Safety -> General safety recommendations for Your Peugeot 408 4 Door Second Generation (2022-2026)

Safety  
Installing electrical accessories  
The fitting of electrical equipment or  
accessories not approved by PEUGEOT may  
cause excessive current consumption and  
faults and failures with the electrical system  
of your vehicle. Contact a PEUGEOT dealer  
for information on the range of approved  
accessories.  
Installation of accessory radio  
communication transmitters  
Before installing a radio communication  
transmitter with an external aerial, you must  
without fail contact a PEUGEOT dealer for  
the specification of transmitters which can  
be fitted (frequency, maximum power, aerial  
position, specific installation requirements), in  
line with the UN ECE Regulation 10.  
General safety  
recommendations  
7
Do not remove the labels attached  
in different places on your vehicle.  
They include safety warnings as well as  
identification information for the vehicle.  
Depending on country regulations, certain  
safety equipment may be mandatory:  
high visibility safety vests, warning triangles,  
breathalysers, spare bulbs, spare fuses, fire  
extinguisher, first aid kit, mud flaps at the rear  
of the vehicle, etc.  
Declarations of conformity for radio  
equipment  
The relevant certificates are  
available on the brand website:  
 
Hazard warning lamps  
As a safety measure, access to the  
diagnostic socket, used for the vehicle's  
electronic systems, is reserved strictly for  
PEUGEOT dealers or qualified workshops,  
equipped with the special tools required (risk  
of malfunctions of the vehicle's electronic  
systems that could cause breakdowns or  
serious accidents). The Manufacturer cannot  
be held responsible if this advice is not  
followed.  
Any modification or adaptation not intended  
or authorised by PEUGEOT or carried out  
without meeting the technical requirements  
defined by the Manufacturer will result in the  
suspension of the commercial warranty.  
Pressing this button causes all the direction  
indicators to flash.  
They can work with the ignition switched off.  
Automatic operation of  
hazard warning lamps  
When braking in an emergency, depending on  
the rate of deceleration, the hazard warning  
lamps come on automatically. They switch off  
automatically when you next accelerate.They  
can be switched off by pressing the button.  
73