Get Before Driving -> Windshield wiper and washer lever Guide for Suzuki Ignis SUV Second Generation (2016-2024)

2-125

BEFORE DRIVING

75RM4-01E

Hazard warning switch

75RM324

Push in the hazard warning switch to acti-

vate the hazard warning lights. All turn sig-

nal lights and both turn signal indicators

will flash simultaneously. To turn off the

lights, push the switch again.

Use the hazard warning lights to warn

other drivers of possible risk of traffic haz-

ard when you park your vehicle in case of

emergency.

Windshield wiper and washer

lever

65D611

Wiper and washer operation

When the ignition switch is in “ON” position

or the ignition mode is ON, you can use

the wiper/washer lever or switch (if

equipped).

When the wipers are under heavy load

such as covered by snow, the breaker will

be activated and the wipers will stop oper-

ating to protect the wiper motor from over-

heating.

If the wiper stops during operation, do the

following methods.

1) Stop the vehicle in a safe place, and

turn the engine off.

2) Move the wiper lever and switch to

“OFF” position.

3) Remove obstacles such as snow on the

wipers.

4) After a while, when the temperature of

the wiper motor becomes low enough,

the breaker will be reset automatically

and the wipers will be able to use.

If you cannot use the wipers after a while,

there may be another problem. Ask your

SUZUKI dealer to have the wipers

inspected.

EXAMPLE

WARNING

To avoid possible injury, do not oper-

ate controls by reaching through the

steering wheel.

2-126

BEFORE DRIVING

75RM4-01E

Windshield wipers

68PM00237

To turn the windshield wipers on, move the

lever down to one of the three operating

positions. In “INT” position, the wipers

operate intermittently. The “INT” position is

very convenient for driving in mist or light

rain. In “LO” position, the wipers operate at

a steady low speed. In “HI” position, the

wipers operate at a steady high speed. To

turn off the wipers, move the lever back to

“OFF” position.

Move the lever up and hold it to “MIST”

position, the windshield wipers will turn on

continuously at low speed.

68PM00238

If the lever is equipped with “INT TIME”

control, turn the control forward or back-

ward to adjust the intermittent wiper opera-

tion to the desired interval.

Windshield washer

68PM00239

To spray windshield washer fluid, pull the

lever toward you. The windshield wipers

will automatically turn on at low speed if

they are not already on and your vehicle is

equipped with “INT” position.

EXAMPLE

WARNING

• To prevent windshield icing in cold

weather, turn on the defroster to

heat the windshield before and

during windshield washer use.

• Do not use radiator antifreeze in

the windshield washer reservoir. It

can severely impair visibility when

sprayed on the windshield, and can

also damage your vehicle’s paint.

EXAMPLE

2-127

BEFORE DRIVING

75RM4-01E

Rear window wiper/washer switch

68PM00240

To turn the rear wiper on, twist the rear

wiper switch on the end of the lever for-

ward to “ON” position. If your vehicle is

equipped with “INT” position, the rear

wiper operates intermittently when you

twist the switch forward to “INT” position.

To turn the rear wiper off, twist the switch

rearward to “OFF” position.

With the rear wiper in “OFF” position, twist

the switch rearward and hold it there to

spray window washer fluid.

With the rear wiper in “ON” position, turn

the switch forward and hold it there to

spray window washer fluid.

NOTICE

To help prevent damage to the wind-

shield wiper and washer system

components, you should take the fol-

lowing precautions:

• Do not continue to hold in the lever

when there is no windshield

washer fluid being sprayed or the

washer motor can be damaged.

• Do not attempt to remove dirt from

a dry windshield with the wipers or

you can damage the windshield

and the wiper blades. Always wet

the windshield with washer fluid

before operating the wipers.

• Clear ice or packed snow from the

wiper blades before using the wip-

ers.

• Check the washer fluid level regu-

larly. Check it often when the

weather is bad.

• Fill a reservoir 3/4 full with washer

fluid to for its expansion, if tem-

perature falls low enough to freeze

the fluid.

EXAMPLE

Intermittent wiper

Washer

Wiper

NOTICE

Clear ice or snow from the rear win-

dow and rear wiper blade before

using the rear wiper. Accumulated

ice or snow could prevent the wiper

blade from moving, causing damage

to the wiper motor.

Before Driving -> Windshield wiper and washer lever for Your Suzuki Ignis SUV Second Generation (2016-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals