37
MAINTENANCE OF YOUR 406
Direction indicator (WY 5 W)
CHANGING A BULB
1 - Dipped beam headlamps
– Pull the rear section of the trans-
parent cover and release the
assembly.
– Turn the connector a quarter turn
and remove it.
– Change the bulb.
2 - Main beam headlamps
2 bulbs (H7-55 W)
– Press the tab and remove the protective cover corresponding to the faulty bulb.
– Disconnect the connector.
– Press the end of the securing clip to remove it. Change the bulb.
– When fitting, ensure that the direction notches are positioned correctly and that
the securing clip is corrrectly fixed.
– Reconnect the connector.
– Refit the protective cover.
Amber bulbs must be
replaced by bulbs of iden-
tical specification and
colour.
3 - Side lights (W 5 W)
In certain weather conditions (low
temperatures, humidity), the pres-
ence of condensation on the
inside of the headlamp glass is
normal; it disappears a few min-
utes after the lights have been
switched on.
Turn the socket using the lever and remove it. Change the bulb.
4 - Direction indicators (P 21 W)
Turn the bulb holder a quarter turn and remove it. Change the bulb.
Note: only handle H7 bulbs using a dry cloth.
To replace the left-hand bulbs, remove the protective battery cover.
17-02-2003
English 
