2006-2014 Peugeot 207 4 Door DRIVING -> Parking brake & Manual gearbox User Manual

MY CAR USER MANUAL

DRIVING -> Parking brake & Manual gearbox for Your Peugeot 207 4 Door First Generation (2006-2014)

2
COMFORT  
Rear parcel shelf (Saloon)  
Hooks  
To remove the shelf:  
) unhook the two cords,  
) raise the shelf slightly, then remove it.  
The hooks can be used to secure shop-  
ping bags.  
You have two storage options:  
-
-
either upright behind the front seats,  
or upright behind the rear seats.  
i When changing a wheel  
The hooks facilitate access to the  
spare wheel by holding up the  
boot carpet by its cord.  
64  
COMFORT  
2
BOOT FITTINGS (SW)  
1. Rear parcel shelf  
(see details on following page)  
2. 12 V accessories socket  
(see details on following page)  
3. Hooks  
(see details on previous page)  
4. Retaining straps  
5. Stowing rings  
6. High load retaining net  
(see details on following page)  
7. Storage box  
8. Storage net  
9. Storage box  
(refer to the section "Practical infor-  
mation - § Changing a wheel")  
65  
2
COMFORT  
Rear parcel shelf (SW)  
12 V accessory socket (SW)  
This consists of three sections which  
can be folded back on each other.  
To store it, fold it on itself and place it  
vertically at the back of the boot.  
To fold it from the boot:  
) take hold of the rear parcel shelf by  
its strap A,  
) fold it concertina-style to the rear  
) In order to connect a 12 V accesso-  
ry (max power: 120 Watts), remove  
the cap and connect the appropriate  
adaptor.  
seats.  
To unfold it from the boot:  
)
Turn the key to the ignition on position.  
) take hold of the rear parel shelf by  
its strap A,  
) unfold it to the boot pillars.  
To gain access from the rear seats:  
) raise the front section of the rear  
parcel shelf using the handle B.  
iMaximum loads  
7.5 kg, rear parcel shelf unfolded  
with high load retaining net at row 2.  
66  
COMFORT  
2
High load retaining net (SW)  
Hooked onto the upper fixings and onto  
the ISOFIX rings or the lugs, this per-  
mits use of the entire loading volume up  
to the roof:  
-
-
behind the rear seats (row 2),  
behind the front seats (row 1) when  
the rear seats are folded.  
When positioning the net, check  
that the strap loops are visible from  
the boot; this will make slackening  
or tightening easier.  
i
To use it in row 1:  
) open the covers of the upper fixings 1, ) fold or remove the load space cover,  
) unroll the high load retaining net, ) open the covers of the upper fixings 2,  
To use it in row 2:  
) position one of the ends of the net's ) unroll the high load retaining net,  
metal bar in the corresponding  
upper fixing 1, then do the same  
) position one of the ends of the net's  
metal bar in the corresponding upper  
with the other end,  
) slacken the straps fully,  
) fix the snap hook of each of the straps ) attach the hook of each of the net's  
fixing 2, then do the same with the  
other end,  
on the corresponding lug 3, located  
under the bench seat cushion,  
straps in the corresponding ISOFIX  
ring 4,  
) fold the rear seats,  
) tighten the straps without raising the  
bench seat,  
) check that the net is hooked and  
tightened correctly.  
) tighten the straps,  
check that the net is hooked and  
tightened correctly.  
67  
3
ACCESS  
REMOTE CONTROL KEY  
Unlocking the vehicle  
Unfolding the key  
) First press button A to unfold the  
Locking the vehicle  
Normal locking using the remote  
control  
System which permits central unlocking  
or locking of the vehicle using the lock  
or remotely. It also locates and starts  
the vehicle, as well as providing protec-  
tion against theft.  
key.  
) Press the closed padlock  
to lock the vehicle.  
) Press the closed padlock  
for more than two seconds  
to close the windows auto-  
matically in addition to lock-  
ing (with sequential electric  
windows).  
Unlocking using the remote control  
) Press the open padlock to  
unlock the vehicle.  
Unlocking using the key Normal locking using the key  
) Turn the key to the left in the driver's ) Turn the key to the right in the driv-  
door lock to unlock the vehicle.  
er's door lock to lock the vehicle.  
Locking is confirmed by fixed lighting of  
the direction indicators for approximate-  
ly two seconds.  
According to version, the door mirrors  
fold at the same time.  
Unlocking is confirmed by rapid flashing  
of the direction indicators for approxi-  
mately two seconds.  
According to version, the door mirrors  
unfold at the same time.  
If one of the doors or the boot is  
still open, the central locking does  
not take place.  
i
68  
ACCESS  
3
Anti-theft protection  
Electronic engine immobiliser  
The key contains an electronic chip  
which has a special code. When the  
ignition is switched on, this code must  
be recognised in order for starting to be  
possible.  
This electronic engine immobiliser locks  
the engine management system a few  
minutes after the ignition is switched off  
and prevents starting of the engine by  
anyone who does not have the key.  
In the event of a fault, you are  
informed by illumination of this  
warning lamp, an audible signal  
and a message in the screen.  
Folding the key  
) First press button A to fold the key.  
In this case, your vehicle does not start;  
contact a PEUGEOT dealer as soon as  
possible.  
The vehicle will relock automati-  
cally after thirty seconds unless a  
door is opened. This system pre-  
vents unintentional unlocking.  
i
The folding and unfolding of the  
door mirrors can be deactivated  
by a PEUGEOT dealer or a quali-  
fied workshop.  
69  
3
ACCESS  
Changing the battery  
Starting the vehicle  
Locating your vehicle  
To locate your vehicle, if you have  
locked it, in a car park:  
) press the closed padlock, the cour-  
tesy lights come on and the direction  
indicators flash for a few seconds.  
) Insert the key in the ignition switch.  
The system recognises the starting  
code.  
) Turn the key fully towards the dash-  
board to position 3 (Starting).  
) When the engine starts, release the  
key.  
Remote control problem  
Following disconnection of the vehicle  
battery, replacement of the remote con-  
trol battery or in the event of a remote  
control malfunction, you can no longer  
unlock, lock or locate your vehicle.  
) First of all, use the key in the lock to  
unlock or lock your vehicle.  
) Then, reinitialise the remote control.  
If the problem persists, contact a  
PEUGEOT dealer as soon as possible.  
Battery ref.: CR1620/3 volts.  
If the battery is flat, you are in-  
formed by illumination of this  
warning lamp, an audible signal  
and a message in the multifunc-  
tion screen.  
Switching the vehicle off  
) Unclip the casing using a coin at the  
notch.  
) Slide the flat battery out of its location.  
) Slide the new battery into its loca-  
tion observing the original direction.  
) Clip the casing.  
) Reinitialise the remote control.  
) Immobilise the vehicle.  
Reinitialisation  
) Switch off the ignition.  
) Turn the key to position 2 (Ignition  
on).  
) Press the closed padlock immedi-  
ately for a few seconds.  
) Switch off the ignition and remove  
the key from the ignition switch.  
The remote control is fully operational  
again.  
) Turn the key fully towards you to po-  
sition 1 (Stop).  
) Remove the key from the ignition  
switch.  
i Key in ignition  
If the key has been left in the igni-  
tion, an audible signal is heard on  
opening the driver's door.  
70  

Related Topics

DRIVING

Automatic gearbox
Speed limiter
Cruise control
Parking sensors