PLUMBING & BATH FEATURES
HOOKUP
To connect the city water supply, connect one end of the hose to the city water supply.
Turn the city water supply “on” for a few seconds to clear the line. Once the hose has been flushed, turn the supply
“off.” Connect the other end of the hose to the inlet valve on the sewer board; turn the blue handle valve on the
sewer board to the city water fixtures turn the red handle valve
on the sewer board to normal. (Note: As the water goes
through the inlet and then passes through the filter insuring
that all water exiting the faucets and showers have been
filtered). Once the city water fill valve is opened, water is
supplied to the freshwater system including the hot water
heater, faucets, and toilet. Turn “on” the water supply and
open all of the faucets to clear any trapped air within the
plumbing lines within the motor home.
Once any air pockets have purged from the water lines and water flows freely, close all the faucets. The city water
supply is pressurized; therefore, the water pump is not needed when the water system of the vehicle is connected
to the city water system.
The valves should never be turned while there is pressure on the lines.
The freshwater tank is normally filled from the city water inlet on the sewer board. The red and blue handle valves
located on the sewer board determine whether the city water is going through the water system or into the
freshwater tank. To fill the freshwater tank, turn the blue handle valve to city fill tank, turn the red handle valve to
normal. Since there is no automatic shut-off when filling the freshwater tank, check the level from the monitor
panel while filling the freshwater tank on the motorhome. (NOTE: As your freshwater tank fills the water passes
through the filter insuring that the water in the freshwater tank has been filtered before use).
All of the water should be drained from the freshwater system when the motorhome is not in use for an extended
period of time.
RUN HOT AND COLD FIXTURES FROM FRESH WATER TANK
After filling the freshwater you are ready to run the water system from the freshwater tank supply.
1. Turn “on” water pump.
2. On the sewer board turn the blue handle valve to the normal position and turn the red handle
valve to the normal position.
SANITIZING HOT AND COLD FIXTURES AND FRESHWATER TANK
To assure complete disinfecting of the freshwater system, it is recommended that the following procedures be
performed on a new system, on one that has not been used for a length of time, or one that may have become
87
English