2010-2016 Subaru XV SUV In case of emergency -> Flat tires User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

In case of emergency -> Flat tires for Your Subaru XV SUV First Generation (2010-2016)

9-6 In case of emergency/Flat tiresNOTEFlat sure that the jack is well lubri-cated before using it.1. Park on a hard, level surface, when-If you have a flat tire while driving, neverever possible, then stop the suddenly; keep driving straight2. Set the parking brake securely andahead while gradually reducing the shift lever in reverse (MT models)Then slowly pull off the road to a safeor the select lever to the “P” (Park) (CVT models).& Changing a flat tire3. Turn on the hazard warning flasherand have everyone get out of the . Do not jack up the vehicle on anincline or a loose road jack can come out of thejacking point or sink into theground and this can result in a6. Take out the tool bucket and turn thesevere bolt counterclockwise, then takethe spare tire out.. Use only the jack provided withyour vehicle. The jack suppliedNOTEwith the vehicle is designed onlyIf the spare tire provided in your vehiclefor changing a tire. Never getis a temporary spare tire, carefully readunder the vehicle while support-“Temporary spare tire” F9-2 anding the vehicle with this jack.4. Put wheel blocks at the front and rearstrictly follow the the tire diagonally opposite the flat tire.. Always turn off the engine before5. Take out the jack, jack handle andraising the flat tire off the groundwheel nut the jack. Never swing orpush the vehicle supported withThe tools and the spare tire are storedthe jack. The jack can come outunder the floor of the trunk (4-door) or theof the jacking point due to a joltcargo area (5-door). Refer to “Mainte-and this can result in a severenance tools” F9-3.
9-6 In case of emergency/Flat tires
NOTE
Flat tires
accident.
Make sure that the jack is well lubri-
cated before using it.
1. Park on a hard, level surface, when-
If you have a flat tire while driving, never
ever possible, then stop the engine.
brake suddenly; keep driving straight
2. Set the parking brake securely and
ahead while gradually reducing speed.
shift the shift lever in reverse (MT models)
Then slowly pull off the road to a safe
or the select lever to the “P” (Park)
place.
position (CVT models).
& Changing a flat tire
3. Turn on the hazard warning flasher
and have everyone get out of the vehicle.
WARNING
. Do not jack up the vehicle on an
incline or a loose road surface.
The jack can come out of the
jacking point or sink into the
ground and this can result in a
6. Take out the tool bucket and turn the
severe accident.
attaching bolt counterclockwise, then take
the spare tire out.
. Use only the jack provided with
your vehicle. The jack supplied
NOTE
with the vehicle is designed only
If the spare tire provided in your vehicle
for changing a tire. Never get
is a temporary spare tire, carefully read
under the vehicle while support-
“Temporary spare tire” F9-2 and
ing the vehicle with this jack.
4. Put wheel blocks at the front and rear
strictly follow the instructions.
of the tire diagonally opposite the flat tire.
. Always turn off the engine before
5. Take out the jack, jack handle and
raising the flat tire off the ground
wheel nut wrench.
using the jack. Never swing or
push the vehicle supported with
The tools and the spare tire are stored
the jack. The jack can come out
under the floor of the trunk (4-door) or the
of the jacking point due to a jolt
cargo area (5-door). Refer to “Mainte-
and this can result in a severe
nance tools” F9-3.
9-7In case of emergency/Flat tires8. Loosen the wheel nuts using the wheelTurn the jackscrew by hand until the jacknut wrench but do not remove the engages firmly into the jack-up point.1)Notch2)Valve holeJack-up points10. Insert the jack handle into the jack-7. If your vehicle has wheel covers, insertscrew, and turn the handle until the tire9. Place the jack under the side sill at thea flat-head screwdriver into the notch onclears the ground. Do not raise the vehiclefront or rear jack-up point closest to the flatthe opposite side of the valve hole and pryhigher than wheel cover to remove it.11. Remove the wheel nuts and the flattire.– CONTINUED –
9-7
In case of emergency/Flat tires
8. Loosen the wheel nuts using the wheel
Turn the jackscrew by hand until the jack
nut wrench but do not remove the nuts.
head engages firmly into the jack-up point.
1)
Notch
2)
Valve hole
Jack-up points
10. Insert the jack handle into the jack-
7. If your vehicle has wheel covers, insert
screw, and turn the handle until the tire
9. Place the jack under the side sill at the
a flat-head screwdriver into the notch on
clears the ground. Do not raise the vehicle
front or rear jack-up point closest to the flat
the opposite side of the valve hole and pry
higher than necessary.
tire.
the wheel cover to remove it.
11. Remove the wheel nuts and the flat
tire.
– CONTINUED –
9-8 In case of emergency/Flat tirestorque checked at the nearest automotiveWARNINGservice not use oil or grease on thewheel studs or nuts when the sparetire is installed. This could cause thenuts to become loose and lead to anaccident.14. Turn the jack handle counterclockwiseto lower the vehicle.1)Support holder16. Store the flat tire in the spare tirecompartment. Install with the supportholder facing upward and secure the flattire by firmly tightening the attaching you cannot fix the flat tire firmly, try15. Use the wheel nut wrench to securelyturning the support holder upsidetighten the wheel nuts to the , following the tightening order in the17. Store the jack, jack handle and wheel12. Before putting the spare tire on, wrench in their storage mounting surface of the wheel and hubFor the wheel nut tightening torque, referwith a “Tires” F12-8. Never use your foot on13. Put on the spare tire. Replace theWARNINGthe wheel nut wrench or a pipe extensionwheel nuts. Tighten them by the wrench because you may exceedNever place a tire or tire changingthe specified torque. Have the wheel nut
