Lighting and visibility
► Unclip the worn wiper blade closest to you
and remove it.
► Install the new wiper blade and clip it to the
arm.
Do not cover the rain/sunshine sensor.
When using an automatic car wash,
switch off the automatic wipers and the
ignition.
Changing a wiper blade
Removing/Refitting at the front
► Repeat the procedure for the other wiper
blade.
► Starting with the wiper blade closest to you,
once again hold each arm by the rigid section,
then guide it carefully onto the windscreen.
In winter, wait until the windscreen is
completely clear of ice before activating the
automatic wipers.
Switching on
Removing/refitting at the rear
► Hold the arm by the rigid section and raise it
as far as possible.
► Clean the rear screen using screenwash
fluid.
► Unclip the worn wiper blade and remove it.
► Install the new wiper blade and clip it to the
arm.
► Carry out these wiper blade replacement
operations from the driver's side.
► Starting with the wiper blade farthest from
you, hold each arm by the rigid section and raise
it as far as possible.
► Give a short downwards push to the control
stalk.
A wiping cycle confirms that the instruction has
been accepted.
► Once again hold the arm by the rigid section,
then guide it carefully onto the rear screen.
This indicator lamp lights up on the
instrument panel, accompanied by
a message.
Depending on version, this indicator lamp
appears on the display or on the instrument
panel, accompanied by a message.
Take care not to hold the arms at the jet
locations.
Do not touch the wiper blades - risk of
irreparable deformation.
Do not release them while moving them. Risk
of damaging the windscreen!
Automatic windscreen
wipers
In AUTO mode, the windscreen wipers operate
automatically and adapt to the intensity of the
rainfall.
Detection is via a rain/brightness sensor, located
at the top centre of the windscreen behind the
rear view mirror.
Switching off
► Clean the windscreen using screenwash
fluid.
► Give the control stalk another brief push
downwards or set the control stalk to another
position (Int, 1 or 2).
This indicator lamp goes off on the
instrument panel, accompanied by
a message.
Do not apply "Rain X" type water-
repellent products.
90
English 
