Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

Practical information -> Roof bars/Roof rack for Your Peugeot Rifter 4 Door 2003-2017

Practical information  
Load reduction mode  
System which manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
For more information about the Engine  
technical data and towed loads and  
particularly the maximum load applied  
on the towing device, refer to the  
corresponding section.  
If a telephone call is being made at this  
time, it will be maintained for around  
10 minutes with the Bluetooth hands-free  
system of your audio system.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates  
certain functions, such as air conditioning,  
heated rear screen, etc.  
Exiting the mode  
These functions will be automatically restored  
the next time the vehicle is used.  
In order to restore the use of these functions  
immediately, start the engine and let it run:  
Remove the quickly detachable towball  
when not towing a trailer.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
-
for less than ten minutes, to use the  
equipment for approximately five minutes,  
for more than ten minutes, to use the  
equipment for up to approximately thirty  
minutes.  
Energy economy mode  
-
System which manages the duration of use of  
certain functions to conserve a sufficient level  
of charge in the battery.  
After the engine has stopped, you can  
still use functions such as the audio and  
telematics system, windscreen wipers, dipped  
beam headlamps, courtesy lamps, etc. for  
a maximum combined duration of about forty  
minutes.  
Roof bars/Roof rack  
Let the engine run for the duration specified to  
ensure that the battery charge is sufficient.  
Do not repeatedly and continuously restart the  
engine in order to charge the battery.  
Recommendations  
Distribute the load uniformly, taking care  
to avoid overloading one of the sides.  
Arrange the heaviest part of the load as  
close as possible to the roof.  
Secure the load firmly.  
Drive gently: the vehicle will be more  
susceptible to the effects of side winds  
and its stability may be affected.  
Regularly check the security and tight  
fastening of the roof bars and racks, at  
least before each trip.  
Switching to this mode  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
A message appears in the instrument panel  
screen indicating that the vehicle has switched  
to economy mode and the active functions are  
put on standby.  
Remove the roof bars once they are no  
longer needed.  
184  
Practical information  
Bonnet  
In the event of loading (not exceeding  
40 cm in height) on the roof, do not  
exceed the following loads:  
As a safety measure and to avoid  
damaging the roof, it is essential to use  
the roof bars and racks approved for your  
vehicle.  
Observe the instructions on fitting and use  
contained in the guide supplied with the  
roof bars and racks.  
-
-
-
Transverse bars on longitudinal bars:  
80 kg.  
Two transverse bars bolted to the roof:  
100 kg.  
Three transverse bars bolted to the  
roof: 150 kg.  
Before doing anything under the bonnet,  
deactivate the Stop & Start system to  
avoid the risk of injury related to an  
automatic change to START mode.  
-
-
An aluminium rack: 120 kg.  
A steel rack: 115 kg.  
If the height exceeds 40 cm, adapt the  
speed of the vehicle to the profile of the  
road to avoid damaging the roof bars  
or the roof rack and the fixings on the  
vehicle.  
The location of the interior bonnet release  
lever prevents opening of the bonnet when  
the left-hand front door is shut.  
Be sure to refer to national legislation in  
order to comply with the regulations for  
transporting objects which are longer than  
the vehicle.  
When the engine is hot, handle the  
exterior safety catch and the stay with  
care (risk of burns), using the protected  
area.  
When the bonnet is open, take care not to  
damage the safety catch.  
To fit the transverse roof bars or a roof rack,  
use the fixing points provided for this purpose:  
F Remove the fixing covers installed on the  
vehicle.  
F Put each fixing in place and lock them on  
the roof one by one.  
F Ensure that the roof bars or the roof rack  
are correctly fitted (by shaking them).  
The bars are adaptable for each fixing point.  
Do not open the bonnet under very windy  
conditions.  
7
In the event of loading a 7-seat model (not  
exceeding 40 cm in height) on the roof,  
do not exceed the following loads:  
The cooling fan may start after  
switching off the engine: take care  
with articles and clothing that might be  
caught by the fan blades.  
-
Three transverse bars bolted to the  
roof: 100 kg.  
-
-
An aluminium rack: 70 kg.  
A steel rack: 65 kg.  
185