Get Layout Guide for Peugeot 307 4 Door 2001-2014

The engine must be switched off

when ﬁlling with fuel.

FILLING WITH FUEL

Open the fuel ﬁller ﬂap.

Insert the key then turn it to the

left.

Remove the cap and hang it on

the hook located on the inside of

the ﬂap.

A label afﬁxed to the inside of the fuel

ﬁller ﬂap indicates which type of fuel

to use.

When you ﬁll your tank, do not con-

tinue after the third cut-off of the

pump. This could cause your vehicle

to malfunction.

The capacity of the tank is approxi-

mately 60 litres.

After ﬁlling the tank, lock the cap

and close the fuel ﬁller ﬂap.

Low fuel level

When the minimum

fuel level in the tank is

reached, this warning

light comes on on the

instrument panel.

Operating fault

With the ignition on, if the fuel gauge

needle remains in or returns to the

rest positon (below zero), this in-

dicates a malfunction of the fuel

gauge.

You can still drive approximately

30 miles (50 km).

Contact a PEUGEOT dealer.

70

Dipped/Main beam change

Pull the stalk towards you.

Vehicles ﬁtted with front fog

lamps and a rear fog lamp (ring C)

LIGHTS STALK

Front fog lamps (ﬁrst rota-

tion of the ring forwards)

Lights on buzzer

With the ignition off and the automat-

ic switching on of the lights deactivat-

ed, when the driver’s door is opened,

a buzzer sounds to warn you that you

have left your lights on.

The front fog lamps operate with

the side lights and the dipped head-

lamps.

Front fog lamps and rear fog

lamp

Front and rear fog

lamps (2nd rotation

of the ring forwards).

Note: to switch off

the rear fog lamp

Turn ring B C forwards to switch

on and backwards to switch off.

The status is conﬁrmed by the

indicator light on the instrument

panel.

Front and rear lights (ring A)

Place ring A in the required posi-

tion.

and the front fog lamps, turn the ring

backwards twice in succession.

Vehicles ﬁtted with a rear fog

lamp (ring B)

Lights off

The rear fog lamp will be de-

activated automatically when

towing or when a bicycle car-

rier ﬁtted with a fog lamp is

ﬁtted.

Rear fog lamp

Automatic switching

on of the lights

This operates with the dipped/main

beam headlamps.

Side lights

Note: when the lights are switched off

automatically, the rear fog lamp and

the dipped headlamps will remain on.

Turn the ring backwards to switch off

the rear fog lamp. The dipped head-

lamps will then be switched off.

In good or rainy weather,

both day and night, the front

fog lamps and the rear fog

lamp are dazzling and are

prohibited.

Do not forget to switch them off when

they are no longer needed.

Dipped/main beam

headlamps

71

Direction indicators (ﬂashers)

Manual "Follow-me-home" lighting

Activation

Turn ring A to the "AUTO" position.

When the automatic switching on of

the lights function is deactivated, the

side lights and dipped headlamps re-

main on for the duration selected for the

automatic "follow-me-home" lighting.

The automatic lighting is accompa-

nied by a message on the multifunc-

tion display.

Left: downwards.

Right: upwards.

If the vehicle is not ﬁtted with the

automatic switching on of the lights

function, when you leave your vehicle,

the side lights and dipped headlamps

remain on for thirty seconds.

Note: if you forget to cancel the di-

rection indicator, the volume of the

audible signal will increase, if you

are driving at a speed greater than

50 mph (80 km/h).

Deactivation

Turn ring A to a position other

than "AUTO". Switching off is ac-

companied by a message on the

multifunction display.

Activation:

If the brightness sensor does not

function correctly, the lights come

on accompanied by the service

warning light, an audible signal and

a message on the multifunction dis-

play.

switch off the engine,

"ﬂash" the headlamps,

get out of the vehicle and lock it.

Automatic "Follow me home"

lighting

With the ignition off, when you leave

your vehicle with the automatic

switching on of the lights function

activated, the side lights and dipped

headlamps remain on for the select-

ed duration.

Deactivation:

"ﬂash" the headlamps again,

get out of the vehicle and lock it.

Contact a PEUGEOT dealer.

To deactivate or activate

this function, go to the mul-

tifunction display conﬁgura-

tion menu.

Automatic switching on of the

lights

Side lights and dipped beam head-

lamps switch on automatically if the

light is poor, or during operation of

the windscreen wipers. They switch

off as soon as the light becomes

bright enough or the windscreen wip-

ers stop.

