Get Safety -> ISOFIX mountings and child seats Guide for Peugeot 308 4 Door Second Genration (2014-2020)

Safety

U

Seat suitable for the installation of a

child seat secured using the seat belt

and universally approved "rearward

facing" and/or "forward facing".

(e)

(f)

To install a child seat at the rear, rearward

or forward facing, move the front seat

forward, then straighten the backrest to

allow enough room for the child seat and

the child's legs.

U (R) As for U, with the vehicle seat adjusted

to the highest and fully back position.

A child seat with a support leg must

never be installed on the centre rear

passenger seat.

X

Seat position not suitable for installation

of a child seat for the weight class

indicated.

Remove and stow the head restraint

before installing a child seat with backrest

on a passenger seat.

Refit the head restraint when the child

seat is removed.

(a)

(b)

(c)

(d)

Universal child seat: child seat that can

be installed in all vehicles using the seat

belt.

Group 0: from birth to 10 kg. Infant car

seats and "car cots" cannot be installed

on the front passenger seat.

"ISOFIX" mountings

Your vehicle has been approved in accordance

with the latest ISOFIX regulations.

The seats shown below are fitted with

regulation ISOFIX mountings.

Refer to the current legislation in your

country before installing your child in

this seat.

The mountings comprise three rings for each seat:

Two rings A, located between the vehicle seat

backrest and cushion, indicated by an ISOFIX

marking.

When a "rearward facing" child seat is

installed on the front passenger seat, the

passenger airbag must be deactivated.

Otherwise, the child would risk being

seriously injured or killed if the airbag

were deployed.

These rings are located behind covers

(hatchback) or zips (SW).

To access them:

F Unclip the covers by pulling them

forward then pivot them upward

(hatchback).

When a "forward facing" child seat is

installed on the front passenger seat,

leave the passenger airbag activated.

F Pull the zips up to open them (SW).

102

Safety

Some also have an upper strap which is

attached to ring B.

To secure the child seat to the TOP TETHER:

-

remove and stow the head restraint before

installing the child seat on the vehicle seat

(refit it when the child seat is removed),

pass the child seat upper strap over the top

of the seat backrest, centring it between the

apertures for the head restraint rods,

attach the hook of the upper strap to ring B,

tighten the upper strap.

-

If your vehicle has a standard spare wheel of

the same size as the four wheels, follow the

procedure below:

A ring B, in the boot (indicated by a label),

referred to as TOP TETHER, for securing the

upper strap.

F pass the strap and spring hook over the

boot floor (in the slot),

F raise the boot floor,

F lift out the upper storage box, located

alongside the wheel,

F attach the spring hook to the TOP TETHER

ring,

The TOP TETHER secures the upper strap of

child seats that have them. In case of frontal

impact, this device limits the tilting of the child

seat forward.

The TOP TETHER is located on the boot floor

behind the seat backrest.

The incorrect installation of a child seat in

a vehicle compromises the protection of

the child in the event of an accident.

Strictly observe the fitting instructions

provided with the child seat.

5

F refit the storage box and boot floor.

Do not use the luggage net rings

(hatchback) or stowing rings (SW), located

at the edges of the boot floor.

For information regarding the ISOFIX

child seats which can be installed in your

vehicle, refer to the table showing the

locations for installing ISOFIX child seats.

This ISOFIX mounting system provides fast,

reliable and safe fitting of the child seat in your

vehicle.

The ISOFIX child seats are fitted with two

latches which are easily secured on the two

rings A.

103

Safety

Recommended ISOFIX

child seats

"Baby P2C Midi and its ISOFIX base"

(size categories: D, C, A, B, B1)

RÖMER Duo Plus ISOFIX

(size category: B1)

Group 1: from 9 to 18 kg

Group 1: from 9 to 18kg

Also consult the user guide from the child

seat’s manufacturer to find out how to

install and remove the seat.

"RÖMER Baby-Safe Plus and its ISOFIX

base"

(size category: E)

Is installed only in the "forward facing"

position.

Group 0+: from birth to 13 kg

Installed "rearward facing" using an ISOFIX

base which is attached to rings A.

The base has a height-adjustable support leg

that rests on the vehicle's floor.

This child seat can also be used "forward

facing".

This child seat cannot be secured with a seat

belt.

We recommend that you use the seat in the

"rearward facing" position up to the age of

3 years.

Is attached to the rings A and the upper ring

B, referred to as the TOP TETHER, using an

upper strap.

3 seat shell angles: sitting, reclining and lying

down.

This child seat can also be used on seats

not equipped with ISOFIX mountings. In this

case, it must be secured to the vehicle's seat

using the three-point seat belt. Adjust the

position of the vehicle's front seat so that the

child's feet are not touching the backrest.

Installed "rearward facing" using an ISOFIX

base which is attached to rings A.

The base has a height-adjustable support leg

that rests on the vehicle's floor.

This child seat can also be secured with a

seat belt. In this case, only the shell is used

and attached to the vehicle seat using the

three-point seat belt.

104

Safety

Locations for ISOFIX child seats

In line with European regulations, this table indicates the options for installing ISOFIX child seats on the vehicle seats fitted with ISOFIX mountings.

In the case of universal and semi-universal ISOFIX child seats, the ISOFIX size category, determined by a letter from A to G, is indicated on the child

seat next to the ISOFIX logo.

Weight of the child/indicative age

Under 10 kg

(group 0)

Up to about

6 months old

From 9-18 kg (group 1)

From about 1 to 3 years old

Under 13 kg

(group 0+)

Up to about 1 year old

Type of ISOFIX child seat

ISOFIX size category

Cot

rearward facing

forward facing

5

F

G

C

D

E

C

D

A

B

B1

Front passenger seat

Not ISOFIX

Hatchback

IL-SU

(a+b)

IL-SU

(c)

IL-SU

(a)

IL-SU

(c)

IL-SU

(a)

IUF

IL-SU

Outer rear seats

Centre rear seat

Not ISOFIX

105

Safety

SW

IL-SU

(a+b)

IL-SU

(c)

IL-SU

(a)

IL-SU

(c)

IL-SU

(a)

IUF

IL-SU

Outer rear seats

Centre rear seat

Not ISOFIX

IUF

Seat suitable for installing an Isofix

Universal seat, "Forward facing",

secured using the upper strap.

(a) Move the non height-adjustable front

seat forward 1 notch from the longitudinal

adjustment halfway position. The height-

adjustable seat must be adjusted to its

maximum height.

For more information on ISOFIX

mountings and child seats and the

upper strap in particular, refer to the

corresponding section.

IL-SU Seat suitable for installing an Isofix

Semi-Universal seat which is either:

-

"rearward facing" fitted with an

upper strap or a support leg,

"forward facing" fitted with a

support leg,

a cot fitted with an upper strap or a

support leg.

(b) Installing a cot on an outer seat prevents

the other two rear seats from being used.

Remove and stow the head restraint

before installing a child seat with backrest

on a passenger seat.

Refit the head restraint when the child

seat is removed.

(c) The height-adjustable seat must be

adjusted to its maximum height. Move the

non height-adjustable front seat forward 5

notches from the longitudinal adjustment

halfway position.

106

Download User Manual App

Safety -> ISOFIX mountings and child seats for Your Peugeot 308 4 Door Second Genration (2014-2020)

Related Topics

Safety

Popular Owner Manuals

Latest Owner Manuals