Practical information
1. Windscreen washing fluid reservoir.
Closing
2. Engine coolant reservoir.
3. Air filter.
F Take the stay out of the support notch.
F Clip the stay in its housing.
F Lower the bonnet and release it near the
end of its travel.
F Pull on the bonnet to check that it is fully
latched.
4. Brake fluid reservoir.
5. Battery.
6. Fusebox.
7. Engine oil dipstick.
8. Engine oil filler cap.
9. Remote earth point.
F Push the exterior safety catch to the left and
raise the bonnet.
F Unclip the bonnet stay from its housing.
F Fix the stay in the notch to hold the bonnet
open.
To avoid damaging the electrical units,
never use a high-pressure jet wash in the
engine compartment.
To access the brake fluid reservoir and/
or the fusebox, unclip the plastic cover,
located at the base of the windscreen, by
pressing the two tabs.
Engine compartment
Do not open the bonnet under very windy
conditions.
When the engine is hot, handle the
exterior safety catch and the stay with
care (risk of burns).
Checking levels
Check all of these levels regularly, in line with
the manufacturer's service schedule. Top them
up if necessary, unless otherwise indicated.
If a level drops significantly, have the
corresponding system checked by a PEUGEOT
dealer or a qualified workshop.
The cooling fan may start after
switching off the engine: take care
with articles and clothing that might be
caught by the fan blades.
7
Because of the presence of electrical
equipment under the bonnet, it is
recommended that exposure to water
(rain, washing, etc.) be limited.
The liquid must comply with the
manufacturer's recommendations and with
the vehicle's engine.
99
English 
