2011-2020 Skoda Citigo SUV Technical data User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Technical data for Your Skoda Citigo SUV First Generation (2011-2020)

Type plate  
Technical data  
The type plate » Fig. 181 is located at the bottom of the B-pillar on the left  
driver's side.  
Technical data  
Basic vehicle data  
Introduction  
The type plate contains the following data.  
1
Vehicle manufacturers  
2
3
4
5
Vehicle identification number (VIN)  
Maximum permissible gross weight  
Maximum permissible front axle load  
Maximum permissible rear axle load  
The details given in the vehicle's technical documentation always take prece-  
dence over the details in the Owner's Manual.  
Vehicle identification number (VIN)  
The performance values listed were determined without performance-reduc-  
ing equipment, e.g. air conditioning system.  
The vehicle identification number - VIN (vehicle body number) is stamped into  
the engine compartment on the right hand suspension strut dome. This num-  
ber is also located on a sign on the lower left hand edge below the windscreen  
(together with a VIN bar code), and on the type plate.  
The values given have been determined in accordance with regulations and in  
conditions prescribed by legal or technical provisions for determining the op-  
erating and technical data of vehicles.  
Engine number  
The engine number is embossed in the engine block.  
The listed values are for the basic model without optional equipment.  
Abbreviations used  
WARNING  
Abbreviation  
ASG  
Meaning  
Do not exceed the specified maximum permissible weights – risk of acci-  
dent and damage!  
Automatic gearbox  
G-TEC  
MG  
Labelling for natural gas vehicles  
Manual gearbox  
Operating weight  
MPI  
Gasoline engine with a multi-point fuel injection  
This value is only a guide value and corresponds to the lowest possible operat-  
ing weight without further weight-reducing equipment (e.g. spare wheel etc.).  
This includes 75 kg driver's weight, the weight of the operating fluids and the  
on-board tool kit and a fuel tank filled to min. 90%.  
Vehicle data  
Fig. 181  
Type plate  
Operating weight  
Engine  
Transmission  
Operating weight (kg)  
1.0 l/44 kW MPI  
MT  
MG  
ASG  
MG  
934  
936  
1.0 l/55 kW MPI  
940  
1033  
1.0 l/50 kW MPI G-TEC  
141  
Technical data  
Note  
If required, you can find out the precise weight of your vehicle at a specialist  
garage.  
Payload  
It is possible to calculate the approximate maximum payload from the differ-  
ence between the permissible total weight and the operating weight.  
The payload consists of the following weights.  
▶
The weight of the passengers.  
The weight of all items of luggage and other loads.  
The weight of the roof, including the roof rack system.  
The weight of the equipment that is excluded from the operating weight.  
▶
▶
▶
Measurement of fuel consumption and CO emissions according to  
2
ECE Regulations and EU Directives  
The data on fuel consumption and CO emissions were not available at the  
2
time of going to press.  
The valid specifications for your vehicle can be found in the technical vehicle  
documentation (e.g. vehicle approval documentation, the COC document) or  
at a ŠKODA partner.  
Note  
■
The emission and fuel consumption values have been determined in accord-  
ance with rules and under conditions set out by legal or technical requirements  
for determining operational and technical data for motor vehicles.  
■
Depending on the range of equipment, style of driving, traffic situation,  
weather influences and vehicle condition, consumption values may deviate  
from the indicated values.  
142  
Technical data  
Dimensions  
Fig. 182 Vehicle dimensions  
The vehicle dimensions given in the vehicle's technical documentation always take precedence over the details in the Owner's Manual.  
The dimensions listed below are for the basic model without any optional equipment.  
Vehicle dimensions for operating weight without driver (in mm)  
» Fig. 182  
Specification  
Value  
1478  
Basic dimension  
G-TEC vehicles  
A
Height  
1480  
B
C
D
E
Front track  
1428  
1641- 1645a)  
Width  
Rear track  
1424  
Width including exterior mirror  
1910  
Basic dimension  
G-TEC vehicles  
Basic dimension  
G-TEC vehicles  
136  
F
Clearance  
134  
2420  
2421  
G
Wheel base  
Length  
H
3597  
a)  
Applies to 5-door models.  
143  
Technical data  
Departure angle  
Fig. 183  
Overhang angle  
Angle » Fig. 183  
A
B
Overhang angle, front  
Overhang angle, rear  
The overhang angle values indicate the maximum incline of a slope, up which  
the vehicle can drive at a slow speed without the bumper or underbody mak-  
ing contact with the slope. The values listed correspond to the maximum axle  
load, front or back.  
Departure angle (°)  
Overhang angle,  
front  
Overhang angle,  
rear  
Engine  
1.0 ltr./44 kW MPI  
1.0 l/55 kW MPI  
14.3  
14.3  
13.5  
22.3  
22.3  
28.0  
1.0 l/50 kW MPI G-TEC  
144  
Technical data  
Vehicle-specific data depending on the engine  
Introduction  
The values given have been determined in accordance with regulations and in conditions prescribed by legal or technical provisions for determining the operat-  
ing and technical data of vehicles.  
The exhaust gas standard is specified in the vehicle's technical documentation, as well as in the declaration of conformity (in the so-called COC document). The  
declaration of conformity (the so-called COC document) can be obtained from a ŠKODA Partner (only valid for some countries and some models).  
1.0 ltr./44 kW MPI engine  
Output (kW at 1/min)  
44/5000 - 6000  
95/3000 - 4300  
3- 999  
Maximum torque (Nm at rpm)  
3
Number of cylinders/displacement (cm )  
Transmission  
MG  
Top speed (km/h)  
with the mentioned gear engaged  
162  
(4)  
Acceleration 0-100 km/h (s)  
14.4  
1.0 l/55 kW MPI engine  
Output (kW at 1/min)  
55- 6200  
95/3000 - 4300  
3- 999  
Maximum torque (Nm at rpm)  
3
Number of cylinders/displacement (cm )  
Transmission  
MG  
ASG  
Top speed (km/h)  
with the mentioned gear engaged  
173  
(4)  
173  
(4)  
Acceleration 0-100 km/h (s)  
13.5  
14.9  
145  
Technical data  
1.0 l/50 kW MPI G-TEC engine  
Output (kW at 1/min)  
50- 6200  
90- 3000  
3- 999  
Maximum torque (Nm at rpm)  
3
Number of cylinders/displacement (cm )  
Transmission  
MG  
Top speed (km/h)  
with the mentioned gear engaged  
165  
(4)  
Acceleration 0-100 km/h (s)  
16.3  
146  
Technical data  

Related Topics

Basic vehicle data (Operating weight, Dimensions) Vehicle-specific data depending on the engine

Popular Owner Manuals

Audi
Audi
BMW
BMW
Citroen
Citroen
Ford
Ford
Honda
Honda
Peugeot
Peugeot