Driving -> Operating the lights and wipers for Your Toyota Avensis 4 Door Third Generation (2010-2018)

232  
4-3. Operating the lights and wipers  
Headlight switch  
The headlights can be operated manually or automatically.  
Operating instructions  
1
The front position, tail,  
license plate and instru-  
ment panel lights turn  
on.  
2
The headlights and all  
lights listed above turn  
on.  
3
The headlights and all  
(If equipped)  
lights listed above turn  
on and off automatically  
when the engine switch  
is in the “ON” position  
(vehicles without smart  
entry & start system) or  
IGNITION ON mode  
(vehicles with smart &  
start system).  
4
The daytime running lights turn on. (P. 237)  
233  
4-3. Operating the lights and wipers  
Turning on the high beam headlights  
1
With the headlights on, push  
the lever forward to turn on the  
high beams.  
Pull the lever back to the center  
position to turn the high beams off.  
2
Pull the lever toward you to turn  
on the high beams.  
Release the lever to turn them off.  
You can flash the high beams with  
the headlights on or off.  
4
234  
4-3. Operating the lights and wipers  
AFS (if equipped)  
AFS (Adaptive Front-lighting System) improves visibility at intersec-  
tions and on curves by automatically adjusting the lateral angle of the  
headlights according to vehicle speed and the degree of the tire angle  
that are controlled by steering input.  
Operates at speed of 10 km/h (6 mph) or higher.  
Deactivating AFS  
1
Select “AFS” on the settings  
display. (P. 112)  
2
Press  
on the steering  
wheel.  
235  
4-3. Operating the lights and wipers  
Manual headlight leveling dial (vehicles with halogen headlights)  
The level of the headlights can be adjusted according to the number  
of passengers and the loading condition of the vehicle.  
1
Raises the level of the head-  
lights  
2
Lowers the level of the head-  
lights  
Guide to dial settings  
Occupancy and luggage load conditions  
Dial position  
4
Occupants  
Luggage load  
Driver  
None  
0
0
Driver and front  
passenger  
None  
All seats occupied  
All seats occupied  
Driver  
None  
1
3
4
Full luggage loading  
Full luggage loading  
236  
4-3. Operating the lights and wipers  
Follow me home system (if equipped)  
This system allows the headlights to be turned on for 30 seconds  
when the engine switch is turned to the “LOCK” position (vehicles  
without a smart entry & start system) or off (vehicles with a smart  
entry & start system).  
After turning the engine switch to  
the “LOCK” position (vehicles  
without a smart entry & start sys-  
tem) or off (vehicles with a smart  
entry & start system), pull the  
lever toward you and release it  
when the light switch is in  
or  
.
Pull the lever toward you and release it again to turn off the lights.  
Cornering lights (if equipped)  
When any of the following conditions is met, while the headlights (low  
beam) are on, the cornering lights will additionally turn on and light up  
the direction of movement for the vehicle. This is to ensure excellent  
visibility when either driving at intersections or parking at night.  
The steering wheel is operated  
The turn signal lever is operated  
The shift lever is in R (both left and right side cornering lights)  
However, when vehicle speed is 35 km/h (21 mph) or above, the cor-  
nering lights do not turn on. When the cornering lights are on and  
vehicle speed exceeds 40 km/h (24 mph), they will be turned off.  
When the cornering lights are on for more than 30 minutes, they will  
automatically turn off.  
237  
4-3. Operating the lights and wipers  
Daytime running light system  
To make your vehicle more visible to other drivers during daytime driving, the  
daytime running lights turn on automatically whenever the engine is started  
and the parking brake is released with the headlight switch off or in the  
“AUTO” position. (Illuminate brighter than the front position lights.) Daytime  
running lights are not designed for use at night.  
Headlight control sensor (if equipped)  
The sensor may not function properly if  
anything that blocks the sensor is affixed  
to the windshield.  
Doing so interferes with the sensor  
detecting the level of ambient light and  
may cause the automatic headlight sys-  
tem to malfunction.  
4
238  
4-3. Operating the lights and wipers  
Automatic light off system  
X Vehicles without smart entry & start system  
When the light switch is in the “AUTO” position, the headlight and all the  
lights turn off automatically if the engine switch is turned to the “ACC” or  
“LOCK” position.  
When the light switch is in the  
position, the front fog lights turn off  
automatically if the engine switch is turned to the “ACC” or “LOCK” position.  
When the light switch is in the position, the headlights and front fog  
lights turn off automatically if the engine switch is turned to “ACC” or “LOCK”  
position.  
The front position and tail lights turn off automatically after 20 minutes.  
To turn the lights on again, turn the engine switch to the “ON” position, or turn  
the light switch to the  
position.  
position once and then back to the  
or  
X Vehicles with smart entry & start system  
When the light switch is in the “AUTO” position, the headlight and all the  
lights turn off automatically if the engine switch is turned to ACCESSORY  
mode or turned off.  
When the light switch is in the  
position, the front fog lights turn off  
automatically if the engine switch is turned to ACCESSORY mode or turned  
off.  
When the light switch is in the  
position, the headlights and front fog  
lights turn off automatically if the engine switch is turned to ACCESSORY  
mode or turned off.  
The front position and tail lights turn off automatically after 20 minutes.  
To turn the lights on again, turn the engine switch to IGNITION ON mode, or  
turn the light switch to the  
position once and then back to the  
or  
position.  
Light reminder buzzer  
X Vehicles without smart entry & start system  
A buzzer sounds when the engine switch is turned to the “LOCK” or “ACC”  
position and the driver’s door is opened while the lights are turned on.  
X Vehicles with smart entry & start system  
A buzzer sounds when the engine switch is turned off or to ACCESSORY  
mode and the driver’s door is opened while the lights are turned on.  