The duration of the timed

period must also be set (15, 30,

60 seconds), via the multifunction

display conﬁguration menu, except

in the case of the monochrome

screen A for which it is pre-set.

Do not cover the brightness

sensor, coupled with the rain

sensor, located in the centre

of the windscreen, behind

the interior mirror. It is used for the

automatic switching on of the lights.

Note: in foggy weather or in snow,

the brightness sensor can detect suf-

ﬁcient light. As a consequence, the

lights will not come on automatically.

Cancelling:

"ﬂash" the headlamps,

get out of the vehicle and lock it.

72

Direction indicators (ﬂashers)

Manual "Follow-me-home" lighting

Activation

Turn ring A to the "AUTO" position.

When the automatic switching on of

the lights function is deactivated, the

side lights and dipped headlamps re-

main on for the duration selected for the

automatic "follow-me-home" lighting.

The automatic lighting is accompa-

nied by a message on the multifunc-

tion display.

Left: downwards.

Right: upwards.

If the vehicle is not ﬁtted with the

automatic switching on of the lights

function, when you leave your vehicle,

the side lights and dipped headlamps

remain on for thirty seconds.

Note: if you forget to cancel the di-

rection indicator, the volume of the

audible signal will increase, if you

are driving at a speed greater than

50 mph (80 km/h).

Deactivation

Turn ring A to a position other

than "AUTO". Switching off is ac-

companied by a message on the

multifunction display.

Activation:

If the brightness sensor does not

function correctly, the lights come

on accompanied by the service

warning light, an audible signal and

a message on the multifunction dis-

play.

switch off the engine,

"ﬂash" the headlamps,

get out of the vehicle and lock it.

Automatic "Follow me home"

lighting

With the ignition off, when you leave

your vehicle with the automatic

switching on of the lights function

activated, the side lights and dipped

headlamps remain on for the select-

ed duration.

Deactivation:

"ﬂash" the headlamps again,

get out of the vehicle and lock it.

Contact a PEUGEOT dealer.

To deactivate or activate

this function, go to the mul-

tifunction display conﬁgura-

tion menu.

Automatic switching on of the

lights

Side lights and dipped beam head-

lamps switch on automatically if the

light is poor, or during operation of

the windscreen wipers. They switch

off as soon as the light becomes

bright enough or the windscreen wip-

ers stop.

The duration of the timed

period must also be set (15, 30,

60 seconds), via the multifunction

display conﬁguration menu, except

in the case of the monochrome

screen A for which it is pre-set.

Do not cover the brightness

sensor, coupled with the rain

sensor, located in the centre

of the windscreen, behind

the interior mirror. It is used for the

automatic switching on of the lights.

Note: in foggy weather or in snow,

the brightness sensor can detect suf-

ﬁcient light. As a consequence, the

lights will not come on automatically.

Cancelling:

"ﬂash" the headlamps,

get out of the vehicle and lock it.

72

Daytime lights*

On vehicles which are equipped with

daytime lights, the dipped headlamps

come on when the vehicle is started.

MANUAL ADJUSTMENT OF

THE HEADLAMPS

AUTOMATIC HEADLAMP

ADJUSTMENT

This warning light comes

on on the instrument panel.

The instruments and controls

(instrument panel, multifunc-

tion display, air conditioning

control panel, ...) are only lit

on switching to the automatic switch-

ing on of the lights mode or when the

lights are switched on manually.

For vehicles ﬁtted with halogen

bulbs, depending on the load in your

vehicle, adjusting the beam of your

headlamps is recommended.

0. 1 or 2 people in the front seats.

3 people.

1. 5 people.

On vehicles with xenon bulbs:

when stationary the system auto-

matically corrects the height of the

beam, whatever the load of the ve-

hicle. The driver is then assured of

having optimum lighting and not

causing a nuisance to other road

2. 5 people + maximum authorised

loads.

3. Driver + maximum authorised

loads.

In cases of malfunction,

the service warning light

comes on on the instrument

panel, accompanied by an

audible signal and a mes-

sage on the multifunction display.

The system places your headlamps

to the low position.

Initial setting is position 0.

Do not touch the xenon bulbs.

Contact a PEUGEOT dealer.

* According to country.

73

Front windscreen wiper with

automatic wipe

Special position of the front

windscreen wiper

WINDSCREEN WIPER STALK

In the minute following switching off

of the ignition, any action on the stalk

positions the wipers in the centre of

the windscreen.

