Advertisement

Advertisement

Checks -> Checking the Levels for Your Peugeot 107 4 Door 2005-2014

CHECKS  
8
CHECKING THE LEVELS  
Changing the brake fluid  
Windscreen wash level  
The brake fluid must be changed at  
the intervals stated, according to the  
manufacturer’s servicing schedule.  
Use fluids recommended by the  
manufacturer, which fulfil DOT4  
standards.  
For best quality cleaning and for your  
safety, we would advise that you  
use products recommended by your  
manufacturer.  
Oil level  
Check the level regularly and top up  
between changes. The maximum  
consumption is 0.5 l per 600 miles  
(1 000 km).  
Contact a PEUGEOT dealer.  
Check the level with the vehicle level,  
engine cold, using the dipstick.  
Cooling system  
Used oil  
Avoid prolonged contact of used oil  
with the skin.  
Brake fluid is harmful to health and  
very corrosive.  
Dipstick  
Only use the fluid recom-  
mended by the manufac-  
turer.  
There are two marks  
on the dipstick:  
A = maximum  
If you fill past this mark,  
contact a PEUGEOT  
dealer.  
B = minimum  
Never allow the level to  
fall below this mark.  
Otherwise, you risk seriously  
damaging your engine.  
Do not dispose of used oil,  
brake fluid or coolant into  
drains or into the ground.  
When the engine is warm, the tem-  
perature of the coolant is controlled  
by the engine fan. As this fan can op-  
erate with the ignition key removed  
and because the cooling system is  
pressurised, wait for at least one hour  
after the engine has stopped before  
carrying out any work.  
Empty the used oil into the  
containers provided for this purpose  
in the PEUGEOT network.  
To maintain the reliability of  
engines and emission control  
systems, the use of additives  
in engine oil is prohibited.  
Slacken the cap by 1/4 of a  
turn to release the pressure  
to prevent any risk of scald-  
ing. When the pressure has  
dropped, remove the cap and top up  
the level.  
Oil change  
According to the information given in  
the servicing booklet.  
Viscosity selection  
In all cases, the oil selected must  
meet the manufacturer’s require-  
ments.  
66