Lighting, windscreen wipers and washers › Dynamic Light Assist headlight assist system 51
✓
The light switch is in the position
.
service
turn on
✓ The driving speed is higher than 30 km/h (for
some countries, higher than 60 km/h).
Push the lever in the
direction of the arrow.
›
✓ The low beam is switched on.
Lights up in the instru-
service
turn on
ment cluster
from
the isolation box.
Push the lever in the
direction of the arrow.
›
Turn off
Manually switch the high beam on or off.
Lights up in the instru-
›
ment cluster
from
the isolation box.
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example.
Turn off
Manually switch the high beam on or off.
›
The headlights/lights of oncoming vehicles are
covered by crash barriers, for example.
▶
Settings
The headlamps/lights of the oncoming or preced-
ing vehicle are dirty or not functioning. The system
can also recognize a vehicle as a single-lane means
of transport.
▶
Activation / deactivation
The function is activated or deactivated in the fol-
lowing menu in the Infotainment system.
Or:
Settings
Activation / deactivation
The Dynamic Light Assist is activated or deactivated
in Infotainment in the following menu.
Dynamic Light Assist headlight assist
system
Or:
Functionality
The headlight assist system automatically switches
the high beam on and off.
Replace light bulbs
When the high beam is switched on, it adjusts the
light cone so that the drivers of oncoming and pre-
ceding vehicles are not dazzled.
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
WARNING
Risk of accident!
If necessary, manually switch the high beam on or
▶
off.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
Functional conditions
NOTICE
✓ The system is activated.
Danger of headlight damage due to the ingress of
water and dirt!
✓
The light switch is in the position
.
Always fit the protective cap on the headlight cor-
rectly after changing a bulb.
▶
✓ The driving speed is higher than 30 km/h (for
some countries, higher than 60 km/h).
✓ The low beam is switched on.
Conditions for changing a bulb
✓ Ignition switched off.
English 
