Fuses and bulbs
–
–
–
2
Remove connector Fig. 107
from the
›››
Note
Change the front bulbs
bulb.
●
Please check at regular intervals that all
3
Unclip the retainer spring Fig. 107
›››
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
Dipped headlight bulb
pressing inwards to the right.
Extract the bulb and fit the replacement so
that the lug on the base fits into the recess
on the reflector.
●
Before changing a bulb, make sure you
have the correct new bulb.
●
Do not touch the glass part of the bulb
with your bare hands, use a cloth or paper
towel instead, since the fingerprints left on
the glass will vaporise as a result of the
heat generated by the bulb, they will be
deposited on the reflector and will impair
its surface.
Day light bulb
Fig. 106 Dipped beam headlights.
●
Depending on the level of equipment fit-
ted in the vehicle, LEDs may be used for
part or all of the interior and/or exterior
lighting. LEDs have an estimated life that
exceeds than that of the car. If an LED light
fails, go to an authorised workshop for its
replacement.
Fig. 108 Day light bulb.
–
–
Raise the bonnet.
1
Turn the bulb holder Fig. 108
clockwise and pull.
anti-
›››
Fig. 107 Dipped beam headlights.
–
–
Remove the bulb by pressing on the bulb
holder and turning it anti-clockwise at the
same time.
–
Raise the bonnet.
–
1
Move the loops Fig. 106
in the direc-
›››
tion of the arrow and remove the cover.
Installation involves all of the above steps in
reverse sequence.
93
English 
