Get Access -> Back-up control(s) Guide for Peugeot Rifter 4 Door 2003-2017

Access

A few seconds after switching off the ignition,

this system locks the engine control system,

therefore preventing the engine from being

started in the event of a break-in.

Locating your vehicle

Where is the integral key

of the Keyless Entry and

Starting?

This function allows you to identify your vehicle

from a distance, particularly in poor light. Your

vehicle must have been locked for more than

five seconds.

In the event of a fault, you are

informed by illumination of this

warning lamp, an audible signal and

a message in the screen.

F

Press this button.

The vehicle will not start; contact a PEUGEOT

dealer as soon as possible.

This will switch on the courtesy lamps and the

direction indicators will flash for around ten

seconds.

Back-up control(s)

If the battery is flat, attempt to lock/unlock the

vehicle as usual. If this does not work, use the

mechanical systems described below.

Also use these systems to mechanically lock/

unlock the doors in the event of:

Remote operation of lighting

F Pull and hold button 1, to extract the integral

key 2.

A short press on this button allows

you to switch on the lighting from

a distance (lighting the sidelamps,

dipped beam headlamps and number

plate lamps).

A second press on this button before

the end of the timed period cancels

the remote lighting.

Locking of the vehicle

-

central locking system failure,

remote control battery discharged,

remote control fault,

vehicle in an area subject to strong

electromagnetic interference.

F Insert the integral key in the driver's door

lock, then turn it to the rear.

Unlocking of the vehicle

F Insert the integral key in the driver's door

Anti-theft protection

lock, then turn it to the front.

Electronic immobiliser

The remote control contains an electronic chip

which has a special code. When the ignition is

switched on, this code must be recognised in

order for starting to be possible.

42

Access

F Open the door.

Unlocking of one part of the

If your vehicle has an alarm, it will not be

deactivated/activated on unlocking/locking

the vehicle.

Opening a door will trigger the alarm,

which can be stopped by switching the

ignition on.

vehicle (front passenger door/

sliding side door/side-hinged

doors)

F Use the interior opening handle.

or

F With side-hinged doors, insert the integral

key in the (left-hand) door lock, then turn it.

2

To deadlock the vehicle, turn the key again

within five seconds of locking.

Front passenger door

If unlocking using the key in the lock

takes place after locking using the

remote control or the Keyless Entry

and Starting, all of the accesses are

unlocked.

For more information on the Child lock

on a sliding side door or side-hinged

doors, refer to the corresponding section.

Sliding side door

If unlocking using the key in the lock

takes place after locking using the key,

only the doors are unlocked (front doors,

sliding side doors). The side-hinged

doors and the tailgate are not unlocked.

Switching on the ignition unlocks them.

Unlocking of the tailgate

Side-hinged doors

Locking of one part of the vehicle

(front passenger door/sliding

side door/side-hinged doors)

F Remove the cap located on the edge of the

door.

F Insert the integral key into the latch (without

forcing) and then turn the assembly.

F Remove the key and refit the cap.

F Close the door(s) and check from the

outside that the vehicle is locked correctly.

F With a sliding side door or side-hinged

doors, if fitted to your vehicle, check that

the electric child lock is not activated.

F From the interior of the vehicle, introduce

a small screwdriver into hole A of the lock to

unlock the tailgate.

F Move the latch to the left.

43

Access

With Keyless Entry and Starting

Changing the battery

Reinitialising the remote

control

Following replacement of the battery or in

the event of a remote control fault, it may be

necessary to reinitialise the remote control.

If the battery is flat, you will be

informed by lighting of this warning

lamp in the instrument panel, an

audible signal and a message in the

screen.

Battery type: CR 2032/3 volts.

The replacement battery is available from

a PEUGEOT dealer or a qualified workshop.

If the problem persists, contact

a PEUGEOT dealer or a qualified

workshop as soon as possible.

With remote control key

Battery type: CR 1620/3 volts.

With remote control key

F Unclip the cover by inserting a small

screwdriver in the slot.

F Remove the cover.

F Remove the flat battery from its

compartment.

F Fit the new battery into its compartment

observing the original fitting direction.

F Clip the cover onto the casing.

The remote control must be reinitialised after

replacing the battery.

For more information on Reinitialising the

remote control, refer to the corresponding

section.

F Switch off the ignition.

F Turn the key to position 2 (Ignition).

F Immediately press the closed padlock

button for a few seconds.

F Switch off the ignition and remove the key

from the switch.

The remote control is fully operational again.

Do not throw away the remote control

batteries, they contain metals which are

harmful to the environment.

Take them to an approved collection

point.

44

Access

With Keyless Entry and Starting

Lost keys, remote control

Go to a PEUGEOT dealer, taking with you the The Keyless Entry and Starting remote

vehicle's registration certificate, your personal control may not operate if close to certain

Electrical interference

F Place the key in the lock to open your

vehicle.

identification documents and if possible, the

label bearing the key code.

electronic devices: telephone, laptop

computer, strong magnetic fields, etc.

2

The PEUGEOT dealer will be able to retrieve

the key code and the transponder code

required to order a new key.

Anti-theft protection

Do not make any modifications to the

electronic engine immobiliser system; this

could cause malfunctions.

Remote control

The high frequency remote control is

a sensitive system; do not operate it while it

is in your pocket as there is a possibility that

it may unlock the vehicle, without you being

aware of it.

Do not press the buttons of your remote

control out of range and out of sight of your

vehicle. You may stop it from working and the

remote control would have to be reinitialised.

The remote control does not operate when

the key is in the ignition, even when the

ignition is switched off.

Do not forget to turn the steering to engage

the steering lock.

F Place the remote control against the back-

up reader on the steering column and hold it

there until the ignition is switched on.

F With a manual gearbox, place the gear

lever in neutral, then fully depress the clutch

pedal.

When purchasing a second-hand vehicle

Have the key codes memorised by

a PEUGEOT dealer, to ensure that the keys in

your possession are the only ones which can

start the vehicle.

F With an automatic gearbox, select mode P,

then fully depress the brake pedal.

Locking the vehicle

Driving with the doors locked may make

access to the passenger compartment by

the emergency services more difficult in an

emergency.

As a safety precaution (with children on

board), remove the key from the ignition or

take the remote control with you when leaving

the vehicle, even for a short time.

F Switch on the ignition by pressing the

"START/STOP" button.

The remote control is fully operational again.

45

Download User Manual App

Access -> Back-up control(s) for Your Peugeot Rifter 4 Door 2003-2017

Related Topics

Access

Popular Owner Manuals

Latest Owner Manuals