Access
Without Keyless Entry and Starting
Battery ref.: CR1620/3 volts.
F Turn the key towards the rear again within
Passenger doors
5 seconds to deadlock the vehicle.
Central locking not
functioning
2
Use these procedures in the following cases:
-
-
central locking fault,
battery disconnected or discharged.
F On the rear doors, check that the child lock
is not on.
In the event of a malfunction with the
central locking system, the battery must
be disconnected to lock the boot and thus
ensure that the vehicle is locked fully.
F Insert the integral key in the latch located
on the edge of the door and turn it an eighth
of a turn to the right for the right-hand side,
and to the left for the left-hand side.
F Close the doors and check from the outside
that the vehicle is locked.
With Keyless Entry and Starting
Battery ref.: CR2032/3 volts.
Driver's door
F Insert the key in the door lock.
F Turn the key towards the front of the vehicle
to unlock it, or towards the rear to lock it.
Changing the battery
If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
If fitted to your vehicle, the alarm is not
activated/deactivated when the vehicle is
locked/unlocked.
F Unclip the cover using a small screwdriver
at the cut-out.
F Remove the cover.
F Remove the discharged battery from its
housing.
Opening a door will trigger the alarm,
which can be stopped by switching the
ignition on.
F Fit the new battery into its housing
observing the polarity.
F Clip the cover onto the casing.
45
English 