9-8 In case of emergency/Flat tires
torque checked at the nearest automotive
WARNING
service facility.
Do not use oil or grease on the
wheel studs or nuts when the spare
tire is installed. This could cause the
nuts to become loose and lead to an
accident.
14. Turn the jack handle counterclockwise
to lower the vehicle.
1)
Support holder
16. Store the flat tire in the spare tire
compartment. Install with the support
holder facing upward and secure the flat
tire by firmly tightening the attaching bolt.
NOTE
If you cannot fix the flat tire firmly, try
15. Use the wheel nut wrench to securely
turning the support holder upside
tighten the wheel nuts to the specified
down.
torque, following the tightening order in the
17. Store the jack, jack handle and wheel
12. Before putting the spare tire on, clean
illustration.
nut wrench in their storage locations.
the mounting surface of the wheel and hub
For the wheel nut tightening torque, refer
with a cloth.
to “Tires” F12-8. Never use your foot on
13. Put on the spare tire. Replace the
WARNING
the wheel nut wrench or a pipe extension
wheel nuts. Tighten them by hand.
on the wrench because you may exceed
Never place a tire or tire changing
the specified torque. Have the wheel nut
9-9In case of emergency/Flat tiresAlso, this system may not react immedi-tools in the passenger to a sudden drop in tire pressure (forafter changing wheels. In a sudden. When a spare tire is mounted or aexample, a blow-out caused running overstop or collision, loose equipmentwheel rim is replaced without thea sharp object).could strike occupants and causeoriginal pressure sensor/trans-injury. Store the tire and all tools inmitter being transferred, the lowWARNINGthe proper pressure warning light willilluminate steadily after blinking. If the low tire pressure warningfor approximately one minute.& Tire pressure monitoringlight illuminates while driving,This indicates the TPMS is un-system (TPMS) (U.S.- brake suddenly. Instead,able to monitor all four roadmodels)perform the following . Contact your SUBARU(1) Keep driving straight aheaddealer as soon as possible forwhile gradually reducingtire and sensor replacement and/ system resetting.(2) Slowly pull off the road to a. When a tire is repaired with liquidsafe place. Otherwise an acci-sealant, the tire pressure warningdent involving serious vehiclevalve and transmitter may notdamage and serious personaloperate properly. If a liquid sea-injury could is used, contact your nearest(3) Check the pressure for all fourSUBARU dealer or other qualifiedtires and adjust the pressureservice shop as soon as possi-to the COLD tire pressureble. Make sure to replace the tireshown on the vehicle placardpressure warning valve andon the door pillar on thetransmitter when replacing theLow tire pressure warning lightdriver’s . You may reuse the wheel ifThe tire pressure monitoring system pro-there is no damage to it and if theIf this light still illuminates whilevides the driver with the warning messagesealant residue is properlydriving after adjusting the tireindicated by sending a signal from acleaned , a tire may have signifi-sensor t
9-9
In case of emergency/Flat tires
Also, this system may not react immedi-
tools in the passenger compartment
possible.
ately to a sudden drop in tire pressure (for
after changing wheels. In a sudden
. When a spare tire is mounted or a
example, a blow-out caused running over
stop or collision, loose equipment
wheel rim is replaced without the
a sharp object).
could strike occupants and cause
original pressure sensor/trans-
injury. Store the tire and all tools in
mitter being transferred, the low
WARNING
the proper place.
tire pressure warning light will
illuminate steadily after blinking
. If the low tire pressure warning
for approximately one minute.
& Tire pressure monitoring
light illuminates while driving,
This indicates the TPMS is un-
system (TPMS) (U.S.-spec.
never brake suddenly. Instead,
able to monitor all four road
models)
perform the following procedure.
wheels. Contact your SUBARU
(1) Keep driving straight ahead
dealer as soon as possible for
while gradually reducing
tire and sensor replacement and/
speed.
or system resetting.
(2) Slowly pull off the road to a
. When a tire is repaired with liquid
safe place. Otherwise an acci-
sealant, the tire pressure warning
dent involving serious vehicle
valve and transmitter may not
damage and serious personal
operate properly. If a liquid sea-
injury could occur.
lant is used, contact your nearest
(3) Check the pressure for all four
SUBARU dealer or other qualified
tires and adjust the pressure
service shop as soon as possi-
to the COLD tire pressure
ble. Make sure to replace the tire
shown on the vehicle placard
pressure warning valve and
on the door pillar on the
transmitter when replacing the
Low tire pressure warning light
driver’s side.
tire. You may reuse the wheel if
The tire pressure monitoring system pro-
there is no damage to it and if the
If this light still illuminates while
vides the driver with the warning message
sealant residue is properly
driving after adjusting the tire
indicated by sending a signal from a
cleaned off.
pressure, a tire may have signifi-
sensor that is installed in each wheel
cant damage and a fast leak that
If the light illuminates steadily
when tire pressure is severely low.
causes the tire to lose air rapidly.
after blinking for approximately
The tire pressure monitoring system will
If you have a flat tire, replace it
one minute, promptly contact a
activate only when the vehicle is driven.
with a spare tire as soon as
SUBARU dealer to have the sys-
– CONTINUED –

Related Topics

Popular Owner Manuals