This action enables you to position

the wiper blades for winter parking,

cleaning or replacement (See sec-

tion "Practical information - Chang-

ing a wiper blade").

To park the wipers after this has

been done, switch on the ignition and

operate the stalk.

Front windscreen wiper with

intermittent wipe

2

1

Fast wipe (heavy rain).

Normal wipe

(moderate rain).

Windscreen and headlamp wash

2

Fast wipe

(heavy rain).

Pull the windscreen wiper stalk to-

wards you. The windscreen wash

then the windscreen wipers operate

for a ﬁxed period.

The headlamp wash is also activated,

if the headlamps are on

I

Intermittent wipe.

Off.

AUTO  Automatic or single wipe

1

Normal wipe

(moderate rain).

0

l

0



Intermittent wipe.

Off.

Single wipe

(press downwards).

In the Intermittent position, the wiping

speed is in proportion to the speed of

the vehicle.

In AUTO mode, the wiping speed is

in proportion to the intensity of the

rainfall. The ﬁrst press of the stalk

downwards activates the automatic

wipe.

In the Intermittent position, the

wiping speed is in proportion to the

vehicle speed.

Subsequent presses trigger a single

wipe.

74

Do not cover the rain sensor

located on the windscreen

behind the interior mirror.

Automatic windscreen

wipers

In AUTO mode, the windscreen wip-

ers operate automatically and adapt

their speed to the intensity of the

rainfall

Rear windscreen wiper

When using an automatic car

wash, switch off the ignition.

In winter, it is advisable to wait for the

windscreen to completely clear of ice

before operating the automatic wipe.

Activation

Activation of the function is accom-

panied by a message on the multi-

function display.

Turn ring A to the ﬁrst notch

for intermittent wiping.

When reverse gear is en-

gaged, if the windscreen

wipers are in operation, the

rear wiper starts.

The automatic windscreen

wipers function must be

reactivated if the ignition

has been switched off for

more than one minute, by press-

ing the stalk downwards.

To activate or deactivate

this function, go to the multi-

function display conﬁgura-

tion menu.

Deactivation

Deactivation of the function is

accompanied by a message on the

multifunction display.

The function is deactivated when the

windscreen wipers stalk is moved to

position I 1

In the event of malfunction of the

automatic windscreen wipers, the

windscreen wipers will operate in in-

termittent mode.

Contact a PEUGEOT dealer to have

the system checked.

If there is a signiﬁcant accumulation

of snow or ice and when using a bi-

cycle carrier on the tailgate (estate),

deactivate the automatic rear wiper

by going to the multifunction display

conﬁguration menu.

2

Rear windscreen wash

Turn ring A past the ﬁrst

notch; the windscreen wash

then the windscreen wiper

operate for a ﬁxed period.

75

Do not cover the rain sensor

located on the windscreen

behind the interior mirror.

Automatic windscreen

wipers

In AUTO mode, the windscreen wip-

ers operate automatically and adapt

their speed to the intensity of the

rainfall

Rear windscreen wiper

When using an automatic car

wash, switch off the ignition.

In winter, it is advisable to wait for the

windscreen to completely clear of ice

before operating the automatic wipe.

Activation

Activation of the function is accom-

panied by a message on the multi-

function display.

Turn ring A to the ﬁrst notch

for intermittent wiping.

When reverse gear is en-

gaged, if the windscreen

wipers are in operation, the

rear wiper starts.

The automatic windscreen

wipers function must be

reactivated if the ignition

has been switched off for

more than one minute, by press-

ing the stalk downwards.

To activate or deactivate

this function, go to the multi-

function display conﬁgura-

tion menu.

Deactivation

Deactivation of the function is

accompanied by a message on the

multifunction display.

The function is deactivated when the

windscreen wipers stalk is moved to

position I 1

In the event of malfunction of the

automatic windscreen wipers, the

windscreen wipers will operate in in-

termittent mode.

Contact a PEUGEOT dealer to have

the system checked.

If there is a signiﬁcant accumulation

of snow or ice and when using a bi-

cycle carrier on the tailgate (estate),

deactivate the automatic rear wiper

by going to the multifunction display

conﬁguration menu.

2

Rear windscreen wash

Turn ring A past the ﬁrst

notch; the windscreen wash

then the windscreen wiper

operate for a ﬁxed period.

75

Layout for Your Peugeot 307 4 Door 2001-2014

Related Topics

Popular Owner Manuals

Latest Owner Manuals