INFORMATION ABOUT THE VEHICLE
The lifting points are compatible
Information on lifting
with the use of a jack equipped with
a flat plate and a diameter between
80 mm and 140 mm.
To prevent any risk of
injury or damage to the
vehicle, the jack must
only be cranked until
The jack used must comply with the
country's current standards and
regulations. The jack lifting capacity
must be greater than the vehicle's
maximum permissible weight on the
relevant axle ꢀ 0.
The jack is only to be used to lift the
vehicle in order to change the
wheels. This must be performed:
the wheel you are replacing is at
most three centimetres off the
ground.
Risk of injury. Risk of damage to
the vehicle.
– with the parking brake applied,
– with the vehicle unladen,
For safety reasons, the
vehicle lifting points
must only be used to
– on level, non-slip and solid ground.
Before lifting the vehicle, the plate of
the jack must be correctly posi-
tioned against the lifting point 1 .
Place the jack horizontally: the jack
head must be lined up with the sill 1
closest to the wheel concerned, as
shown by an arrow 2 .
change the wheels. Un-
der no circumstances should
they be used:
Your vehicle is equipped with four
dedicated lifting points 1 located un-
derneath the vehicle.
7
– to carry out a repair;
– to access the underside of the
vehicle.
For your safety, we rec-
ommend that you con-
tact an approved deal-
Risk of injury. Risk of damage to
the vehicle.
er to change the
wheels. Risk of damage to the
vehicle and particularly to the
electric traction battery in the
event of incorrect positioning
of the lifting equipment.
3 7 6 - T e c h n i c a l s p e c i f i c a t i o n s
English 
