LP GAS – ELECTRONIC IGNITION OPERATION
1. If the water heater fails to operate because of high water temperature, the heater will go
into a
lockout condition (indicator light “on”). When the water eventually cools,
reset the system by turning the switch to the “off” position for at least 30 seconds, then
turn the switch back “on.”
2. If a lockout condition persists, contact your authorized dealer.
120- VOLT AC ELECTRICAL OPERATION
1. For electrical operation, use the Water Heater switch found on the master control panel
in the galley of the coach.
2. Completely fill the water heater with water and purge the hot-water lines of any trapped
air.
3. Turn the Water Heater switch “on.” NOTE: Turning the power “on” to the water heater
without having previously covered the water-heating element with water may burn out
the element and void the warranty.
4. After a while, check the water heater for proper operation; the water temperature should
be approximately 140°F (60°C).
1. If the manual-reset, high-temperature-limit switch should trip the circuit breaker; reset
the switch by depressing the reset button--use a pencil or other non-metallic object to
depress the reset button. If the high-temperature-limit switch should again trip the circuit
breaker, contact an authorized service technician or an authorized dealer.
2. Both the electrical and gas operations of the water heater may be used simultaneously to
reduce recovery time of heating water up to desired temperature.
For general maintenance of the water heater or specific information about select steps in
operating the water heater, please refer to the owner’s manual for this appliance contained in
the Owner’s Information Package.
41
English