessary to reprogramme the sys-
tem.
Switch off the ignition.
Switch the ignition on again.
Press one of the remote control
buttons immediately for a few sec-
onds.
As a safety measure (with children
on board), remove the key from the
ignition when leaving the vehicle,
even for a short time.
Do not make any modifications to the
electronic immobiliser system.
The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of your
vehicle, you risk rendering it inopera-
tive. It would then have to be repro-
grammed.
Switch off the ignition and remove
the key from the ignition lock.
The remote control is now working
again.
If the malfunction persists, contact a
PEUGEOT dealer.
Changing the remote control
battery
To change the battery, remove the
screw then unclip the housing using
a coin inserted at the ring.
Battery CR 2016/3 volts.
If the remote control does not work
after the battery has been changed,
reprogramme it.
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control sys-
tem as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
Do not discard the remote
control batteries, they contain
metals which are harmful to
the environment.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
Take them to a PEUGEOT dealership,
or to any other approved collection
point.
In the event of a malfunction, your
vehicle will not start.
Contact a PEUGEOT dealer.
46
English 