Advertisement

Advertisement

PRACTICAL INFORMATION -> BATTERY for Your Peugeot 206 4 Door 1998-2013

104 - PRACTICAL INFORMATION  
BATTERY  
To charge the battery using a  
battery charger:  
ECONOMY MODE FUNCTION  
After the engine has stopped, certain  
functions (windscreen wiper, elec-  
tric windows, courtesy lights, audio  
equipment, etc.) can only be used for  
a combined duration of approximately  
thirty minutes, to prevent discharging  
the battery.  
Once the thirty minutes are over, a  
switching to economy mode mes-  
sage appears on the multi-function  
display and the active functions are  
put on standby.  
These functions are reactivated au-  
tomatically next time the vehicle is  
driven.  
In order to resume the use of these  
functions immediately, the engine  
must be started and left to run for a  
few minutes.  
-
Disconnect the battery,  
-
Follow the instructions for use  
given by the battery charger  
manufacturer,  
-
Reconnect starting with the  
negative (-) terminal,  
-
Check that the terminals and  
connectors are clean. If they are  
covered with sulphate (white or  
greenish deposit), disconnect  
them and clean them.  
-
Wait for 2 minutes  
after switching off  
the ignition before  
disconnecting the  
battery.  
To start the vehicle from another  
battery:  
-
-
-
Connect the red cable to the  
positive (+) terminals of the  
two batteries,  
Connect one end of the green  
or black cable to the negative (-)  
terminal of the slave battery,  
Connect the other end of the  
green or black cable to an  
earth point on the broken down  
vehicle, as far as possible from  
the battery (for example, right-  
hand engine mounting),  
The time available to you will then be  
double the duration for which the en-  
gine is left running. However, this pe-  
riod will always be between ive and  
thirty minutes.  
-
-
Never disconnect a terminal  
when the engine is running.  
Never charge a battery  
without irst disconnecting the  
terminals.  
Close the windows and the  
roof before disconnecting the  
battery.  
After every reconnection of  
the battery, switch on the  
ignition and wait 1 minute  
before starting to allow the  
electronic systems to be  
initialised. If slight dificulties  
are experienced after this,  
please consult a PEUGEOT  
dealer.  
-
-
-
Operate the starter, let the  
engine run,  
Wait for the engine to return to  
-
idle, then disconnect the cables.  
A lat battery prevents the  
engine from starting.  
It is advisable to disconnect the  
battery if the vehicle is not to be  
used for a period of more than  
one month.