Ventilation
Have the additional heating system
checked at least once a year at the
beginning of winter. Maintenance and
repairs should only be carried out by a
PEUGEOT dealer.
Cancelling the programming
Good practice
Press this button briefly to clear
the programmed start time.
To avoid any risk of poisoning or
asphyxiation, the additional heating must
not be used, even for short periods, in
an enclosed space such as a garage or
workshop which is not fitted with an exhaust
gas extraction system.
The screen illumination and the
pre-selection number (e.g. 1) are
switched off.
Use only genuine replacement parts.
Recalling one of the pre-selected
start times
The additional heating is supplied by the
vehicle's fuel tank.
Ensure that the fuel gauge indicator lamp is
not at reserve.
Press this button as many times
as necessary until the number
corresponding to the required
pre-selected start time (e.g. 2)
appears.
Two different types of equipment
Always switch off the additional heating
when filling with fuel to avoid any risk of fire
or explosion.
The additional heating is separate and
programmable. Before you enter the vehicle,
it gradually increases the temperature of the
engine to make starting easier.
After ten seconds, the time is cleared but
remains stored for as long as the number
(e.g. 2) and the screen remain on.
Do not park the vehicle on an inflammable
surface (dry grass, dead leaves, paper…),
there is a risk of fire.
The temperature near the heater must not
exceed 120 °C. A temperature higher than
this (for example in the case of painting in
an oven) could damage the components of
the electronic circuits.
This also facilitates passenger compartment
heating, demisting and defrosting.
Switching off the heating
Press this button.
The additional passenger compartment
heating system supplements the
standard equipment. Its operation may be
independent of the engine.
The heating cycle indicator lamp
and the screen are switched off.
The additional heating system is fitted with
a temperature limiter which cuts off the
combustion in the event of overheating due
to a lack of coolant.
Switching on of the heating may be
programmable.
Top up the coolant, then press the
programme selection control before
switching the heating on again.
English 
