28 Doors, windows and boot lid › Window - with electrical operation
once again and the window goes down by several
centimetres.
Pull the corresponding button until it stops; the
window closes automatically. By pressing the but-
ton again, the closing process is stopped.
›
If you attempt to close the window again within
10 seconds of the window being moved down for
the second time, even though the obstacle was not
yet been removed, the closing process is only stop-
ped. During this time, it is not possible to automati-
cally close the windows by pulling the button all the
way. The force limiter is, however, switched on.
After switching off the ignition, the windows can
still open and close for about 10 minutes so long as
none of the doors are opened.
Open all of the windows at the same time
Press and hold the button on the key.
›
Or:
The force limiter is only not operational if you at-
tempt to close the window again within the next
10 seconds – the window will now close with full
force! If you wait longer than 10 seconds, the force
limiter is switched on again.
Turn off the ignition, open the driver's door, and
hold down the driver's window button until it
stops.
›
Close all of the windows at the same time
CAUTION
Risk of injury!
Close the windows carefully, even though they
have a force limiter.
Press and hold the button on the key.
›
Or:
▶
Turn off the ignition, open the driver's door, and
pull upwards on the driver's window button until it
stops.
›
Overview of the operating buttons on the
driver's door
Or:
For vehicles with a keyless locking system, hold
one finger on the sensor on the outside of the han-
›
Depending upon vehicle
equipment:
dle on the front door.
Front left window
Front right window
Rear left window
Rear right window
A
B
C
D
E
Settings
The window operation is set in the following menu in
the Infotainment system:
Menu item for window operation
Deactivation/activa-
tion of the buttons in
Or:
the rear doors
Menu item for window operation
Operation
Troubleshooting
When the windows are open, irritating noises
may occur at certain speeds.
The window regulator has stopped working after
repeated opening and closing
The window regulator mechanism could have over-
heated.
Opening
Press the corresponding button slightly down-
›
wards and hold it until the window has reached the
desired position.
Allow the window regulator mechanism to cool
›
down.
Or:
The window operation does not work after discon-
necting the 12 volt vehicle battery
Press the corresponding button until it stops; the
›
Enable window operation » page 28.
›
window opens automatically. Pressing the button
again will stop the opening process.
Closing
Activation after disconnecting the 12-volt
vehicle battery
To close, pull gently upwards on the top edge of
›
the corresponding button and hold until the win-
dow has reached the desired position.
Activate automatic window operation
Turn on the ignition.
Pull the corresponding button upwards and the
window closes.
›
›
Or:
English 
