2020-2025 Subaru Outback SUV Keys and Doors -> Unlocking the Doors (Remote Keyless Entry) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Keys and Doors -> Unlocking the Doors (Remote Keyless Entry) for Your Subaru Outback SUV Sixth Generation (2020-2025)

(138,1)
北米Model "A2620BE-A" EDITED: 2022/ 4/ 25
Transmitter
1) Lock/arm button
2) Unlock/disarm button
3) Trunk lid opener (Legacy)/Rear gate
unlock button (Outback/Subaru Outback
Wilderness)
4) PANIC button
The remote keyless entry system has the
following functions.
. Locking and unlocking the doors, rear
gate (Outback/Subaru Outback
Wilderness) and fuel filler lid
. Opening the trunk lid (Legacy)
. Sounding a panic alarm
. Arming and disarming the alarm sys-
tem. For details, refer to “Alarm System”
�P143.
The operable distance of the remote key-
less entry system is approximately 30 feet
(10 meters). However, this distance will
vary depending on environmental condi-
tions. The system’s operable distance will
be shorter in areas near a facility or
electronic equipment emitting strong radio
waves such as a power plant, broadcast
station, TV tower, or remote controller of
home electronic appliances.
NOTE
. For models with “keyless access
with push-button start system”, the
remote keyless entry system will not
be activated when the push-button
ignition switch is in any position other
than the “OFF” position.
. For models without “keyless access
with push-button start system”, the
remote keyless entry system will not
be activated when the key is inserted in
the ignition switch.
. The hazard warning flashers will
flash once or twice when the access
key fob/transmitter button is pressed in
the following cases.
– When locking the doors
– When unlocking the doors
– When unlocking the rear gate
If desired, you can turn the hazard
warning flashers off by operating the
center information display. For details,
refer to “Car settings” �P226. The
setting can also be changed by a
SUBARU dealer. Consult your SUBARU
dealer for details.
& Locking the Doors
s02ae01
Press the “ ” button to lock all doors, rear
gate (Outback/Subaru Outback
Wilderness) and fuel filler lid. An electronic
chirp will sound once and the hazard
warning flashers will flash once.
If any of the doors (or the rear gate) are not
fully closed, the following will occur to alert
you that the doors (or the rear gate) are not
properly closed.
. An electronic chirp sounds five times.
. The hazard warning flashers flash five
times.
When you close the door, it will automati-
cally lock and then the following will occur.
. An electronic chirp sounds once.
. The hazard warning flashers flash
once.
& Unlocking the Doors
s02ae02
Press the “ ” button to unlock the driver’s
door and fuel filler lid. An electronic chirp
will sound twice and the hazard warning
flashers will flash twice. To unlock all doors
and the rear gate, briefly press the “
”
button again within 5 seconds.
Remote Keyless Entry System
136
(139,1)
北米Model "A2620BE-A" EDITED: 2022/ 4/ 25
NOTE
If the interval between the first and
second presses of the “
” button (for
unlocking of all of the doors and the
rear gate) is extremely short, the sys-
tem may not respond.
& Opening the Trunk Lid
(Legacy)
s02ae13
Press and hold the “ ” button to open the
trunk lid. An electronic chirp will sound
twice and the hazard warning flashers will
flash twice.
This operation setting can be changed by a
SUBARU dealer. Consult your SUBARU
dealer for details.
& Unlocking the Rear Gate
(Outback/Subaru Outback
Wilderness)
s02ae03
Press the “ ” button to unlock the rear
gate. An electronic chirp will sound twice
and the hazard warning flashers will flash
twice.
This operation setting can be changed by a
SUBARU dealer. Consult your SUBARU
dealer for details.
& Setting Audible Signal Op-
eration
s02ae07
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock.
Models with “keyless access with
push-button start system”:
If desired, you can turn the audible signal
off by operating the center information
display. For details, refer to “Car settings”
�P226 (11.6-inch display models) or
“Vehicle setting icons” �P246 (dual 7.0-
inch display models). Furthermore, the
volume setting of the audible signal can
also be changed by a SUBARU dealer.
Consult your SUBARU dealer for details.
Models without “keyless access with
push-button start system”:
Perform the following steps to deactivate
the audible signal. Take the same steps to
restore the function.
Steps Operation Time
1 Sit in the driver’s seat. —
2
Close all doors and the
rear gate.
—
3
(1)
Press and hold “
” on
the power locking
switch.
Within
10 sec.
(2)
Insert the key into the
ignition switch and pull it
out at least 6 times.
4
Open and close the dri-
ver’s door.
Within
10 sec.
The hazard warning flashers flash 3 times
to indicate completion of the setting.
Your SUBARU dealer can perform the
above procedure for you.
– CONTINUED –
Remote Keyless Entry System
137
2
Keys and Doors

Related Topics

Popular Owner Manuals