2010-2014 Subaru Outback SUV Keys and doors -> Immobilizer User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Keys and doors -> Immobilizer for Your Subaru Outback SUV Fourth Generation (2010-2014)

2-4 Keys and doors
Immobilizer
The immobilizer system is designed to
prevent an unauthorized person from
starting the engine. Only keys registered
with your vehicle’s immobilizer system can
be used to operate your vehicle.
For models with “keyless access with
push-button start system”:
If you press the push-button ignition
switch when carrying an unregistered
access key, the switch will not turn to the
“ON” position and the engine will not start.
For models without “keyless access
with push-button start system”:
Even if an unregistered key fits into the
ignition switch and can be turned to the
“START” position, the engine will auto-
matically stop after several seconds.
Each immobilizer key contains a trans-
ponder in which the key’s ID code is
stored . The transp onder transmit s the
key’s ID code to the immobilizer system’s
receiver under any of the following condi-
tions.
. When an access key is detected within
the operating range of the antennas inside
the vehicle (models with “keyless access
with push-button start system”)
. When a key is inserted into the ignition
switch and turned to the “ON” position
(models without “keyless access with
push-button start system”)
If the transmitted ID code matches the ID
code registered in the immobilizer system,
the system allows the engine to be
started. Since the ID code is transmitted
and acted upon almost instantly, the
immobilizer system does not impede
normal starting of the engine.
If the engine does not start, perform either
of the following procedures.
. Perform the procedure described in
“Sta rting engine” F9-21 (models w ith
“keyless access with push-button start
system”).
. Pull out the key once before trying
again (models without “keyless access
with push-button start system”). Refer to
“Ig nition switch (models witho ut push-
button start system)” F3-3.
CAUTION
. Do not place the key under direct
sunlight or anywhere it may
become hot.
. Do not get the key wet. If the key
gets wet, wipe it dry with a cloth
immediately.
NOTE
To protect yo ur vehicle from theft,
please pay close attention to the fol-
lowing security precautions:
. Never leave your vehicle unattended
with its keys inside.
. Before leaving your vehicle, close all
windows and the moonroof, and lock
the doors (all models) and rear gate
(Outback).
. Do not leave spare keys or any
record of your k ey number i n the
vehicle.
& Certification for immobilizer
system
For models with “keyless access with
push-button start system”:
Refer to “Certification for keyless access
with push-button start system” F2-10.
For models without “keyless access
with push-button start system”:
CAUTION
FCC WARNING
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user’s authority to operate the
equipment.
This device complies with Part 15 of
the FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the
following two conditions: (1) This de-
vice may not cause harmful interfer-
ence, and (2) this device must accept
any interference re ceived , including
interference that may cause undesired
operation.
& Security ID plate (models
without “keyless access with
push-button start system”)
1) Key number plate
2) Security ID plate
The security ID is stamped on the security
ID plate attached to the key set. Write
down the security ID and keep it in
another safe place, not in the vehicle.
This number is needed to make a replace-
ment key if you lose your key or lock it
inside the vehicle.
To make replacement keys, the key
number is also needed. Refer to “Key
replacement (m odels witho ut “keyless
access with push-button start system”)”
F2-5.
The security ID is also needed for
replacement or repair of the engine control
unit, integrated unit, etc. For details,
consult your SUBARU dealer.
& Security indicator light
Refer to “Security indicator light” F3-30.
& Key replacement (models
without “keyless access with
push-button start system”)
Your key number plate and security ID
plate will be required if you ever need a
replacement key made. Any new key must
be registered for use with your vehicle’s
immobilizer system before it can be used.
Up to four keys can be registered for use
with one vehicle.
For security, all the keys registered with
your vehicle’s immo bilizer system will
have their ID codes erased and r e-
registered when a new key is made.
Therefore, all of your vehicle’s keys must
be presented when a new key is regis-
tered. Any key that is not re-registered
when a new key is made cannot be used
after the other keys are re-registered. For
information on replacement keys and on
the registration of keys with your immo-
bi lizer system, contact your SUBARU
dealer.
Keys and doors 2-5

Related Topics

Popular Owner Manuals