Wheels › Wheel bolt cover caps 217
Disconnecting
Settings
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
Tyre type
Select the tyre type in the following menu.
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
›
Or:
Installing
Press the wheel trim onto the wheel rim at the
designated valve opening.
›
Vehicle loading condition
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
In the following menu, select the menu item for
displaying the vehicle condition.
›
›
Or:
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
Using the functional surfaces choose the menu
›
item
.
Tyre pressure monitor
.
Tap the
load condition.
functional area and select the vehicle
›
Removing and installing the Aero trim
Applies to factory built or original accessory trims
from ŠKODA.
Troubleshooting
Removal
Functional restriction / system fault
flashes
Stop the engine and start again.
If the indicator light flashes again after the engine
›
›
starts, there is a problem with the system.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
›
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
Hook the bracket as close to the centre as possible
to remove the wheel covers at the edge of the
panel.
Pull off the centre of the wheel cover by loosening
it and pulling off the trim.
›
›
Push the pull-off clamp
onto the cover cap up
to the stop.
›
To facilitate removal, it is possible to insert the
wheel wrench through the bracket loop and pull on
the two key ends.
Remove the cover cap.
›
Installing
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
›
Position the panel on the wheel rim and push in the
individual spokes of the panel one after the other
until they are fully engaged.
›
Installing
Push the cover cap onto the wheel bolt to the stop.
›
Press in the centre of the wheel cover until it en-
gages completely.
›
NOTICE
Full wheel frame
Use hand pressure, do not hit the wheel cover.
▶
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
English 
