Get AUDIO EQUIPMENT -> RADIO Guide for Peugeot 206 4 Door 1998-2013

AUDIO EQUIPMENT 31

-

Adjusting the front/rear sound

distribution (Fader)

Selecting radio mode

Press button R.

RADIO

Notes on radio reception

When "FAD" is displayed, press

button I or J.

Button I increases the volume in the

Your car radio is subject to phenom-

ena which do not affect domestic ra-

dio sets. Both AM (MW/LW) and FM

reception are subject to various forms

of interference. This is no relection on

the quality of the equipment, but is due

to the nature of the signals and the

way in which they are transmitted.

On MW/LW, interference may be no-

ticed when passing under high voltage

power lines or bridges, or in tunnels.

On FM, interference may be the re-

sult of increasing distance from the

transmitter, delection of the signals by

obstacles (mountains, hills, buildings,

etc.), or of being in an area which is

not covered by a transmitter.

front.

Button J increases the volume in the

rear.

Selecting a waveband

Adjusting the right/left sound

distribution (Balance)

When "BAL" is displayed, press

button I or J.

Button I increases the volume on the

right-hand side.

Button J increases the volume on the

left-hand side.

Briely press button

R to select the FM1,

FM2 FMast and AM

wavebands.

Automatic volume correction

This function enables the volume to

be automatically adjusted depending

on the level of noise produced by the

speed of the vehicle.

Press buttons I or J to switch the

function on or off.

AUDIO EQUIPMENT 31

-

Adjusting the front/rear sound

distribution (Fader)

Selecting radio mode

Press button R.

RADIO

Notes on radio reception

When "FAD" is displayed, press

button I or J.

Button I increases the volume in the

Your car radio is subject to phenom-

ena which do not affect domestic ra-

dio sets. Both AM (MW/LW) and FM

reception are subject to various forms

of interference. This is no relection on

the quality of the equipment, but is due

to the nature of the signals and the

way in which they are transmitted.

On MW/LW, interference may be no-

ticed when passing under high voltage

power lines or bridges, or in tunnels.

On FM, interference may be the re-

sult of increasing distance from the

transmitter, delection of the signals by

obstacles (mountains, hills, buildings,

etc.), or of being in an area which is

not covered by a transmitter.

front.

Button J increases the volume in the

rear.

Selecting a waveband

Adjusting the right/left sound

distribution (Balance)

When "BAL" is displayed, press

button I or J.

Button I increases the volume on the

right-hand side.

Button J increases the volume on the

left-hand side.

Briely press button

R to select the FM1,

FM2 FMast and AM

wavebands.

Automatic volume correction

This function enables the volume to

be automatically adjusted depending

on the level of noise produced by the

speed of the vehicle.

Press buttons I or J to switch the

function on or off.

32 - AUDIO EQUIPMENT

Automatic station search

Manual station search

Press the "MAN" button.

Automatic storing of FM stations

in the memory (autostore)

Briely press button L or N to in-

crease or decrease the frequency

displayed.

Press and hold button

R for more than two

seconds.

By continuing to press the button in

the direction selected, you will obtain

continuous scrolling of the frequency.

The scrolling stops as soon as the

button is released.

Pressing the "MAN" button again

returns you to automatic station

search.

Briely press button L or N to search

for the station immediately above or

below. By continuing to press the

button in the direction selected, you

will obtain continuous scrolling of the

frequency.

The scrolling stops at the irst sta-

tion found as soon as the button is

released.

Your radio automatically stores the

6 stations with the strongest signal in

FM. These stations are stored in the

FMast waveband.

If it is not possible to ind 6 stations,

the remaining memories are empty.

If the TA trafic programme is select-

ed, only stations broadcasting this

type of programme are selected.

Searching for a station occurs irst in

"LO" sensitivity (selection of the most

powerful transmitters) during scan-

ning of the waveband, then in "DX"

sensitivity (selection of the weakest

and most distant transmitters).

Manual storing of stations in the

memory

Select the station required.

Press one of the buttons "1" to "6"

for more than two seconds.

Recalling stations stored in the

memory

For each waveband, briely press

buttons "1" to "6" to recall the cor-

responding station.

To make a direct search in "DX" sen-

sitivity, press button L or N twice.

The sound stops then becomes audi-

ble again, conirming that the station

has been stored in the memory.

AUDIO EQUIPMENT 33

-

Trafic information programme

(TA)

Regional following mode

RDS

When they are part of a network,

certain stations broadcast regional

programmes in the various areas

they serve. With regional following

mode you can keep listening to the

same programme.

Press the "RDS" button for more

than two seconds to switch the func-

tion on or off.

Using the RDS (Radio Data

System) function on FM

Radio Data System allows you to

continue listening to the same sta-

tion, whatever frequency it is using

for the region you are going through.

Press the "TA" button

to switch the function

on or off.

The multifunction dis-

play will show:

-

"TA" if the function is selected,

"(TA)" if the function is selected

but not available.

Brielypressthe"RDS"

button to switch the

function on or off.

The multifunction dis-

play will show:

Any trafic information lash will be

given priority, whatever source you

are listening to (radio, CD or CD

changer).

If you wish to interrupt a message,

press the "TA" button; this switches

the function off.

Note: the volume of trafic informa-

tion is independent of the volume

of normal radio listening. You can

adjust it using the volume button.

The setting will be stored and will

be used when the next messages

are broadcast.

-

"RDS" if the function is selected.

"(RDS)" if the function is

selected but not available.

RDS station following

The display indicates the name of the

station selected. The radio is contin-

ually searching for the station which

has the best reception and which is

transmitting the same programme.

34 - AUDIO EQUIPMENT

Search by type of programme

(PTY)

Thisallowsyoutolistentostationsbroad-

casting a speciic type of programme

(news, culture, sport, rock, etc.).

To search for a PTY programme:

EON system

This connects stations which are part

of the same network. It enables the

broadcast of trafic information or a

PTY programme, by a station that is

part of the same network as the sta-

tion to which you are listening.

This service is available when you

have selected the TA trafic informa-

tion programme or the PTY function.

With FM selected, press

the "TA" button for

two seconds to switch

this function on or off.

-

select the PTY function,

-

briely press button L or N to

scroll down the list of the various

types of programmes offered.

-

when the programme of your

choice is displayed, keep button

L or N pressed for two seconds

to carry out an automatic search

(after an automatic search the

PTY function is switched off).

In PTY mode the different types of

programmecanbestoredinthemem-

ory. To do this, press the preselection

buttons "1" to "6" for two seconds.

Briely press the corresponding but-

ton to recall the type of programme

stored in the memory.

AUDIO EQUIPMENT -> RADIO for Your Peugeot 206 4 Door 1998-2013

Related Topics

AUDIO EQUIPMENT

Popular Owner Manuals

Latest Owner Manuals