2011-2020 Skoda Citigo SUV Using the system -> Transport of cargo User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Using the system -> Transport of cargo for Your Skoda Citigo SUV First Generation (2011-2020)

CAUTION  
Transport of cargo  
Never exceed the maximum permissible load for the respective fasteners,  
nets, hooks etc. - these could be damaged.  
Please ensure that the heating elements for the rear window heater are not  
Luggage compartment and transporting objects  
Introduction  
damaged as a result of abrasive objects.  
Do not place any sharp objects in the nets in the luggage compartment -  
there is a risk of damage to the nets.  
When transporting heavy objects, the driving characteristics change due to  
the shift in centre-of-gravity. Therefore, adjust the speed and driving mode ac-  
cordingly.  
Fasteners  
When transporting cargo the following instructions must be adhered to  
Distribute the load evenly in the luggage compartment and secure it with  
Fig. 80  
Fasteners  
suitable lashing straps to the lashing eyes or fixing nets so that they cannot  
slip.  
Place heavy objects as far forward in the luggage compartment as possible.  
Tyre pressure should be adjusted for the load.  
In the event of an accident, even small and light objects gain so much kinetic  
energy that they can cause severe injuries.  
The magnitude of the kinetic energy is dependent on the speed at which the  
vehicle is travelling and the weight of the object.  
Read and observe and on page 61 first.  
Luggage compartment light  
The fasteners are located on both sides of the luggage compartment.  
The light switches on/off when the luggage compartment lid is opened or  
closed.  
Overview of the fastening elements » Fig. 80  
A
B
C
Fasteners only for fastening fixing nets  
Hooks for hanging small items of luggage (e.g. bags)  
Lashing eye for fastening the load  
If the boot lid is open and the ignition switched off, the light will go out auto-  
matically after 10 minutes.  
WARNING  
B
The maximum static load for each hook  
is 1.5 kg and the individual lashing  
Never exceed the maximum permissible load of the respective fasteners,  
eyes C is 350 kg.  
nets, hooks etc. If heavy objects have not been suitably secured, there is a  
risk of injury!  
An unsecured dirt or improperly attached load could slip during a sudden  
WARNING  
Do not use hook  
damage to the hook during sudden braking or a vehicle collision.  
B
» Fig. 80 to lash down any objects - there is a risk of  
manoeuvre or in an accident - danger of injury!  
Loose cargo could hit a deployed airbag and injure occupants – danger of  
death!  
When transporting loads in the luggage compartment that has been en-  
larged by folding one of the rear seats forward, care should be taken to en-  
sure the safety of passengers transported on the other rear seat.  
61  
Transport of cargo  
Fixing nets  
Luggage compartment cover  
Fig. 81 Example of how to fix nets/fastening details for the rear area of  
the luggage compartment  
Fig. 83 Remove the luggage compartment cover  
Read and observe and on page 61 first.  
A
If the support straps  
» Fig. 83 are attached to the boot lid, then opening the  
lid will raise the boot lid cover (hereafter referred to as cover).  
Fold up and lock  
Raise the cover and bolt it down » Fig. 83 on both sides of the boot lid in the  
B
studs  
.
B
» Fig. 83.  
Removal  
Fig. 82 Details of the fastening behind the rear seats  
A
On both sides of the boot lid unhook the straps  
in the direction of arrow  
1
» Fig. 83.  
Press down on both sides on the underside of the cover to free them from  
Read and observe and on page 61 first.  
Fastening examples for nets » Fig. 81 and » Fig. 82  
C
the studs  
.
2
Take out the cover in the direction of arrow  
.
cross bags  
Inserting  
Fastening details in the rear area of the luggage compartment  
Details of the fastening to the upper lashing eyes behind the foldable rear  
seat rest  
D
C
Position the fixtures  
Press down on both sides on the top of the cover in the area of the studs  
The fixtures  
gage compartment.  
on the cover over the studs  
» Fig. 83.  
C
.
D
C
must lock into place in the studs  
on both sides of the lug-  
Details of the fastening to the lashing eyes on the luggage compartment  
floor behind the rear seats  
A
On both sides of the boot lid unhook the straps  
.
The maximum permissible load for each of the nets is 1.5 kg.  
62  
Using the system  
WARNING  
Class N1 vehicles  
Do not place any objects on the cover during the trip - risk of injury if  
braking suddenly or colliding!  
Never ride with the cover up - risk of damage to the cover.  
Read and observe and on page 61 first.  
In class N1 vehicles that are not fitted with a protective grille, a lashing set that  
complies with the EN 12195 standard (1-4) must be used for fastening the load.  
Variable loading floor  
For safe vehicle operation, the proper functioning of the electrical installation  
is essential. It is important to ensure that it is not damaged in adaptation as  
well as the loading and unloading of the cargo space.  
Transportation on the roof rack  
Fig. 84 Variable loading floor in the raised position: raise / raised  
Fig. 86 Attachment points - 3-door  
Fig. 85 Variable loading floor: lower / lowered  
Read and observe and on page 61 first.  
A
To raise the loading floor, grasp handle  
and raise as far as the stop in the  
Fig. 87 Attachment points - 5-door  
1
direction of arrow  
» Fig. 84.  
To lower it, lift the loading floor, push it into the grooves in the direction of  
A
B
The attachment points  
» Fig. 86 and » Fig. 87.  
and  
are located on both sides of the vehicle  
2
3
arrow  
arrow  
insert and lay it on the luggage compartment floor in direction of  
.
The basic carrier should be mounted and dismounted in accordance with the  
instructions provided.  
63  
Transport of cargo  

Related Topics

Popular Owner Manuals