Get Using the system -> Seats and head restraints Guide for Skoda Citigo SUV First Generation (2011-2020)

The knob for the electrically adjustable mirrors can be moved to the following

positions » Fig. 51 - .

Seats and head restraints

Front seats



Adjust the left-hand exterior mirror



Switch off mirror control

 Introduction



Adjust the right-hand exterior mirror



Exterior mirror heater (only operates when the engine is running)

WARNING

Folding in the exterior mirrors

■

Only adjust the driver's seat when the vehicle is stationary – otherwise

risk of accident!

Caution when adjusting the seat! You may suffer injuries or bruises as a

result of adjusting the seat without paying proper attention.

The mirror can be manually folded in towards the side window. To put it back

into its original position, it should be folded back from the side window until it

audibly clicks into place.

■

WARNING

Do not touch the exterior mirror surfaces, if the exterior mirror heating is

switched on - hazard of burning.

Adjusting the front seats

Fig. 52

Controls on the left front seat

 Read and observe on page 50 first.

Adjusting the seat in the longitudinal direction (after releasing the control

lever, locking must be audible)

Adjusting the seat height

Adjusting the tilt of the backrest (do not lean on the backrest when adjust-

ing)

Adjust the tilt of the seat back (seats with Easy Entry System)

Some controls are arranged in mirror image formation on the passenger seat.

Fold forward and slide seat using the Easy Entry System

Pull lever

» Fig. 52 and fold the seat backrest forwards.

›

At the same time, move the seat forwards.

›

Restore position of the seat with Easy Entry System



Push the seat backwards again to its original position.

›

Using the system

Fold the seat backrest back. The locking mechanism must audibly snap into

place.

Check this by pulling on the seat backrest.

›

WARNING (Continued)

When moving the seat backrest, keep limbs out of the area between the

seat and seat backrest – risk of injury!

Never transport the following items on the seat backrest when folded

■

Note

forwards.

After a certain time, play can develop within the adjustment mechanism of the

backrest angle.

■

Objects that could restrict the driver's view.

Objects which make it impossible for the driver to control the vehicle

■

(e.g. if they roll under the pedals, or protrude into the driver's zone).

Objects which could lead to injury to passengers (e.g. if accelerating

Folding front passenger seat

■

sharply, braking or changing direction).

Fig. 53

Folding the front passenger seat

forward

Rear seat backrests

 Read and observe on page 50 first.

The front passenger seat can (depending on vehicle equipment fitted) be fol-

ded forward into a horizontal position.

Fig. 54 Fold down seat backrest / pull on belt for side trim panel

To fold the seat down, pull the lever in the direction of arrow

and fold

›

down the seat back in the direction of arrow

» Fig. 53. The locking mecha-

Folding forward

Press the release handle

nism must audibly snap into place.

in the direction of arrow

and tilt » Fig. 54 the

›

Slide the seat forwards up to the stop.

To fold back, pull the lever in the direction of arrow

›

seat backrest in the direction of arrow

pull and fold back the

seat back in the direction of arrow . The locking mechanism must audibly

snap into place.

Remove or push the head restraints all the way down » page 52 and fold the

›

seat backrest forward in the direction of arrow

Move the seat all the way back to the stop (depending on the specification,

the seat may resume the forward position it previously had).

›

For all-in-one seat backrests, press the release handles A on both sides of the

seat backrest at the same time.

WARNING

Folding backwards

If the head restraints had been removed, they should be reinserted with the

›

■

If the seat backrest is folded down, only the seat behind the driver's seat

backrest slightly raised» page 52.

can be used to transport passengers.

■

Pull the seat belt

for the side panel in the direction of arrow

» Fig. 54.

until the release

audibly locks. Check this by pulling on the seat backrest.

›

When transporting objects on the folded seat backrest, the front passen-

Raise the seat backrest against the direction of arrow

ger airbag should be deactivated » page 16.

■

handle

Make sure that the red marker

Do not adjust the seat back while driving - danger of injury and accidents!



is not visible.

›

Seats and head restraints

For all-in-one seat backs, pull the two seat belts towards the side panel. After

Note

folding back the seat back, the release handles

should audibly click into

The front headrests are integrated into the seat backrests and cannot be ad-

justed in height.

place on both sides of the seat back and the red mark

on either side of the seat back.

should not be visible

Removing/inserting

WARNING

■

The seat backs in occupied rear seats must be properly engaged.

When transporting objects in the luggage compartment that has been en-

■

larged by folding the backrest forward, ensure the safety of the passenger

being transported on the other rear seat.

■

The seat backrests must be securely locked in position so that no objects

in the luggage compartment can slide into the passenger compartment on

sudden braking – risk of injury.

CAUTION

When moving the seat backrest the seat belts should not be trapped - there is

a risk of damage to the seat belts.

Fig. 56 Removing/inserting the rear headrests

Only the rear headrests can be removed or installed.

Headrests

Before removing/fitting the headrests, fold the corresponding seat backrest

slightly forward » page 51.

›

Setting the height

To remove the headrest, pull it out of the seat backrest as far as the stop.

›

Hold down the securing button

in the direction of arrow , at the same

›

time insert the vehicle key in opening

move the headrest in the direction of arrow

To insert the headrest, push the headrest into the seat backrest in the direc-

in the direction of arrow

and re-

» Fig. 56.

›

tion of arrow

until the locking button clicks into place.

Front seat heating

Fig. 57

Buttons for heating the front

seats

Fig. 55 Setting the height of the back headrest

Only the front headrests are height-adjustable.

Grasp the headrest and move upwards in the direction of arrow

» Fig. 55.

in the direction of

and hold it down while pressing the headrest in the direction of ar-

›

To move the headrest down, press the securing button

arrow

row



The seat backrests and seats can be heated electrically.

Using the system

Using the system -> Seats and head restraints for Your Skoda Citigo SUV First Generation (2011-2020)

Related Topics

Popular Owner Manuals

Latest Owner Manuals