Plumbing and Bath Features -> Water Heater Bypass System for Your Peugeot Wayfarer 4 Door First Generation (1995-2002)

PLUMBING & BATH FEATURES  
quart of vinegar to five gallons of water. Repeat steps four, five and six to run the solution  
through the water lines. Drain the system and flush with freshwater.  
WATER FILTER  
This unit is equipped with a water filter (Figure13-7) which must be  
removed before disinfecting the fresh-water system.  
First remove the water filter and then replace cover to allow the  
sanitizing solution access to the faucets. As installed, the filter will  
remove chlorine, dirt, and other matter. The filter will also eliminate  
most phenol (or similar) odors and tastes while delivering sparkling,  
taste-free water for drinking and cooking.  
The water filter is located in the sanitation compartment on the outside  
of the motorhome. The water filter is not guaranteed to  
Figure 13-7: Water Filter  
remove the tastes and odors of iron and sulfur. To remove these impurities, you need to chlorinate the  
water. Replacement filters are available that will filter iron and sulfur. Ask your dealer or RV supply center  
about purchasing an iron and sulfur filter.  
If you are traveling in an area where the water has high iron and sulfur content, then add one tablespoon of  
chlorine bleach to every 10 gallons of water in your tankthis will precipitate the iron or sulfur so that the  
filter can remove those impurities.  
If you are at a site where the unit is connected to a city water supply, you will not be able to chlorinate the  
system because the water flows straight to your faucets and not through the freshwater tank.  
Filters should be changed every 6-12 months depending on the quality and quantity of water that is used in  
your motorhome.  
WATER HEATER BYPASS SYSTEM  
This process is performed when winterizing your motorhome. Using the bypass  
valve will keep antifreeze out of the water heater when winterizing the  
motorhome. Draining the water heater during winterizing is a MUST.  
BYPASS WATER HEATER FOR MAINTENANCE  
This procedure is used for any maintenance that may be done to the water  
heater. On the sewer board turn the blue handle valve to the city fixture position  
and turn the red handle valve to the bypass position. (NOTE: You will still be able  
to use your faucets and showers if necessary but it can only be done with pressurized city water and will  
only receive cold water).  
Figure 13-8: Water Bypass  
89