Get Technical data -> Basic vehicle data (Operating weight, Dimensions) Guide for Skoda Citigo SUV First Generation (2011-2020)

Type plate

Technical data

The type plate » Fig. 181 is located at the bottom of the B-pillar on the left

driver's side.

Technical data

Basic vehicle data

 Introduction

The type plate contains the following data.

1

Vehicle manufacturers

2

3

4

5

Vehicle identification number (VIN)

Maximum permissible gross weight

Maximum permissible front axle load

Maximum permissible rear axle load

The details given in the vehicle's technical documentation always take prece-

dence over the details in the Owner's Manual.

Vehicle identification number (VIN)

The performance values listed were determined without performance-reduc-

ing equipment, e.g. air conditioning system.

The vehicle identification number - VIN (vehicle body number) is stamped into

the engine compartment on the right hand suspension strut dome. This num-

ber is also located on a sign on the lower left hand edge below the windscreen

(together with a VIN bar code), and on the type plate.

The values given have been determined in accordance with regulations and in

conditions prescribed by legal or technical provisions for determining the op-

erating and technical data of vehicles.

Engine number

The engine number is embossed in the engine block.

The listed values are for the basic model without optional equipment.

Abbreviations used

WARNING

Abbreviation

ASG

Meaning

Do not exceed the specified maximum permissible weights – risk of acci-

dent and damage!

Automatic gearbox

G-TEC

MG

Labelling for natural gas vehicles

Manual gearbox

Operating weight

MPI

Gasoline engine with a multi-point fuel injection

This value is only a guide value and corresponds to the lowest possible operat-

ing weight without further weight-reducing equipment (e.g. spare wheel etc.).

This includes 75 kg driver's weight, the weight of the operating fluids and the

on-board tool kit and a fuel tank filled to min. 90%.

Vehicle data

Fig. 181

Type plate

Operating weight

Engine

Transmission

Operating weight (kg)

1.0 l/44 kW MPI

MT

MG

ASG

MG

934

936

1.0 l/55 kW MPI

940

1033



1.0 l/50 kW MPI G-TEC

141

Technical data

Note

If required, you can find out the precise weight of your vehicle at a specialist

garage.

Payload

It is possible to calculate the approximate maximum payload from the differ-

ence between the permissible total weight and the operating weight.

The payload consists of the following weights.

▶

The weight of the passengers.

The weight of all items of luggage and other loads.

The weight of the roof, including the roof rack system.

The weight of the equipment that is excluded from the operating weight.

▶

Measurement of fuel consumption and CO emissions according to

2

ECE Regulations and EU Directives

The data on fuel consumption and CO emissions were not available at the

2

time of going to press.

The valid specifications for your vehicle can be found in the technical vehicle

documentation (e.g. vehicle approval documentation, the COC document) or

at a ŠKODA partner.

Note

■

The emission and fuel consumption values have been determined in accord-

ance with rules and under conditions set out by legal or technical requirements

for determining operational and technical data for motor vehicles.

■

Depending on the range of equipment, style of driving, traffic situation,

weather influences and vehicle condition, consumption values may deviate

from the indicated values.

142

Technical data

Dimensions

Fig. 182 Vehicle dimensions

The vehicle dimensions given in the vehicle's technical documentation always take precedence over the details in the Owner's Manual.

The dimensions listed below are for the basic model without any optional equipment.

Vehicle dimensions for operating weight without driver (in mm)

» Fig. 182

Specification

Value

1478

Basic dimension

G-TEC vehicles

A

Height

1480

B

C

D

E

Front track

1428

1641- 1645^a)

Width

Rear track

1424

Width including exterior mirror

1910

Basic dimension

G-TEC vehicles

Basic dimension

G-TEC vehicles

136

F

Clearance

134

2420

2421

G

Wheel base

Length

H

3597

a)

Applies to 5-door models.

143

Technical data

Departure angle

Fig. 183

Overhang angle

Angle » Fig. 183

A

B

Overhang angle, front

Overhang angle, rear

The overhang angle values indicate the maximum incline of a slope, up which

the vehicle can drive at a slow speed without the bumper or underbody mak-

ing contact with the slope. The values listed correspond to the maximum axle

load, front or back.

Departure angle (°)

Overhang angle,

front

Overhang angle,

rear

Engine

1.0 ltr./44 kW MPI

1.0 l/55 kW MPI

14.3

13.5

22.3

28.0

1.0 l/50 kW MPI G-TEC

144

Technical data

Technical data -> Basic vehicle data (Operating weight, Dimensions) for Your Skoda Citigo SUV First Generation (2011-2020)

Related Topics

Popular Owner Manuals

Latest Owner Manuals