Get INSTRUMENTS AND CONTROLS Guide for Peugeot 206 4 Door 1998-2013

INSTRUMENTS and CONTROLS 17

-

INSTRUMENT DIALS: PETROL - DIESEL MANUAL GEARBOX

1. Seat belt not fastened warning

light

9. Total distance recorder, service,

engine oil level and speed

limiter/cruise control indicator

10. Right hand direction indicator

11. Emission control system warning light

18. Total distance recorder button

19. Central (STOP) warning light

20. Speedometer

2. Passenger air bag disarmed

warning light

21. Coolant temperature indicator

22. Rev counter

12. Main beam headlamps indicator

light

3. Air bags warning light

23. Lighting rheostat button

24. Fuel level indicator

4. Front fog lamps indicator light

13. Handbrake, low brake luid

level and electronic brake force

distribution warning light

14. Dipped beam headlamps

indicator light

15. Battery charge warning light

16. Engine oil pressure and

temperature warning light

17. Engine oil temperature indicator

5. Anti-lock braking system (ABS)

warning light

25. Low fuel level warning light

26. Dynamic stability control

(ESP/ASR) warning light

6. Rear fog lamp indicator light

7. Diesel pre-heat warning light

8. Left hand direction indicator

27. Speed limiter/cruise control

indicator light

18 - INSTRUMENTS and CONTROLS

INSTRUMENT DIALS: PETROL AUTOMATIC GEARBOX

1. Seat belt not fastened warning

light

9. Right hand direction indicator

10. Emission control system warning light

19. Central (STOP) warning light

20. Speedometer

11. Main beam headlamps indicator

light

12. Handbrake, low brake luid

level and electronic brake force

distribution warning light

13. Dipped beam headlamps

indicator light

14. Battery charge warning light

15. Engine oil pressure and

temperature warning light

2. Passenger air bag disarmed

warning light

21. Coolant temperature indicator

22. Rev counter

3. Air bags warning light

4. Front fog lamps indicator light

23. Lighting rheostat button

24. Fuel level indicator

5. Anti-lock braking system (ABS)

warning light

25. Low fuel level warning light

6. Rear fog lamp indicator light

7. Left hand direction indicator

26. Dynamic stability control

(ESP/ASR) warning light

16. Operating programmes

17. Gear indicator

18. Total distance recorder button

8. Total distance recorder, service,

engine oil level and speed

limiter/cruise control indicator

27. Speed limiter/cruise control

indicator light

INSTRUMENTS and CONTROLS 19

-

WARNING LIGHTS

A permanently lit warning light or one lashing, with the engine running, indicates an operating fault of the unit

concerned.

The illumination of certain warning lights may be accompanied by an audible signal and a message on the multi-

function display. Do not ignore this warning: consult a PEUGEOT dealer as soon as possible.

If the central STOP warning light comes on when you are driving, stop your vehicle immediately, where it is safe to

do so.

Engine oil pressure

and temperature

warning light

Handbrake, low

Central (STOP)

warning light

brake fluid level and

Electronic Brake Force

Distribution fault

Linked to the warning lights:

-

Linked to the central (STOP) warning

light.

You must stop.

warning light

engine oil pressure and

temperature,

Linked to the central (STOP) warning

light.

This indicates one of the following:

This warning light indicates one of

the following:

-

handbrake,

low brake luid level,

electronic brake force distribution

fault.

-

insuficient oil pressure,

-

that the handbrake is applied or

not fully released,

a lack of oil in the lubrication

circuit. Top up the level.

an oil temperature which

-

an excessive drop in brake luid

level (if the warning light remains

on even when the handbrake is

released).

a fault in the Electronic Brake

Force Distribution, if lit at the

same time as the ABS warning

light.

Linked to the coolant temperature in-

dicator.

You must stop if the light lashes

with the engine running.

Consult a PEUGEOT dealer.

-

is too high. The warning

light is accompanied by an

audible signal. To lower the oil

temperature, reduce your speed.

-

Consult a PEUGEOT dealer.

You must stop.

Consult a PEUGEOT dealer.

20 - INSTRUMENTS and CONTROLS

Anti-lock braking

system (ABS) warning

light

Battery charge warning

light

Diesel engine pre-heat

warning light

This indicates one of the fol-

lowing:

faulty operation of the charging

circuit,

slack battery or starter terminals,

a cut or slack alternator belt,

an alternator failure.

Wait until the warning light

goes out before starting the engine.

If the temperature is high enough,

the warning light comes on for less

than one second. You can start the

engine without waiting.

