Operation of each component -> Power back window for Your Toyota 4 Runner SUV Fifth Generation (2010-2024)

158  
3-5. Opening, closing the windows and moon roof  
Power back window  
The power back window can be opened and closed using the  
switch or key.  
Opening and closing procedures  
From inside the vehicle  
Closing  
1
2
3
4
One-touch closing*  
Opening  
One-touch opening*  
*: To stop the window partway, oper-  
ate the switch in the opposite direc-  
tion.  
From outside the vehicle  
Opening (push and hold)  
Closing (push and hold)  
1
2
This operation can only be per-  
formed when the electronic key is  
within the detection range.  
4RUNNER (U)  
159  
3-5. Opening, closing the windows and moon roof  
The power back window can be operated from inside the vehicle when  
The engine switch is in IGNITION ON mode.  
The power back window can be opened when the rear window wiper is  
working, but the wiper stops working until the window is closed again.  
If the power back window is not fully closed, the rear window wiper, washer,  
and defogger will not work.  
If the back door is not fully closed, the power back window cannot be  
opened using the switch located in the cabin. (It is still possible to close the  
window.)  
If the back door is opened while the power back window is opening or clos-  
ing, window operation will stop.  
The power back window can be operated from outside the vehicle when  
The engine switch is off.  
3
The back door is closed.  
Operating the power back window from inside the vehicle after turning  
the engine off  
The power back window can be operated for approximately 45 seconds even  
after the engine switch is turned to ACCESSORY mode or turned off. It can-  
not, however, be operated once either front door is opened.  
Jam protection function  
If an object becomes caught between the window and the window frame, win-  
dow travel is stopped and the window is opened slightly.  
When the power back window does not close normally  
If the jam protection function is operating abnormally and a window cannot be  
closed, perform the following operations using the power back window  
switch.  
After stopping the vehicle, the window can be closed by holding the power  
back window switch in the one-touch closing position while the engine  
switch is turned to IGNITION ON mode.  
If the window still cannot be closed even by carrying out the operation  
explained above, initialize the function by performing the following proce-  
dure.  
1
Hold the power back window switch in the one-touch closing position.  
Continue holding the switch for a further 6 seconds after the window has  
closed.  
2
Hold the power back window switch in the one-touch opening position.  
Continue holding the switch for a further 2 seconds after the window has  
opened completely.  
3
Hold the power back window switch in the one-touch closing position  
once again. Continue holding the switch for a further 2 seconds after the  
window has closed.  
4RUNNER (U)  
160  
3-5. Opening, closing the windows and moon roof  
If you release the switch while the window is moving, start again from the  
beginning.  
If the window continues to close but then re-open slightly even after perform-  
ing the above procedure correctly, have the vehicle inspected by your Toyota  
dealer.  
Customization  
Settings (e.g. linked operation) can be changed.  
(Customizable features P. 549)  
WARNING  
Observe the following precautions.  
Failure to do so may result in death or serious injury.  
Caution while driving  
Keep the back door and back window closed while driving. If the back door  
or the back window is left open, the back door may hit nearby objects while  
driving or luggage may be unexpectedly thrown out, causing an accident.  
In addition, exhaust gases may enter the vehicle, causing death or a seri-  
ous health hazard. Make sure to close the back door and back window  
before driving.  
Closing the power back window  
The driver is responsible for power back window opening and closing  
operations.  
In order to prevent accidental operation, especially by a child, do not let a  
child operate the power back window. It is possible for children and other  
passengers to have body parts caught in the power back window.  
Check to make sure that all passengers do not have any part of their body  
in a position where it could be caught when a window is being operated.  
When using the wireless remote control or key and operating the power  
back window, operate the power back window after checking to make sure  
that there is no possibility of any passenger having any of their body parts  
caught in the power back window. Also, do not let a child operate power  
back window by the wireless remote control or key. It is possible for chil-  
dren and other passengers to get caught in the power back window.  
When exiting the vehicle, turn the engine switch off, carry the key and exit  
the vehicle along with the child. There may be accidental operation, due to  
mischief, etc., that may possibly lead to an accident.  
Jam protection function  
Never use any part of your body to intentionally activate the jam protection  
function.  
The jam protection function may not work if something gets caught just  
before the window fully closes.  
4RUNNER (U)