Keys and doors -> Security system for Your Toyota Avensis 4 Door Second Generation (2004-2009)

Machine Translated by Google  
KEYS AND DOORS  
50  
Security system  
3. Secure the hood in the open position by inserting  
the support rod into the hole.  
To prevent vehicle theft, this system is designed to  
sound an alarm if any side door, trunk lid/tailgate,  
or hood is forcibly unlocked or opened, or the  
battery terminals are disconnected and then  
reconnected, or the cable is cut sirens or when  
someone breaks into the vehicle while the vehicle is  
locked.  
Before closing the hood, visually check that you have  
not forgotten any tools, rags, etc. in the engine  
compartment, and return the support rod to the holder -  
this will prevent rattling. Then lower the hood and make  
sure it is locked.  
If necessary, press down gently on its front edge to lock  
it in place.  
The alarm will sound the horn and siren intermittently,  
and the turn signals and front interior lighting will flash.  
WARNING  
After inserting the support bar into the hole, make  
sure that the bar sufficiently secures the hood  
against falling on your head or body.  
Machine Translated by Google  
KEYS AND DOORS  
51  
INTRUSION SENSOR CANCEL SWITCH  
SYSTEM SETUP  
The intrusion sensor can be disabled to prevent  
unwanted alarms from being triggered in the following  
circumstances:  
1. Turn the ignition key to the "LOCK" position and  
remove it.  
When the key is removed from the ignition switch, the  
indicator will flash. (Details - see "Engine Immobilizer  
System" on page 18 of this chapter.)  
A child or household member is left in the vehicle  
animal.  
Some window or skylight is left open.  
2. Let all passengers get out of the car  
eat.  
When parking in a noisy area or on a rooftop  
parking lot. The  
3. Close and lock all side doors, trunk lid/tailgate and  
hood with the wireless remote control.  
vehicle's bodywork or windows are hit by a strong  
impact from the outside (for example, during  
a high-pressure vehicle  
If all side doors, trunk lid/tailgate and hood are closed  
and locked, the warning light will remain on.  
wash). When the vehicle is transported on a car  
transport chassis.  
The system will automatically reset after 30 seconds.  
Canceling the intrusion sensor  
When the system is set, the indicator will start flashing  
again.  
1. Press the switch on the overhead console.  
The indicator on the instrument panel will flash rapidly  
for 5 minutes.  
4. After making sure that the indicator has started  
flashing, you can leave the vehicle.  
2. When the indicator is flashing, set the security  
system.  
The intrusion sensor is disabled while the system  
remains secure.  
Machine Translated by Google  
KEYS AND DOORS  
52  
If the alarm has been activated and the key is not in the  
WARNING  
ignition switch, all side doors and the trunk lid/tailgate  
will automatically lock again.  
Never activate the double locking system while  
there are people inside the vehicle, as none of the  
After 28 seconds, the alarm will stop automatically and  
the indicator will start flashing again.  
doors will be able to be opened from inside the  
vehicle. If you accidentally lock the door, press the  
"UNLOCK" button on the wireless remote control  
key.  
Alarm reactivation  
Once the system is set, the system will automatically  
set the alarm again after the alarm stops.  
Canceling the system  
The alarm is activated again under the same  
conditions described in "Activating the system".  
The system will cancel within 30 seconds before the  
system auto-sets under any of the following conditions:  
Stop the alarm  
Unlock any side door or trunk lid/tailgate with the wireless  
remote control key.  
Any side door, trunk lid/tailgate or hood is open.  
Any side door or trunk lid/  
If the battery is discharged due to long-term non-use of  
the vehicle, etc., when the battery is recharged or  
replaced, the system will trigger an alarm. If this happens,  
the back door is unlocked.  
The key is inserted into the ignition.  
The battery terminals are reconnected.  
immediately unlock any side door or trunk lid/tailgate  
with the wireless remote control key and the alarm will  
stop.  
WHEN THE SYSTEM IS SET UP  
System activation  
SYSTEM TEST  
The system sounds an alarm under the following  
conditions:  
1. Open all windows.  
2. Cancel the intrusion sensor using the procedure above.  
If any side door is unlocked or opened without  
a wireless remote control key, or if the trunk  
lid/tailgate or hood is forced open.  
3. Set up the system as described above. The side doors  
and trunk lid/tailgate should be locked with a wireless  
remote control key. Wait until the indicator turns off  
or starts flashing.  
If the battery terminals are disconnected and  
then reconnected.  
4. Unlock any side door from the inside.  
The system should activate an alarm.  
If the ignition is shorted.  
Someone or something is moving inside the vehicle  
5. Stop the alarm as described above.  
when the intrusion sensor function is on.  
6. Repeat this operation for other doors and hood.  
When testing the hood, also check that the system  
is activated when the battery terminal block is  
disconnected and then reconnected.  
When the system is activated, the indicator lights up.  
Machine Translated by Google  
KEYS AND DOORS  
53  
Fuel tank cap –  
If the system is not working properly, have it checked by  
any authorized Toyota dealer or workshop, or another  
properly qualified and equipped professional.  
INTRUSION SENSOR FUNCTION TEST  
1. Open all windows.  
2. Set up the system as described above. The side doors  
and trunk lid/tailgate should be locked with a wireless  
remote control key. Wait until the indicator turns off  
or starts flashing.  
This symbol indicates that the fuel tank door is  
located on the left side of your vehicle.  
3. Insert your hand through the open window, move it  
near the driver's seat and remove your hand. The  
system should activate an alarm.  
4. Stop the alarm as described above.  
If the system is not working properly, have it checked by  
any authorized Toyota dealer or workshop, or another  
properly qualified and equipped professional.