92 - Practical information
Access to the spare wheel and
the jack
The wheel is located outside the ve-
hicle, under the rear loor, supported
by a metal carrier.
- Remove the jack and the wheel-
brace 1, secured in an interior hous-
ing above the rear right wheel.
- Using the wheelbrace 1, slacken
the spare wheel carrier retaining
bolt, located on the inside near the
closing system.
CHANGING A WHEEL
Parking the vehicle
- If possible, park the vehicle on level,
stable and non-slippery ground.
- Apply the handbrake, switch off the
ignition and engage irst or reverse
gear.
Removing a wheel
- Chock the rear of the wheel di-
agonally opposite the wheel to be
changed, using the chock 2.
- Remove the wheel trim using the
wheelbrace 1, by pulling at the
valve passage hole.
- Slacken the wheel bolts.
- Place the jack under one of the four
locating points on the sub-frame A
closest to the wheel to be changed.
Ensure that the entire surface of
the jack base plate is in contact
with the ground.
- Extend the jack, completely un-
screw the bolts and remove the
wheel.
- Lift the carrier to release the hook
rearwards, then lower it.
- Remove the chock 2 located in the
spare wheel.
01-02-2005
English 
