2020-2024 Skoda Enyaq 4 Door Keys, locks and alarm system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Keys, locks and alarm system for Your Skoda Enyaq 4 Door First Generation (2020-2024)

Keys, locks and alarm system › Key 33  
Removing the key bit  
Keys, locks and alarm system  
› Press securing tab A . The pendant  
part B of the key bit folds out.  
Key  
Key Overview  
› Press the securing tab A again.  
Remove the key bit.  
›
Locking the vehicle  
Operating the boot lid  
Unlocking the vehicle  
Battery status warning light  
A
B
Locking tab for removal of the  
key bit  
NOTICE  
Protect the key from moisture and strong vibrations.  
Keep the grooves in the key clean.  
▶
▶
The effective range of the key signal is about 30 m. The ef-  
fective range can be reduced, e.g. due to signal interference  
from other transmitters.  
Troubleshooting  
The battery in the key is almost empty  
After pressing a button on the key, the warning light does not  
▶
flash.  
Or:  
34 Keys, locks and alarm system › Key  
A message stating it is necessary to change the battery will be  
displayed.  
Remove the key bit and partially  
insert it into the opening.  
Press down on the key fob to re-  
lease the top cover.  
▶
›
›
Replace the battery » page 34.  
›
The vehicle cannot be unlocked or locked with the remote  
control  
There may be the following reasons:  
The battery in the key is empty.  
Replace the battery » page 34.  
The key is not synchronized.  
▶
›
▶
Open the battery cover.  
›
Synchronize the key as follows:  
Press any button on the key.  
Unlock the door within 1 minute with the key via the locking  
cylinder » page 37.  
›
›
If necessary, the key must be synchronized if a favoured but-  
ton on the key has been repeatedly pressed outside of the effec-  
tive range of the remote control.  
Insert a thin screwdriver into the  
recess A and remove the battery.  
›
›
Changing the key battery  
The new battery must comply with the specification of the origi-  
nal battery.  
Press any button on the remote  
key to reset the key.  
Insert the new battery.  
Fit the battery cover and press un-  
til it clicks into place.  
›
›
Keys, locks and alarm system › Central locking 35  
The SAFE function is activated when the vehicle is locked from  
the outside.  
WARNING  
Risk of death!  
If the battery is swallowed, serious or even fatal injuries can re-  
sult from burns in the digestive tract.  
In the display of the instrument cluster after the ignition is  
switched off, a message regarding the SAFE function is dis-  
played.  
Always keep children away from the vehicle key and batteries.  
▶
If the battery is swallowed, seek medical help immediately.  
▶
DANGER  
Risk of death!  
No people are allowed in the locked vehicle with the SAFE  
function.  
▶
Central locking  
Functionality  
Turn off the SAFE function  
By double locking within 2 seconds.  
▶
Central locking system  
The system simultaneously unlocks and locks all doors, the  
charging socket cover and the boot lid.  
Or:  
Together with the deactivation of the interior monitor-  
▶
Unlock indicator: double flashing of the indicator lights.  
Lock indicator: single flashing of the indicator lights.  
ing » page 40, Settings.  
The warning light in the driver's door will flash for about 2 sec-  
onds in quick succession after the vehicle is locked, then goes  
out and starts flashing regularly at longer intervals after about  
30 secs.  
The warning light in the driver's door will flash for about 2 sec-  
onds in quick succession after the vehicle is locked, then it will  
start flashing regularly at longer intervals.  
When the SAFE function is switched off, the door can be opened  
from the inside by pulling once on the opening lever.  
If no door is opened within 45 seconds after unlocking, the  
vehicle automatically locks again.  
If the handle of the boot lid is not pressed within 120 s, the lid  
automatically locks again.  
The SAFE function is switched on again after unlocking and  
locking the vehicle.  
SAFE function  
Depending on the equipment, the central locking system can in-  
clude the SAFE function.  
Operation  
Ways in which central locking operates  
Depending upon vehicle equipment:  
The SAFE function prevents the doors from opening from the  
inside once the vehicle is locked.  
Key » page 33  
Keyless locking (KESSY)» page 37.  
▶
▶
36 Keys, locks and alarm system › Central locking  
Central locking button  
Doors on one side of the vehicle  
▶
Using the button on the key, the doors on the driver’s side and  
the battery charging flap are unlocked.  
Lock/unlock using the central locking button  
The button in the middle part of the control panel.  
›
In vehicles equipped with a keyless locking system, the doors on  
the passenger’s side near to which the key is located and the  
fuel filler flap are unlocked by touching the door handle.  
The symbol in the button comes on when locked.  
The button locks/unlocks all of the doors and the boot lid.  
The vehicle is also unlocked when a door is opened from the in-  
side.  
When unlocked again, the other doors and the boot lid are un-  
locked.  
WARNING  
A locked vehicle with a central locking button makes it difficult  
for responders to enter the vehicle in an emergency.  
Troubleshooting  
Central locking fault  
The warning light in the driver's door first flashes for 2 secs in  
quick succession.  
▶
Setting the unlocking and locking function  
Then it lights up continuously.  
After 30 secs, it flashes slowly.  
▶
▶
In the Infotainment system, select the menu  
Out-  
›
›
›
side  
.
Seek the help of a specialist garage.  
By moving your finger sideways, choose the screen with the  
›
menu item Central locking  
.
Select Central locking  
.
All doors  
Unlocking of all doors, the boot lid and the battery charging flap.  
Single door  
Using the button on the key, the driver's door and the battery  
charging flap are unlocked.  
In vehicles equipped with a keyless locking system, the door  
near to which the key is located and the battery charging flap  
are unlocked by touching the door handle.  
When unlocked again, the other doors and the boot lid are un-  
locked.  
Keys, locks and alarm system › Keyless locking (KESSY) 37  
Locking the door without the lock cylinder  
Mechanically unlocking and locking the door  
Unlocking and locking the door with the lock cylinder  
Remove the cover  
Pull the handle on the front left  
door and hold it in place.  
›
Insert the key bit into the recess  
on the underside of the cover.  
›
Lift the cover in the direction of  
the arrow.  
›
Release the door handle.  
›
Open the door.  
›
For vehicles with a panel over the opening, remove the panel.  
Insert the key or a flat-head screwdriver into the slot.  
Turn the key or flat-head screwdriver towards the outside of  
the vehicle (spring-loaded position).  
›
Locking and unlocking  
›
›
Insert the removed key bit with  
›
the pendant facing downwards in-  
to the lock cylinder, then unlock or  
lock it.  
After closing, the door is locked.  
Install cover  
Pull on the door handle and hold it.  
Replace the cover.  
Release the door handle.  
›
Keyless locking (KESSY)  
Usage  
›
›
The keyless locking system, KESSY, enables unlocking and lock-  
ing of the vehicle without actively using the remote control key.  
Operation  
Keep the key with you when unlocking and locking.  
38 Keys, locks and alarm system › Keyless locking (KESSY)  
The sensors on the handle are intended to be operated with bare  
hands, e.g. wearing gloves may affect the function of the sen-  
sors.  
Protection against inadvertently locking the key in the vehicle  
If the key is locked inside the vehicle, the vehicle will unlock it-  
self automatically. If no door is opened within 45 seconds, the  
vehicle automatically locks again.  
The recess on the door handle is also present on vehicles  
without the keyless locking system.  
If the key is locked in the luggage compartment, the luggage  
compartment lid can be opened within 2 minutes.  
Release  
Grab the door handle.  
Open the door.  
›
›
Settings  
Deactivate keyless locking  
Lock the vehicle with the button on the key.  
Within 5 s, touch the sensor on the door handle with your fin-  
ger.  
›
›
Deactivation is confirmed by a single flash of the direction indi-  
cators.  
To check the deactivation, wait at least 10 seconds and then  
pull the door handle.  
›
Lock  
The door must remain locked.  
Touch the sensor.  
›
Keyless locking is automatically activated once again after the  
vehicle is unlocked.  
After locking, it is not possible to  
unlock within 2 seconds by touch-  
ing the door handle. This can be  
used to check whether the vehicle  
is locked.  
Permanently deactivate keyless locking  
In the Infotainment system, select the menu  
Out-  
›
›
›
side  
.
By moving your finger sideways, choose the screen with the  
menu item Central locking  
.
Select Central locking Keyless Access  
.
Unlocking the boot lid  
Press the handle of the boot lid.  
›
Keys, locks and alarm system › Alarm system 39  
Activate / deactivate automatic unlocking when the key ap-  
proaches the vehicle  
Alarm system  
Functionality  
In the Infotainment system, select the menu  
Out-  
›
›
›
side  
.
The alarm system triggers audible and visual signals during a  
break-in or towing attempt.  
By moving your finger sideways, choose the screen with the  
menu item Central locking  
.
The alarm system is activated automatically approximately 30  
seconds after the vehicle is locked.  
Select Central locking Unlock the vehicle when approaching  
.
If the vehicle is not unlocked for a longer period of time, the  
function can be deactivated automatically.  
The alarm system is automatically deactivated after the vehicle  
is unlocked.  
If single door locking or unlocking of the doors on one side of  
the vehicle is set, there is no vehicle unlocking when the key ap-  
proaches the rear of the vehicle.  
Alarm triggering  
The activated alarm system triggers an alarm when one of the  
following events occurs:  
Opening the front flap  
Opening the boot lid  
Opening the door  
Manipulation of the ignition lock  
Towing the vehicle  
Movement in the vehicle  
Sudden and significant voltage drop of the electrical system  
Uncoupling the trailer  
▶
▶
▶
▶
▶
▶
▶
▶
▶
Troubleshooting  
The vehicle cannot be unlocked or locked using the sensors  
on the handle  
Lock or unlock the vehicle with the button on the key.  
Then try to unlock or lock the vehicle using the sensors on the  
handle.  
›
›
If keyless locking does not work, seek the help of a specialist  
garage.  
›
Opening the door unlocked via the lock cylinder  
If the vehicle is not unlocked for a longer period of time, the  
function can be deactivated automatically.  
Switching off the triggered alarm  
Unlock the vehicle.  
›
When the ignition was switched on, no key was found  
illuminates  
Or:  
Turn on the ignition.  
›
Message that no key was found in the vehicle  
Insert the key into the vehicle.  
›
40 Keys, locks and alarm system › Alarm system  
By moving your finger sideways, choose the screen with the  
Operating conditions  
›
›
menu item Central locking  
.
For the correct functioning of the alarm system, all windows  
must be closed.  
Select Central locking and deactivate the interior monitoring by  
moving the slider to the left.  
A trailer is integrated into the alarm system under the following  
conditions:  
The deactivated functions are reactivated after the vehicle is un-  
locked and locked again.  
✓ The vehicle is factory-fitted with a towing device.  
✓ The trailer is electrically connected to the vehicle via the  
Deactivation is to be carried out if the vehicle is, for example,  
towed or transported.  
trailer socket.  
✓ The trailer is not equipped with LED taillights.  
After switching off the ignition, a menu is displayed on the In-  
fotainment screen, showing where the interior monitoring can  
be deactivated.  
If the electrical connection to the trailer is interrupted on a vehi-  
cle with an activated alarm system, warning signals are trig-  
gered.  
Disable the alarm before connecting or disconnecting a trail-  
er.  
Settings  
The following functions of the alarm system can be deactivated  
at the same time:  
Interior monitoring  
Towing protection  
▶
▶
Deactivation will also switch off the SAFE function » page 35,  
Functionality.  
Deactivation  
By double locking within 2 seconds.  
▶
Or:  
▶ In the Infotainment system, in the menu:  
Outside.  

Related Topics

Popular Owner Manuals