Access
When the vehicle is unlocked using the remote
control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.
To take effect, this deactivation must be carried
out after each time the ignition is switched off.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the system.
Have it checked by a PEUGEOT dealer or
a qualified workshop.
Reactivating the interior
volumetric monitoring
F
Deactivate the exterior perimeter
monitoring by unlocking the vehicle using
the remote control.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric monitoring
to avoid unwanted triggering of the alarm in
certain cases such as:
F
Reactivate the alarm system normally.
Electric windows
Locking the vehicle without
activating the alarm
-
-
-
-
-
-
leaving a pet in the vehicle,
leaving a window partially open,
washing your vehicle,
changing a wheel,
having your vehicle towed,
transport by ship.
F
Lock or deadlock the vehicle using the
key (integral to the remote control) in the
driver's door lock.
1. Left-hand front.
2. Right-hand front.
3. Right-hand rear.
4. Left-hand rear.
Failure of the remote
control
Deactivating the interior
volumetric monitoring
To deactivate the monitoring functions:
F
Unlock the vehicle using the key (integral to
the remote control) in the driver's door lock,
Open the door; this sets off the alarm.
Upon switching on the ignition the alarm
stops. The indicator lamp in the button
goes off.
5. Deactivation of the electric window controls
F
Switch off the ignition and within
located at the rear seats.
ten seconds, press this button
until the indicator lamp is on
fixed.
F
F
Manual operation
F
F
Get out of the vehicle.
Immediately lock the vehicle using the
remote control.
To open or close the window, press or pull the
switch gently, without exceeding the point of
resistance. The window stops as soon as the
switch is released.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
34
English