This comes on for a few seconds each

-

time the ignition is switched on.

If the warning light remains on or co-

mes on above 8 mph (12 km/h), this

indicates an ABS malfunction.

However, the vehicle retains conven-

tional servo-assisted braking.

Illumination of this warning light, ac-

companied by an audible signal and

a message on the multifunction dis-

play, indicates a fault in the ABS sys-

tem.

-

Consult a PEUGEOT dealer.

Low fuel level

warning light

When this light irst co-

mes on, you have enough fuel to drive

at least 30 miles (50 km). The tank ca-

pacity is approximately 50 litres.

Consult a PEUGEOT dealer.

Emission control

system warning light

(according to model)

Dynamic stability

control system (ESP/

ASR) warning light

This comes on for a few seconds each

time the ignition is switched on.

If it comes on with the engine run-

ning, this indicates incorrect operation

of the injection, ignition or emission

control system.

Speed limiter/cruise

control indicator light

This comes on for a few seconds each

time the ignition is switched on.

With the engine running and when

the vehicle is moving, it comes on if

the system is activated.

It lights permanently accompanied by

a message on the multifunction dis-

play when the system is disarmed.

If the warning light remains lit with

the engine running and when the ve-

hicle is moving, consult a PEUGEOT

dealer.

This comes on when the

speed limiter or cruise control

is activated.

If the warning light lashes, there

is a risk of damage to the catalytic

converter on petrol engines.

Consult a PEUGEOT dealer.

INSTRUMENTS and CONTROLS 21

-

Seat belt not fastened

warning light

When the ignition is switched

on, this indicator light comes on if the

driver has not fastened his seat belt.

Above 12 mph (20 km/h), the war-

ning light lashes for about two minu-

tes accompanied by an increasingly

audible signal and a message on the

multifunction display. This warning

light remains lit until the driver's seat

belt is fastened.

Coolant temperature indicator

Engine oil temperature

indicator

-

needle in zone (A), the

temperature is correct,

Passenger air bag

disarmed warning light

With the engine running, this indica-

tes the oil temperature:

-

needle in zone (B), the

temperature is too high. The

central STOP warning light

lashes.

-

needle in zone (C), the

temperature is correct,

Illumination of this warning light accom-

panied by a message on the multifunc-

tion display, indicates that the passenger

air bag is disarmed.

The warning light remains lit as long as

the passenger air bag is disarmed.

Always consult a PEUGEOT dealer if

the warning light lashes.

-

needle in zone (D), the

temperature is too high.

To lower the oil temperature,

reduce your speed.

You must stop.

Consult a PEUGEOT dealer.

Air bags warning light

The light will come on for a

few seconds when the igni-

tion is switched on.

With the engine running, illumination

of this warning light, accompanied by

an audible signal and a message on

the multifunction display, indicates a

fault in the air bags.

Consult a PEUGEOT dealer.

INSTRUMENTS and CONTROLS 21

-

Seat belt not fastened

warning light

When the ignition is switched

on, this indicator light comes on if the

driver has not fastened his seat belt.

Above 12 mph (20 km/h), the war-

ning light lashes for about two minu-

tes accompanied by an increasingly

audible signal and a message on the

multifunction display. This warning

light remains lit until the driver's seat

belt is fastened.

Coolant temperature indicator

Engine oil temperature

indicator

-

needle in zone (A), the

temperature is correct,

Passenger air bag

disarmed warning light

With the engine running, this indica-

tes the oil temperature:

-

needle in zone (B), the

temperature is too high. The

central STOP warning light

lashes.

-

needle in zone (C), the

temperature is correct,

Illumination of this warning light accom-

panied by a message on the multifunc-

tion display, indicates that the passenger

air bag is disarmed.

The warning light remains lit as long as

the passenger air bag is disarmed.

Always consult a PEUGEOT dealer if

the warning light lashes.

-

needle in zone (D), the

temperature is too high.

To lower the oil temperature,

reduce your speed.

You must stop.

Consult a PEUGEOT dealer.

Air bags warning light

The light will come on for a

few seconds when the igni-

tion is switched on.

With the engine running, illumination

of this warning light, accompanied by

an audible signal and a message on

the multifunction display, indicates a

fault in the air bags.

Consult a PEUGEOT dealer.

22 - INSTRUMENTS and CONTROLS

Display screen showing the

positions of the automatic

gearbox selector lever

Automatic gearbox indicator

lights

"SPORT" Indicator light

This comes on when the "SPORT"

programme is selected.

