Power window force limiter
Operational faults
Read and observe and on page 51 first.
Read and observe and on page 51 first.
The electrical power windows are fitted with a force limiter. It reduces the risk
of bruises or injuries when closing the windows.
Electrical power windows do not operate
If the battery has been disconnected and then reconnected while the window
was opened, the electrical power windows will not operate. The system must
be activated. Proceed as follows to re-establish the function.
If there is an obstacle, the closing process is stopped and the window goes
down by several centimetres.
Switch on the ignition.
Pull the top edge of the button in the driver's door and close the window.
Release the button.
Pull the relevant button upwards again for another approximately 3 seconds
›
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down
by several centimetres.
›
›
›
and hold.
If you attempt to close the window again within 10 seconds of the window be-
ing moved down for the second time, even though the obstacle was not yet
been removed, the closing process is only stopped. During this time it is not
possible to automatically close the window. The force limiter is still switched
on.
Operation in winter
In the winter, ice on the window may cause greater resistance as the window
is closed. The window will stop and open again by several centimetres.
It is necessary to deactivate the force limiter to close the window » page 53.
The force limiter is only switched off if you attempt to close the window again
within the next 10 seconds - the window will now close with full force!
Electric sliding/tilting roof
If you wait longer than 10 seconds, the force limiter is switched on again.
Introduction
Window convenience operation
This chapter contains information on the following subjects:
Read and observe and on page 51 first.
Operation
54
Comfort operation
Emergency operation
54
55
The comfort controls of the windows provide the ability to open or close all the
windows at once.
The sliding/tilting roof is operated with the rotary switch » Fig. 38 on
page 54 and only works when the ignition is switched on. The control dial
has several positions.
Opening can take place in one of the following ways.
Opening
Press the symbol button on the remote control key and hold.
Hold the key in the driver's lock in the unlock position.
Hold button A » Fig. 37 on page 52 in the opening position.
›
The sliding/tilting roof can still be opened, closed and tilted for approx. 10 mi-
nutes after switching the ignition off. However, as soon as one of the front
doors is opened it is no longer possible to operate the sliding/tilting roof.
›
›
Closing
Press the symbol button on the remote control key and hold.
Hold the key in the driver's lock in the lock position.
Hold Button A » Fig. 37 on page 52 in the closing position.
WARNING
›
›
Close the sliding/tilting roof carefully – risk of injury.
›
The movement of the window is immediately stopped by releasing the key or
the respective button.
53
Unlocking and locking
English 