239  
4-3. Operating the lights and wipers  
Automatic headlight leveling system (vehicles with LED headlights)  
The level of the headlights is automatically adjusted according to the number  
of passengers and the loading condition of the vehicle to ensure that the  
headlights do not interfere with other road users.  
If the  
indicator flashes...  
It may indicate a malfunction in the system. Contact any authorized Toyota  
dealer or repairer, or another duly qualified and equipped professional.  
Customization  
Settings (e.g. light sensor sensitivity) can be changed.  
(Customizable features P. 632)  
NOTICE  
To prevent battery discharge  
Do not leave the lights on longer than necessary when the engine is not  
running.  
4
240  
4-3. Operating the lights and wipers  
Fog light switch  
The fog lights secure excellent visibility in difficult driving con-  
ditions, such as in rain or fog.  
X Front and rear fog light switch  
1
The front and rear fog  
lights turn off.  
2
The front fog lights turn on.  
3
Both front and rear fog  
lights turn on.  
Releasing the switch ring  
returns it to  
.
Operating the switch ring  
again turns only the rear fog  
light off.  
: If equipped  
241  
4-3. Operating the lights and wipers  
X Rear fog light switch  
1
Rear fog light turns off.  
Rear fog light turns on.  
Releasing the switch ring  
2
returns it to  
.
Operating the switch ring  
again turns the rear fog light  
off.  
4
Fog lights can be used when  
X Vehicles with a front and rear fog light switch  
Front fog lights: The headlights or front position lights are turned on.  
Rear fog light: The front fog lights are turned on.  
X Vehicles with a rear fog light switch  
The headlights or front position lights are turned on.  
242  
4-3. Operating the lights and wipers  
Windshield wipers and washer  
Operating the wiper lever  
The wiper operation is selected by moving the lever as follows.  
X Intermittent windshield wipers  
1
Intermittent operation  
2
Low speed operation  
3
High speed operation  
4
Temporary operation  
5
Increases the intermittent wiper  
frequency  
6
Decreases the intermittent  
wiper frequency  
243  
4-3. Operating the lights and wipers  
7
Washer/wiper dual operation  
Wipers operate automatically.  
If the headlights are on, the  
headlight cleaners will operate  
once. And then, the headlight  
cleaners will operate every five  
times you pull the lever. (if  
equipped)  
X Rain-sensing windshield wipers  
With “AUTO” selected, the wipers will operate automatically when the  
sensor detects falling rain. The system automatically adjusts wiper  
timing in accordance with rain volume.  
1
Rain-sensing wiper operation  
Low speed wiper operation  
High speed wiper operation  
Temporary operation  
2
3
4
4
5
6
Sensor sensitivity (high)  
Sensor sensitivity (low)  
244  
4-3. Operating the lights and wipers  
7
Washer/wiper dual operation  
Wipers operate automatically.  
If the headlights are on, the  
headlight cleaners will operate  
once. And then, the headlight  
cleaners will operate every five  
times you pull the lever. (if  
equipped)  
The windshield wiper and washer can be operated when  
The engine switch is in the “ON” position (vehicles without smart entry & start  
system) or IGNITION ON mode (vehicles with smart entry & start system).  
Rain drop sensor (vehicles with rain-sensing windshield wipers)  
The raindrop sensor judges the amount of  
raindrops.  
If the wiper switch is turned to the “AUTO” position while the engine switch is  
in the “ON” position (vehicles without smart entry & start system) or IGNI-  
TION ON mode (vehicles with smart entry & start system), the wiper will oper-  
ate once to show that “AUTO” mode is activated.  
If the wiper sensitivity is adjusted to higher, the wiper may operate once to  
indicate the change of sensitivity.  
If no windshield washer fluid sprays  
Check that the washer nozzles are not blocked and if there is washer fluid in  
the windshield washer fluid reservoir.  
245  
4-3. Operating the lights and wipers  
Windshield wiper features  
The rear window and outside rear view mirror defoggers automatically turn on  
when you operate the wipers.  
WARNING  
Caution regarding the use of windshield wipers in “AUTO” mode  
The windshield wipers may operate unexpectedly if the sensor is touched or  
the windshield is subject to vibration in “AUTO” mode. Take care that your  
fingers or anything else do not become caught in the windshield wipers.  
Caution regarding the use of washer fluid  
When it is cold, do not use the washer fluid until the windshield becomes  
warm. The fluid may freeze on the windshield and cause low visibility. This  
may lead to an accident, resulting in death or serious injury.  
NOTICE  
4
When the windshield is dry  
Do not use the wipers, as they may damage the windshield.  
When there is no washer fluid spray from the nozzle  
Damage to the washer fluid pump may be caused if the lever is pulled  
toward you and held continually.  
When a nozzle becomes blocked  
In this case, contact any authorized Toyota dealer or repairer, or another  
duly qualified and equipped professional.  
Do not try to clean it with a pin or other object. The nozzle will be damaged.  
246  
4-3. Operating the lights and wipers  
Rear window wiper and washer  
Operating the wiper lever  
Turning the end of the lever turns on the rear window wiper and  
washer.  
1
Intermittent operation  
Normal operation  
2
3
Washer/wiper dual opera-  
tion  
4
Washer/wiper dual opera-  
tion  
The rear window wiper and washer can be operated  
When the engine switch is in the “ON” position (vehicles without smart entry &  
start system) or IGNITION ON mode (vehicles with smart entry & start sys-  
tem).  
NOTICE  
When the rear window is dry  
Do not use the wipers, as they may damage the rear window.  
When the washer fluid tank is empty  
Do not operate the switch continually as the washer fluid pump may over-  
heat.  
: If equipped