Get BEFORE DRIVING -> Windshield wiper and washer lever Guide for Suzuki Swift 4 Door Fourth Generation (2023-2026)

BEFORE DRIVING

Lane change signal

EXAMPLE

Hazard warning switch

Windshield wiper and washer

lever

66RH036

Move the lever partially upward or down-

ward to turn right or left and hold the lever

in the moved position.

• The turn signal and its indicator flash

while the lever is held at the moved posi-

tion.

• The turn signal and its indicator flash 3

times even if you returned the lever

immediately after the activation.

EXAMPLE

57RK035

Push the hazard warning switch to activate

the hazard warning lights. All turn signal

lights and both turn signal indicators will

flash simultaneously. To turn off the lights,

push the switch again.

57L21128

WARNING

To avoid possible injury, do not oper-

ate controls by reaching through the

steering wheel.

Use the hazard warning lights to warn

other drivers of possible risk of traffic haz-

ard when you park your vehicle in case of

emergency.

NOTE:

The turn signal and its indicator can be set

whether they flash 3 times after the turn

signal lever is returned via the information

display. Refer to “Information display” in

this section.

NOTE:

You can customize the setting for the num-

ber of flashing times of the turn signal and

its indicator (1 to 4 times). Please ask an

authorized SUZUKI dealer for the customi-

zation.

2-92

BEFORE DRIVING

Wiper and washer operation

Windshield wipers

EXAMPLE

When the ignition switch is in “ON” position

or the ignition mode is ON, you can use

the wiper/washer lever.

When the wipers are under heavy load

such as covered by snow, the breaker will

be activated and the wipers will stop oper-

ating to protect the wiper motor from over-

heating. If the wiper stops during

operation, do the following methods.

MIST

OFF

INT

1) Stop the vehicle in a safe place, and

turn the engine off.

2) Move the wiper lever and switch to

“OFF” position.

57RK037

If the lever is equipped with “INT TIME”

control, turn the control knob forward or

backward to adjust the intermittent wiper

operation to the desired interval.

57RK036

3) Remove obstacles such as snow on the

wipers.

4) After a while, when the temperature of

the wiper motor becomes low enough,

the breaker will be reset automatically

and the wipers will be able to use.

To turn the windshield wipers on, move the

lever down to one of the three operating

positions. In “INT” position, the wipers

operate intermittently. The “INT” position is

very convenient for driving in mist or light

rain. In “LO” position, the wipers operate at

a steady low speed. In “HI” position, the

wipers operate at a steady high speed. To

turn off the wipers, move the lever back to

“OFF” position.

If you cannot use the wipers after a while,

there may be another problem. Ask an

authorized SUZUKI dealer to have the wip-

ers inspected.

Move the lever up and hold it to “MIST”

position, the windshield wipers will turn on

continuously at low speed.

2-93

BEFORE DRIVING

Windshield washer

EXAMPLE

Rear window wiper/washer switch

EXAMPLE

NOTICE

To help prevent damage to the wind-

shield wiper and washer system

components, you should take the fol-

lowing precautions:

• Do not continue to hold in the lever

when there is no windshield

washer fluid being sprayed or the

washer motor can be damaged.

• Do not attempt to remove dirt from

a dry windshield with the wipers or

you can damage the windshield

and the wiper blades. Always wet

the windshield with washer fluid

before operating the wipers.

• Clear ice or packed snow from the

wiper blades before using the wip-

ers.

• Check the washer fluid level regu-

larly. Check it often when the

weather is bad.

Washer

Wiper

Intermittent wiper

57RK038

To spray windshield washer fluid, pull the

lever toward you. The windshield wipers

will automatically turn on at low speed if

they are not already on and your vehicle is

equipped with “INT” position.

57RK039

To turn the rear wiper on, twist the rear

wiper switch on the end of the lever for-

ward to “ON” position. If your vehicle is

equipped with “INT” position (if equipped),

the rear wiper operates intermittently when

you twist the switch forward to “INT” posi-

tion. To turn the rear wiper off, twist the

switch rearward to “OFF” position.

WARNING

• Fill a reservoir to 3/4 level with

washer fluid for its expansion, if

temperature falls low enough to

freeze the fluid.

• To prevent windshield icing in cold

weather, turn on the defroster to

heat the windshield before and

during windshield washer use.

• Do not use radiator antifreeze in

the windshield washer reservoir. It

can severely impair visibility when

sprayed on the windshield, and can

also damage your vehicle’s paint.

With the rear wiper in “OFF” position, twist

the switch rearward and hold it there to

spray window washer fluid.

With the rear wiper in “ON” position, turn

the switch forward and hold it there to

spray window washer fluid.

2-94

BEFORE DRIVING -> Windshield wiper and washer lever for Your Suzuki Swift 4 Door Fourth Generation (2023-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals