Removing and installing carrier rails
Net partition (Fabia Estate)
Introduction
This chapter contains information on the following subjects:
Using the net partition behind the rear seats
Using the net partition behind the front seats
Removing and refitting the net partition housing
73
74
74
WARNING
■
The belt locks and the belts must be in their original position after folding
back the seat cushions and backrests - they must be ready to use.
The seat backrests must be securely latched in position so that no ob-
■
Fig. 69 Slacken check points/remove carrier rails
Read and observe on page 72 first.
Removing
jects from the luggage compartment can slip into the passenger compart-
ment under sudden braking – there is a risk of injury.
Ensure that the rear seat backrests are properly engaged. It is only then
that the three-point seat belt for the middle seat can reliably fulfil its func-
tion.
■
Undo the securing points B » Fig. 69 on the carrier rails using the vehicle
key or a flat screwdriver.
›
■
Make sure that the transverse rod is inserted into the mounts C » Fig. 70
Grasp the carrier rail A at position
1
and slacken it by pulling in the direc-
›
on page 73 or » Fig. 71 on page 74 in the forward position.
tion of arrow. You can take out the removable storage compartments in or-
der to facilitate the removal » page 83, Storage compartments in the boot.
Grasp the carrier rail A at position 2 and slacken it by pulling in the direc-
tion of arrow.
The carrier rail on the other side of the luggage compartment can be re-
moved in the same way.
Using the net partition behind the rear seats
›
›
Fitting
Position the carrier rails on the sides of the boot.
Press the two securing points B » Fig. 69 on each carrier rail to the stop.
Check the attachment of the carrier rails by pulling it.
›
›
›
WARNING
Ensure that the carrier rails and variable loading floor are correctly fastened
when fitting the variable loading floor. If this is not the case, there is a risk
of injury for the occupants.
Fig. 70 Extending/retracting the net partition
Read and observe on page 73 first.
Extending
Open the rear right door.
Fold down the rear seat backrests slightly forwards, which makes it possible
to clear the access for removing the net partition.
›
›
73
Seats and storage
English 
