Lighting and visibility
Maintenance
Clean the windscreen regularly,
– The main beam headlamps
come on automatically. These
particularly the area in front of the camera.
The internal surface of the windscreen can
also become misted around the camera.
In humid and cold weather, demist the
windscreen regularly.
indicator lamps light up on the instrument panel.
If the ambient light level is sufficient and/or the
traffic conditions do not allow the main beam
headlamps to be lit:
– The dipped beam headlamps
Do not allow snow to accumulate on the
bonnet or roof of the vehicle as this could
obstruct the camera.
remain lit. These indicator lamps
light up on the instrument panel.
The function is deactivated if the foglamps are
switched on.
When the foglamps are switched off, the function
is automatically reactivated.
This system is a driving aid.
The driver remains responsible for
the vehicle's lighting, its correct use in the
prevailing light, visibility and traffic conditions,
and for compliance with driving and vehicle
regulations.
Automatic headlamp
dipping
This indicator lamp goes out when the
function is deactivated.
For more information, refer to the
General recommendations for
automatic lighting systems.
Pause
If the situation requires a change of headlamp
beam, the driver can take over at any time.
► Switch the headlamps manually between
dipped and main beam to pause the function.
If the "AUTO" and "Dipped beam" indicator
lamps were on, the system changes to main
beam.
The system becomes operational when
the vehicle exceeds 16 mph (25 km/h).
When the speed falls below 9 mph (15 km/h),
the function is no longer operational.
With the ring of the lighting control stalk in the
"AUTO" position and the function activated on
the touch screen, this system automatically
switches between dipped and main beam
headlamps, according to lighting and traffic
conditions, using a camera located at the top of
the windscreen.
Activation/Deactivation
If the "AUTO" and "Main beam" indicator lamps
were on, the system changes to dipped beam.
► To reactivate the function, once again switch
the headlamps manually between dipped and
main beam.
It is set via the Driving / Vehicle touch
screen menu.
The state of the system stays in the memory
when switching off the ignition.
Operation
Malfunction
If the ambient light level is very low and traffic
If a malfunction occurs with the system or
the camera, this warning lamp lights up
conditions permit:
60
English