Get Practical information -> Checks Guide for Peugeot 308 4 Door Second Genration (2014-2020)

Practical information

When the engine is hot, the temperature of this

fluid is regulated by the fan.

In addition, as the cooling system is pressurised,

wait at least one hour after switching off the

engine before carrying out any work.

To avoid the risk of scalding when you need to

top up in an emergency, place a cloth around

the cap and unscrew the cap by two turns to

allow the pressure to drop.

Once the pressure has dropped, remove the cap

and top up to the required level.

12 V battery

In wintry conditions, it is recommended

that you use an ethyl alcohol or methanol

based fluid.

The battery does not require any maintenance.

However, check regularly that the terminals

are correctly tightened (versions without quick

release terminals) and that the connections

are clean.

Diesel fuel additive level

(Diesel with particle filter)

For more information on the precautions

to take before starting work on the 12 V

battery, refer to the corresponding

section.

A low additive level is indicated by

illumination of this warning lamp,

accompanied by an audible warning

and a message in the instrument

panel screen.

Fluid speciﬁcation

This fluid must conform to the manufacturer's

recommendations.

Versions equipped with Stop & Start are

fitted with a 12 V lead-acid battery of

specific technology and specification.

Its replacement should be carried out

only by a PEUGEOT dealer or a qualified

workshop.

Topping up

The cooling fan may start after

switching off the engine: take care

with articles and clothing that might be

caught by the fan blades.

This additive must be topped up without delay

by a PEUGEOT dealer or a qualified workshop.

Checks

Unless otherwise indicated, check these

components in accordance with the

manufacturer's service schedule and according

to your engine.

Screenwash fluid level

Air filter

Depending on the environment

(e.g. dusty atmosphere) and the

use of the vehicle (e.g. city driving),

replace it twice as often if

necessary.

Top up to the required level when

necessary.

Otherwise, have them checked by a PEUGEOT

dealer or a qualified workshop.

Fluid speciﬁcation

For optimum cleaning and to avoid freezing,

this fluid must not be topped up or replaced

with plain water.

186

Practical information

Passenger compartment filter

Automatic gearbox

As soon as the traffic conditions permit,

regenerate the filter by driving at a speed

of at least 37 mph (60 km/h) until the

warning lamp goes off.

If the warning lamp stays on, this indicates

a low Diesel additive level.

Depending on the environment

(e.g. dusty atmosphere) and the

use of the vehicle (e.g. city driving),

replace it twice as often if

necessary.

The gearbox does not require any

maintenance (no oil change).

For more information on Checking levels,

refer to the corresponding section.

Parking brake

If excessive travel or a loss of

effectiveness of this system is

noticed, the parking brake must

be checked, even between two

services.

A clogged passenger compartment

filter may have an adverse effect on

the performance of the air conditioning

system and generate undesirable odours.

On a new vehicle, the first particle

filter regeneration operations may be

accompanied by a "burning" smell, which

is perfectly normal.

Following prolonged operation of the

vehicle at very low speed or at idle,

you may, in exceptional circumstances,

notice the emission of water vapour at the

exhaust on acceleration. This does not

affect the behaviour of the vehicle or the

environment.

This system must be checked by a PEUGEOT

dealer or a qualified workshop.

Oil filter

Change the oil filter each time the

engine oil is changed.

Brake pads

Brake wear depends on the style

of driving, particularly in the case

of vehicles used in town, over short

distances. It may be necessary to

have the condition of the brakes

checked, even between vehicle

services.

Particle filter (Diesel)

The start of saturation of the particle

filter is signalled by the temporary

illumination of this warning lamp

accompanied by a message warning

of the risk of the filter clogging up.

Manual gearbox

The gearbox does not require any

maintenance (no oil change).

Unless there is a leak in the circuit, a drop in

the brake fluid level indicates that the brake

pads are worn.

187

Practical information

The pressures given on the tyre pressure label

are valid for "cold" tyres. If you have driven for

more than 10 minutes or more than 6 miles

(10 kilometres) at more than 31 mph (50 km/h),

0.3 bar (30 kPa) should be added to the values

given on the label.

Under-inflation increases fuel consumption.

Non-compliant tyre pressure causes premature

wear on tyres and has an adverse effect on the

vehicle's road holding – Risk of an accident!

Driving with worn or damaged tyres reduces

braking efficiency and control of the vehicle's

steering. Regular inspections of the condition

of tyres (tread and sides) and rims are

recommended as well as making sure that

valves are fitted.

Brake disc/drum wear

Only use products recommended by

PEUGEOT or products of equivalent

quality and specification.

In order to optimise the operation of

components as important as those in the

braking system, PEUGEOT selects and

offers very specific products.

After washing the vehicle, dampness, or

in wintry conditions, ice can form on the

brake discs and pads: braking efficiency

may be reduced. Make light brake

applications to dry and defrost the brakes.

For information on checking

brake disc/drum wear, contact a

PEUGEOT dealer or a qualified

workshop.

Electric parking brake

This system does not require any

specific check. However, in the

event of a problem, have the system

checked by a PEUGEOT dealer or a

qualified workshop.

AdBlue^®(BlueHDi

engines)

Using different size wheels and tyres from

those specified can affect the lifetime of tyres,

wheel rotation, ground clearance and the

speedometer reading and have an adverse

effect on road holding.

To respect the environment and ensure

For more information on the Electric

parking brake, refer to the corresponding

section.

compliance with the Euro 6 standard, without

adversely affecting the performance or fuel

consumption of its Diesel engines, PEUGEOT

has taken the decision to equip its vehicles

with a system that associates SCR (Selective

Catalytic Reduction) with a Diesel particle filter

(DPF) for the treatment of exhaust gases.

Fitting different tyres on the front and rear axles

can cause the ESC to mistime.

Wheels and tyres

The pressure must be checked on

all tyres, including the spare wheel,

when the tyres are "cold", at least

once a month and before a long

journey.

SCR system

Using a fluid called AdBlue^®containing urea,

a catalytic converter converts up to 85%

of nitrogen oxides (NOx) into nitrogen and

water, which are harmless to health and the

environment.

188

Download User Manual App

Practical information -> Checks for Your Peugeot 308 4 Door Second Genration (2014-2020)

Related Topics

Practical information

Popular Owner Manuals

Latest Owner Manuals