Park

Reverse

Neutral

Drive

"SNOW" Indicator light

This comes on when the "SNOW"

programme is selected.

Operating abnormality

If the Sport and Snow indicator lights

lash, accompanied by an audible

signal and a message on the multi-

function display, consult a PEUGEOT

dealer.

Manual mode:

1st gear engaged

2nd gear engaged

3rd gear engaged

4th gear engaged

INSTRUMENTS and CONTROLS 23

-

5 seconds after the ignition is

switched on, the total distance re-

corder resumes normal operation and

the display shows the total or trip dis-

tances.

The service is overdue.

INSTRUMENT PANEL

DISPLAY

After switching on the ignition, three

functions are shown in succession:

Each time the ignition is switched on

and for 5 seconds, the spanner and

the excess distance lash.

Example: the service is overdue by

300 miles/km. The service should be

carried out very shortly.

-

service indicator,

engine oil level indicator,

total distance recorder, it remains

displayed for 30 seconds after

the ignition is switched off.

When the ignition is switched on and

for 5 seconds, the display shows:

It also displays the speed limiter/

cruise control information, when one

of these systems is active (see cor-

responding section).

The distance remaining before

the next service is less than

500 miles (1.000 km).

Example: 400 miles (900 km) remain

before the next service is due.

When switching on the ignition and

for 5 seconds, the display shows:

Service indicator

This is a visual reminder of when the

next service is due. This service is to

be carried out according to the manu-

facturer’s servicing schedule.

5 seconds after the ignition is

switched on, the total distance re-

corder resumes normal operation and

the spanner remains lit. The display

shows the total or trip distances.

Operation

As soon as the ignition is switched

on and for 5 seconds, the spanner

symbolising service operations is lit.

The trip recorder display shows the

distance remaining (in round igures)

before the next service.

Example: 400 miles (900 km) re-

main before the next service is due.

When switching on the ignition and

for 5 seconds, the display shows:

5 seconds after the ignition is

switched on, the total distance re-

corder resumes normal operation and

the display shows the total or trip dis-

tances.

This indicates that a service should

be carried out shortly. The display

shows the total or trip distances.

24 - INSTRUMENTS and CONTROLS

Resetting the service indicator

Engine oil level indicator

When the ignition is switched on,

the engine oil level is indicated for

approximately 10 seconds, after the

service information.

Oil level gauge fault

Flashing of the six segments indi-

cates a malfunction of the oil level

gauge.

There is a risk of damage to the en-

gine.

Consult a PEUGEOT dealer.

Your PEUGEOT dealer carries out

this operation after each service.

The reset procedure is as follows:

Surplus of oil

Flashing of the six squares and dis-

playing of "max" indicate a surplus of

oil which could damage the engine.

If the surplus of oil is conirmed by

a check using the dipstick, contact a

PEUGEOT dealer without delay.

-

Switch off the ignition.

Press and hold button 1.

Switch on the ignition.

The display begins a 10 second

countdown

Keep button 1 pressed for

10 seconds.

-

The display shows [= 0] and the

spanner disappears.

Lack of oil

Flashing of the six segments and dis-

playing of "min" indicate a lack of oil

which could damage the engine.

If the lack of oil is conirmed by a

check using the dipstick, it is essen-

tial that the level is topped up.

The level read on the gauge will

only be correct if the vehicle is

on level ground and the engine

has been off for more than 15 mi-

nutes.

INSTRUMENTS and CONTROLS 25

-

TOTAL DISTANCE

RECORDER

LIGHTING RHEOSTAT

HAZARD WARNING

LIGHTS

Press the button, the direction indica-

tors lash.

They can operate with the ignition off.

Automatic lighting of hazard

warning lights

Pressing button 1 alternates be-

With the lights on, press the button

to vary the intensity of the lighting of

the instruments and controls. When

the lighting reaches the minimum (or

maximum) setting, release the button

then press it again to increase (or re-

duce) the brightness.

When braking in an emergency, de-

pending on the deceleration, the hazard

warning lights come on automatically.

They switch off automatically the irst

time you accelerate.

It is also possible to switch them off

by pressing the button.

tween:

-

the total distance display,

the trip distance display,

the speed limiter or cruise

control display when one of

these systems is selected with

the engine running.

As soon as the lighting is of the re-

quired brightness, release the button.

To reset the trip recorder to zero,

when it is displayed press button 1

until zeros appear.

INSTRUMENTS AND CONTROLS for Your Peugeot 206 4 Door 1998-2013

Related Topics

Popular Owner Manuals

Latest Owner Manuals