Read and observe and on page 51 first.
Power window buttons » Fig. 37.
CAUTION
■
Keep the windows clean to ensure the correct functionality of the electric
windows.
Should the windows freeze, first remove the ice » page 131, Windows and
exterior mirrors and only then operate the power windows. Otherwise, the
window seal and the power window mechanism could be damaged.
In the winter, ice on the window may cause greater resistance as the win-
dow is closed. The window will stop and open again by several centimetres.
Always make sure that the windows are closed when you leave the locked
A
B
C
D
S
Button for electrical power window of the driver's door
Button for electrical power window of the front passenger door
Button for electrical power window of the rear right door
Button for electrical power window of the rear left door
Safety pushbutton
■
■
■
The electrical power windows can only be operated when the ignition is
switched on.
vehicle.
For the sake of the environment
At high speeds, you should keep the windows closed to prevent unnecessarily
high fuel consumption.
Opening
A window is opened by pressing lightly on the relevant button. The opening
›
process stops when one releases the button.
Note
The window will also open fully automatically if you briefly press the button as
far as the stop. Renewed pressing of the button causes the window to stop
immediately.
■
After switching the ignition off, it is still possible to open or close the win-
dows for approx. 10 minutes. After the driver's or front passenger's door has
been opened, the windows can only be operated by using A » Fig. 37 on
page 52 .
Closing
The window is closed by pulling lightly on the relevant button. The closing
process stops when one releases the button.
›
■
When driving always use the existing heating, air conditioning and ventila-
tion system for ventilating the interior of the vehicle. If the windows are
opened, dust as well as other dirt can get into the vehicle and in addition the
wind noise is more at certain speeds.
The window will also close fully automatically if you briefly pull the button as
far as the stop. Renewed pulling of the button causes the window to stop im-
mediately.
Opening/closing the windows
Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by press-
ing the safety switch S » Fig. 37. The buttons for the electrical power win-
dows in rear doors are activated again by pressing the safety pushbutton
again.
S
If the buttons for the rear doors are deactivated, the warning light in the
safety switch S lights up.
Note
The window lift mechanism is equipped with protection against overheating.
Repeated opening and closing of the window can cause this mechanism to
overheat. If this happens, it will not be possible to operate the window for a
short time. You will be able to operate the window again as soon as the over-
heating protection has cooled down.
Fig. 37 Buttons on the driver's door/in the rear doors
52
Using the system