Lighting and visibility
stuck to the windscreen before operating the
wipers.
Fast wiping (heavy rain)
Headlamp beam height
adjustment
Normal wiping (moderate rain)
After using an automatic car wash, you
may temporarily notice abnormal noises
and poorer wiping performance. You do not
need to replace the wiper blades.
Intermittent wiping (proportional to the
vehicle’s speed)
Switching off
Single wipe (press down and release).
Automatic wiping
Without AUTO wiping
or
To avoid inconvenience to other road users,
the height of the halogen headlamps should be
adjusted according to the load in the vehicle.
Refer to the corresponding section.
0
(Initial setting)
Unladen.
Partial load.
Medium load.
Maximum authorised load.
Windscreen wash
► Pull the wiper control stalk towards you and
hold.
1
2
3
A final wiping cycle is performed when
screenwashing ends.
4 5 6 Not used.
The windscreen wash jets are
incorporated into the tip of each wiper
arm.
Screenwash fluid is sprayed along the length
of the wiper blade. This improves visibility and
reduces screenwash fluid consumption.
With AUTO wiping
Windscreen wipers
Wiper control stalk
Before operating the wipers in wintry
conditions, clear any snow, ice or frost
from the windscreen and around the wiper
arms and blades.
With automatic air conditioning, any
action on the screenwash control results
in temporary closure of the air intake to
protect the passenger compartment from any
odour.
Do not operate the wipers on a dry
windscreen. In extremely hot or cold
weather, check that the wiper blades are not
► To select the wiping speed: raise or lower the
stalk to the desired position.
88
English 
